Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 6 — A cuboid has six faces in total: a top, a bottom, a front, a back, and two ends — each one is a rectangle in the net, giving six rectangles altogether. Choosing 3 counts only the three PAIRS of congruent rectangles (top/bottom, front/back, two ends) rather than all six individual faces. Choosing 5 forgets one face, as if the net were missing its lid. Choosing 12 is the number of edges of a cuboid, not the number of rectangles in its net.
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (d) 706.5 cm² — Area of a circle = πr². With r = 15 cm and π = 3.14, area = 3.14 × 15² = 3.14 × 225 = 706.5 cm². A student who uses the circumference formula 2πr instead of the area formula gets 2 × 3.14 × 15 = 94.2 cm². A student who uses πr instead, forgetting to double, gets 3.14 × 15 = 47.1 cm². A student who squares the diameter (30 cm) instead of the radius gets 3.14 × 900 = 2826.0 cm².
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (a) 89.6° — Angle PQR is at vertex Q, so the side opposite it is PR = 13 cm. Using the cosine rule rearranged for an angle: cos(PQR) = (121 + 49 − 169) ÷ (2 × 11 × 7) = 1 ÷ 154 = 0.0065. Taking the inverse cosine, angle PQR = 89.6° (1 d.p.). Using PR as one of the enclosing sides instead of as the opposite side, finding angle P instead of angle Q, gives (121 + 169 − 49) ÷ (2 × 11 × 13) = 241 ÷ 286 = 0.8427, and angle = 32.6°. Swapping the sign inside the bracket, computing 169 − 121 − 49 instead, gives −1 ÷ 154 = −0.0065, and angle = 90.4°. Using PR in the denominator instead of QR gives (121 + 49 − 169) ÷ (2 × 11 × 13) = 1 ÷ 286 = 0.0035, and angle = 89.8°. Keep PR as the opposite side, QR and PQ as the enclosing sides, and angle PQR comes to 89.6°.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (d) 63.6 — Method: the three angles inside the triangle formed by the two ladders and the ground add up to 180°. Working: 180 − 58.2 − 58.2 = 63.6. Answer: 63.6°. A candidate who assumes the top angle equals the base angles gives 58.2. A candidate who subtracts only one base angle from 180°, working out 180 − 58.2, gets 121.8. A candidate who doubles the base angle instead of subtracting it twice from 180°, working out 2 × 58.2, gets 116.4.
- (a) 69.3 m — Method: each observer gives a right-angled triangle with the mast as the opposite side, so tan θ = 60 ÷ distance and the distance from the foot of the mast is 60 ÷ tan θ; because both stand on the same side, the gap between them is the difference of those two distances. Working: from Amelia, 60 ÷ tan 30° = 103.92… m; from Noah, 60 ÷ tan 60° = 34.64… m; the gap is 103.92… − 34.64… = 69.28… m, which is 69.3 m to 1 decimal place. Answer: 69.3 m. The distractors: 103.9 m is Amelia's own distance from the foot of the mast, written down before the second distance has been taken away; 34.6 m is Noah's distance from the foot of the mast; 138.6 m comes from adding the two distances, which would be right only if the two observers stood on opposite sides of the mast.
- (a) 59.0° — Method: rearrange Area = (1/2)ab sin C to make sin C the subject: sin C = 2 × Area ÷ (a × b). Working: sin C = 2 × 24 ÷ (8 × 7) = 0.857, so C = sin⁻¹(0.857) = 59.0° (1 d.p.), which is acute as the question requires. Answer: 59.0°. Taking the obtuse angle instead of the acute one asked for, 180 − 59.0 = 121.0°; forgetting to double the area before dividing gives sin C = 24 ÷ (8 × 7) = 0.4286, whose acute angle is 25.4°; and combining that same forgotten-doubling error with the obtuse branch gives 180 − 25.4 = 154.6°. Always double the area first, and then pick the acute branch, since that is what this question asks for.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (c) 8 cm — Area of a trapezium = (sum of parallel sides) ÷ 2 × height, so 45 = (a + 10) ÷ 2 × 5. Dividing 45 by 5 gives 9, so (a + 10) ÷ 2 = 9, meaning a + 10 = 18, so a = 18 − 10 = 8 cm. A pupil who correctly finds that the two parallel sides add up to 18 but forgets to subtract the known side of 10 cm gives the sum of both parallel sides, 18 cm, as the answer. A pupil who then adds 10 again by mistake instead of subtracting gets 18 + 10 = 28 cm. A pupil who halves the correct answer by mistake gets 8 ÷ 2 = 4 cm. The correct length of the other parallel side is 8 cm.
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
Build your own mix at the worksheet builder.