Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 360 cm² — Method: the total surface area is the square base plus the four triangular faces, and the height used for a triangular face is the slant height of 13 cm, not the vertical height of 12 cm. Working: the base is 10 × 10 = 100 cm²; one triangular face is (10 × 13) ÷ 2 = 65 cm², so four faces give 4 × 65 = 260 cm²; the total is 100 + 260 = 360. Answer: 360 cm². The distractors: 260 cm² comes from adding the four triangular faces and leaving out the base; 340 cm² comes from using the vertical height of 12 cm as the height of each triangle, 100 + 4 × 60; 620 cm² comes from working out each face as 10 × 13 without halving, 100 + 4 × 130.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (a) −2 — Let the centre be C = (c, 0). The vector from the centre to the image equals the scale factor k times the vector from the centre to the object: (7 − c, −4) = k(1 − c, 2). The y-coordinate gives −4 = 2k, so k = −2 — this doesn't depend on knowing c. (Checking: substituting k = −2 into the x-equation gives c = 3, consistent with a centre on the x-axis.) '2' comes from taking the magnitude of the ratio without noticing the image is on the opposite side of the centre from the object, so the sign should be negative. '−1/2' comes from inverting the scale factor, dividing the object's coordinate by the image's instead of the other way round. '3' is the x-coordinate of the centre, mistaken for the scale factor.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (a) (8, 2) — Method: translating a point by a column vector means adding the vector's top number to the x-coordinate and its bottom number to the y-coordinate. Working: x-coordinate 2 + 6 = 8; y-coordinate 5 + (−3) = 2. Answer: B = (8, 2). A candidate who ignores the negative sign and adds 3 instead of −3 gets (8, 8). A candidate who translates in the reverse direction, subtracting the vector from A instead of adding it, gets (−4, 8). A candidate who swaps the vector's top and bottom numbers before adding gets (−1, 11).
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
- (d) 6 cm — Method: CH cuts the triangle into two smaller right-angled triangles, so Pythagoras' theorem can be written in each of the three right-angled triangles and the results combined. Working: HB = 12 − 3 = 9 cm. In triangle ACH, CH² = AC² − 3² = AC² − 9; in triangle CHB, CH² = CB² − 9² = CB² − 81. Setting those equal gives AC² − 9 = CB² − 81. In triangle ABC, AC² + CB² = 12² = 144, so CB² = 144 − AC². Substituting gives AC² − 9 = 144 − AC² − 81, so 2 × AC² = 72 and AC² = 36, giving AC = 6. Answer: 6 cm. The distractors: 36 cm comes from stopping at AC² = 36 and never taking the square root; 9 cm is HB, the other part of the hypotenuse, written down in place of AC; 4 cm comes from working out 12 ÷ 3, treating AH as a scale factor between the two triangles rather than as a length.
- (c) 10 cm — The diagonals of a rhombus bisect each other at right angles, splitting it into four congruent right-angled triangles with legs 8 cm (half of 16 cm) and 6 cm (half of 12 cm). By Pythagoras' Theorem, side² = 8² + 6² = 64 + 36 = 100. Square root: √100 = 10 cm.
- (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (b) −2 — The gradient of the original line is (6 − 2) ÷ (3 − 1) = 4 ÷ 2 = 2. Reflecting in the x-axis sends every y-coordinate to its negative, which flips the sign of the gradient: the image line has gradient −2. Translating by (2, 0) is a horizontal shift, which does not change the line's steepness or direction at all, so the gradient stays at −2. Assuming the gradient is unaffected by the reflection gives 2, the original gradient carried straight through. Thinking a reflection in the x-axis turns a gradient into its positive reciprocal gives 1/2. Combining that same wrong idea with the sign flip from the reflection gives −1/2. Only the sign flips, from the reflection, and translating never changes a gradient at all, so the answer is −2.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
Build your own mix at the worksheet builder.