Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (d) £100.48 — Area of the rug = (angle ÷ 360) × π × r² = (180 ÷ 360) × 3.14 × 16 = 0.5 × 50.24 = 25.12 m². Cost = 25.12 × £4 = £100.48. (£200.96 comes from finding the area of a full circle, 3.14 × 16 = 50.24 m², and forgetting the angle fraction before costing it; £25.12 comes from forgetting to square the radius, using 0.5 × 3.14 × 4 = 6.28 m², and then costing that; £50.24 comes from using the arc length formula, 0.5 × 2 × 3.14 × 4 = 12.56, in place of the area, and costing that.)
- (c) (10.5, −2) — Method: the vector from the first tile to the third tile is the pattern's vector doubled, since two translations happen between them. Working: doubling (4.5, −2.5) gives (9, −5); adding this to the starting corner (1.5, 3) gives x-coordinate 1.5 + 9 = 10.5 and y-coordinate 3 − 5 = −2. Answer: (10.5, −2). A candidate who only applies the vector once, translating to the second tile instead of the third, gets (6, 0.5). A candidate who adds 2.5 instead of subtracting it in the y-coordinate gets (10.5, 8). A candidate who doubles the x-part of the vector correctly but forgets to change the y-coordinate at all gets (10.5, 3).
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (b) 21 — Both legs of the journey are on the same bearing, 070°, so the ship travels in one straight line the whole way and the distances simply add: 12 + 9 = 21 km. A candidate who subtracts instead of adding gets 12 − 9 = 3 km. A candidate who multiplies the two distances gets 12 × 9 = 108. A candidate who assumes the ship changed direction and treats the two legs as the sides of a right-angled triangle works out √(12² + 9²) = √225 = 15 km — but the bearing does not change, so there is no triangle and no hypotenuse to find. Because the ship stays on one straight line, the total distance is 21 km.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (b) Statement 3 — a triangle's angles are said to sum to 360° — The angles of any triangle sum to 180°, not 360° — Statement 3 uses the wrong total, and that error is what sends its final line to the impossible claim that angle ACB = 180°. The correct working is angle OAC + angle OBC + angle ACB = 180°, and since angle ACB = angle OCA + angle OCB, this gives 2 × angle ACB = 180°, so angle ACB = 90°, which is the actual theorem. Statement 1 correctly identifies OA and OC as equal radii, making triangle OAC isosceles — nothing wrong there. Statement 2 correctly does the same for triangle OBC. Statement 4 correctly states that A, O and B are collinear, since a diameter passes through the centre — also nothing wrong there. Statement 3 is the one to flag: it is the angle sum it quotes that is wrong, not the diagram or the radii.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
- (c) ABC ≅ XYZ — Method: match each vertex in ABC to its corresponding vertex in XYZ, using the equal sides and angles given, then write the letters in that matching order. Working: AB matches XY, BC matches YZ, and angle B matches angle Y, so A corresponds to X, B corresponds to Y, and C corresponds to Z, giving ABC ≅ XYZ. Options: 'ABC ≅ ZYX' puts Z in A's position, but A corresponds to X, not Z; 'ABC ≅ YXZ' puts Y in A's position, but A corresponds to X; 'ABC ≅ ZXY' puts Z in A's position and X in B's position, neither of which is correct. Answer: ABC ≅ XYZ.
Build your own mix at the worksheet builder.