Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 12 cm — By Pythagoras' Theorem, QR² = PQ² + PR², so PR² = QR² − PQ² = 15² − 9² = 225 − 81 = 144. Square root: √144 = 12 cm.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (b) (3, −1) — Method: find the distance from the point to the mirror line, then place the image the same distance on the other side of the line. Working: B is 5 − 2 = 3 units above the line y = 2, so its image is 3 units below the line, at y = 2 − 3 = −1, giving (3, −1); the x-coordinate does not change, since the mirror line is horizontal. Options: (3, −5) comes from reflecting in the x-axis (y = 0) instead of the line y = 2; (−3, 5) comes from reflecting in the y-axis instead of a horizontal line; (3, −4) comes from doubling the distance from the line instead of reflecting it, giving 2 − 2×3 = −4. Answer: (3, −1).
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (c) 9 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 12 ÷ 8 = 1.5. So PR = AC × 1.5 = 6 × 1.5 = 9 cm. (4 cm comes from using the scale factor upside down, AB ÷ PQ; 10 cm comes from adding the difference between AB and PQ, 4 cm, to AC instead of scaling; 16 cm comes from multiplying PQ by the ratio AB : AC instead of scaling AC by the correct scale factor.)
- (c) AB means the segment or its length, shown by context — Method: recall the standard convention for a two-letter label such as AB. Working: AB names the segment AND its length; the sentence around it shows which is meant — 'draw AB' means the segment, 'AB = 5 cm' means the length. Options: 'a different symbol is needed' and 'must be written as |AB|' both describe stricter rules than the convention GCSE actually uses; 'AB can only mean the segment' ignores that the same label is also used for the length. Answer: AB means the segment or its length, shown by context.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (c) Two angles and one side are known; x is another side — The sine rule needs a matching pair, a side and the angle opposite it, that you already know, so you can set up a ratio with the unknown. When two angles and one side are known, you can find the third angle from the angle sum, giving you an angle opposite the known side and an angle opposite x: the sine rule applies directly. When all three sides are known and x is an angle, there is no side-angle pair available at all, so the cosine rule, rearranged for an angle, is what's needed instead. When two sides and the included angle are known and x is the third side, again there is no matching side-angle pair yet, so the cosine rule finds the third side directly. When two sides and the included angle are known and x is one of the other angles, you still have no side-angle pair to start from — the cosine rule has to be used first, to find the third side, before any angle can be found. Only the two-angles-and-a-side case hands you a ready-made pair, which is exactly what the sine rule needs.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (d) RHS, using AM as common side — Triangle ABM and triangle ACM both have a right angle at M, since AM is perpendicular to BC. AB and AC are the hypotenuses of the two triangles and are equal, and AM is a side common to both triangles, giving a right angle, equal hypotenuses and one further equal side, exactly RHS, so 'RHS, using AM as common side' is correct. 'SAS, right angle as included angle' wrongly treats the right angle at M as included between AB and AM, but AB is the hypotenuse, not one of the two sides forming that right angle. 'SSS, using BM = CM as a fact' wrongly assumes BM equals CM as a given fact, when this is only true because of the RHS congruence, not before it, so it cannot be used to prove that congruence. 'ASA, AB as the included side' again wrongly labels a side as if it could sit between two angles when only one angle, the right angle, is actually known.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (d) £50 — Area = 1/2 × (3.5 + 6.5) × 4 = 1/2 × 10 × 4 = 20 m². Cost = 20 × £2.50 = £50. (£100 comes from forgetting to halve the trapezium area, giving 40 m² instead of 20 m²; £65 comes from using only the longer parallel side, 6.5 × 4 = 26 m², instead of the trapezium formula; £35 comes from adding all three given lengths, 3.5 + 6.5 + 4, and treating that total as the area in square metres.)
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
Build your own mix at the worksheet builder.