Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (c) (1, 0) — To enlarge about a centre other than the origin, find the vector from the centre to the point, scale that vector, then add it back to the centre. The vector from (2, 2) to A(4, 6) is (2, 4). Scaling by −1/2 gives (−1, −2). Adding this to the centre (2, 2) gives the image point (1, 0). (3, 4) comes from using +1/2 instead of −1/2, so the image lands on the same side as A instead of the opposite side. (−2, −3) comes from scaling A's coordinates directly about the origin, ignoring that the centre is (2, 2). (−2, −6) comes from using a scale factor of −2 instead of −1/2.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (b) 68° — Method: two properties are needed. Angle A and angle D are co-interior angles between the parallel sides AB and DC, so they add up to 180°; and because the trapezium is isosceles, the two angles on the side AB are equal, so angle B = angle A. Working: angle A = 180° − 112° = 68°, and angle B = angle A = 68°. Answer: 68°. The distractors: 112° comes from assuming that angles B and D are equal, which is the property of a parallelogram, not of a trapezium; 90° comes from assuming that the angles on the other parallel side must be right angles; 248° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given.
- (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (d) 2 — Method: if f is 3 times e, then each part of f equals 3 times the matching part of e. Working: using the bottom numbers, 6 = 3 × k, so k = 2. Answer: k = 2. A candidate who multiplies instead of dividing, working out 6 × 3, gets 18. A candidate who uses the top numbers' ratio instead, 15 ÷ 5, and gives that ratio as k gets 3. A candidate who adds instead of using the multiple relationship, working out 6 + 3, gets 9.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (a) (9, −5) — Method: multiply every part of q by 2, then subtract the matching part from p. Working: 2q = (−4, 6); p − 2q gives top 5 − (−4) = 9 and bottom 1 − 6 = −5. Answer: p − 2q = (9, −5). A candidate who forgets to double q first, working out p − q instead, gets (7, −2). A candidate who doubles p instead of q, working out 2p − q, gets (12, −1). A candidate who adds 2q instead of subtracting it gets (1, 7).
- (c) Square — Because the cut is parallel to the square base, it produces a shape that is similar to the base — the same shape, scaled down — so it is also a square, with four equal sides, smaller than the base. A candidate who looks at the sloped triangular faces instead of at the horizontal cut answers triangle. A candidate who pictures a slanted cut, which would shorten one pair of sides, answers trapezium, but a cut parallel to the base scales all four sides by the same amount. A candidate who counts an extra side, perhaps including an edge of the base, answers pentagon. The cross-section is a square.
- (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
Build your own mix at the worksheet builder.