Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 60° — Method: the 4 cm side is next to the angle wanted and the 8 cm side is the hypotenuse, so the ratio built from them is cos θ = adjacent ÷ hypotenuse, and the angle comes from the inverse cosine. Working: cos θ = 4 ÷ 8 = 0.5, so θ = cos⁻¹(0.5). Answer: 60°. The distractors: 30° comes from using sin⁻¹(0.5), which treats the 4 cm side as the side opposite the angle when it is the side next to it; 45° comes from assuming the two acute angles of the triangle must be equal; 90° comes from writing down the right angle the question already gives instead of the angle it asks for.
- (c) 9.9 cm — Method: the 7 cm side is opposite the 45° angle and the hypotenuse is wanted, so use sin θ = opposite ÷ hypotenuse and rearrange it for the hypotenuse. Working: sin 45° = 7 ÷ h, so h = 7 ÷ sin 45° = 9.899…, which is 9.9 to 1 decimal place. Answer: 9.9 cm. The distractors: 5.0 cm comes from multiplying by sin 45° instead of dividing by it; 14.0 cm comes from doubling the 7 cm side, which is the rule for a side opposite 30° and not one opposite 45°; 7.0 cm comes from reading the two equal sides of a 45° right-angled triangle as including the hypotenuse, when the equal pair is the two shorter sides.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
- (d) 452.16 cm² — Area = πr². Substitute r = 12: area = 3.14 × 12² = 3.14 × 144 = 452.16 cm².
- (a) 21.8° — The base diagonal has length √(6² + 8²) = √(36 + 64) = √100 = 10 cm, using Pythagoras' theorem on the rectangular base. The angle between the space diagonal and the base lies in the right-angled triangle formed by the height (4 cm, opposite), the base diagonal (10 cm, adjacent) and the space diagonal (hypotenuse), so tan(angle) = 4 ÷ 10 = 0.4, giving angle = 21.8° (1 d.p.). Using the height and one base edge instead of the full base diagonal, tan(angle) = 4 ÷ 8 = 0.5, gives 26.6° instead. Inverting the ratio, tan(angle) = 10 ÷ 4 = 2.5, gives 68.2°, the complement of the angle rather than the angle itself. Using the height and the other base edge, tan(angle) = 4 ÷ 6, gives 33.7°.
- (a) 59.0° — Method: rearrange Area = (1/2)ab sin C to make sin C the subject: sin C = 2 × Area ÷ (a × b). Working: sin C = 2 × 24 ÷ (8 × 7) = 0.857, so C = sin⁻¹(0.857) = 59.0° (1 d.p.), which is acute as the question requires. Answer: 59.0°. Taking the obtuse angle instead of the acute one asked for, 180 − 59.0 = 121.0°; forgetting to double the area before dividing gives sin C = 24 ÷ (8 × 7) = 0.4286, whose acute angle is 25.4°; and combining that same forgotten-doubling error with the obtuse branch gives 180 − 25.4 = 154.6°. Always double the area first, and then pick the acute branch, since that is what this question asks for.
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (c) 64.4 cm² — Method: with two sides and the angle between them, use Area = (1/2)ab sin C. Working: Area = 1/2 × 15.6 × 8.9 × sin 112° = 64.4 cm² (1 d.p.). Answer: 64.4 cm². Leaving out the 1/2 gives 128.7 cm²; using cos 112° instead of sin 112° gives a negative value, which a candidate who drops the minus sign reads as 26.0 cm²; and squaring one side instead of multiplying the two different given sides together gives 112.8 cm². Sin C is never negative for an angle between 0° and 180°, so a negative area is always a sign that cos was used by mistake — check you used sin before you trust your answer.
- (b) 21.5 km — Method: find angle ABC from the two bearings, then use the cosine rule. Working: the bearing of A from B is 038° + 180° = 218°, so angle ABC = 218° − 142° = 76°. Then AC² = 14² + 20² − 2 × 14 × 20 × cos 76°, so AC = 21.5 km. Leaving out the factor of 2 in the cosine rule gives AC = 23.0 km; using 142° − 38° = 104° as the angle instead of the correct 76° gives AC = 27.0 km; and simply adding the two distances as if the path were a straight line gives 34.0 km. The angle between the two legs must come from the bearings, not from subtracting them directly.
- (b) 43.8 km — Method: find the angle of the triangle at Q from the two bearings, then use the cosine rule on the two known sides and that included angle. Working: the bearing of P from Q is the back bearing of 040°, which is 040° + 180° = 220°, and the bearing of R from Q is 115°, so angle PQR = 220° − 115° = 105°. Then PR² = 24² + 31² − 2 × 24 × 31 × cos 105° = 576 + 961 − 1488 × (−0.25882) = 1537 + 385.12 = 1922.12, and the square root of 1922.12 is 43.842. Answer: PR = 43.8 km to 1 decimal place. The distractors: 33.9 km comes from subtracting the bearings, 115° − 040° = 75°, and using 75° as the angle at Q, which is the angle the ship turns through, not the angle inside the triangle; 19.9 km comes from using the first bearing itself, 040°, as the angle at Q; 55.0 km comes from adding the two legs, 24 + 31, which would be the distance only if the ship had sailed in a straight line.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (a) 17 cm — Convert the real distance to centimetres first: 3.4 km = 340 000 cm. Then divide by the scale factor, 20 000, since the map is 20 000 times smaller than real life: 340 000 ÷ 20 000 = 17, so the map distance is 17 cm. Choosing 1700 cm divides by 200 instead of 20 000, losing two zeros from the scale factor (340 000 ÷ 200 = 1700). Choosing 170 cm divides by 2 000 instead of 20 000, losing one zero from the scale factor (340 000 ÷ 2 000 = 170). Choosing 0.17 cm divides by 2 000 000 instead of 20 000, adding two extra zeros to the scale factor (340 000 ÷ 2 000 000 = 0.17).
Build your own mix at the worksheet builder.