Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 6 m — The horizontal distance is adjacent to the 60° angle and the zip-wire is the hypotenuse, so horizontal distance = 12 × cos 60° = 12 × 1/2 = 6 m. 6√3 m comes from using sin 60° = √3/2 instead of cos 60°, which would give the vertical drop, not the horizontal distance. 4√3 m comes from treating 12 as the side adjacent to a tangent ratio and dividing by tan 60° = √3. 24 m comes from dividing 12 by cos 60° instead of multiplying by it.
- (a) (9, −5) — Method: multiply every part of q by 2, then subtract the matching part from p. Working: 2q = (−4, 6); p − 2q gives top 5 − (−4) = 9 and bottom 1 − 6 = −5. Answer: p − 2q = (9, −5). A candidate who forgets to double q first, working out p − q instead, gets (7, −2). A candidate who doubles p instead of q, working out 2p − q, gets (12, −1). A candidate who adds 2q instead of subtracting it gets (1, 7).
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (d) (−4, −3) — The combined translation is the sum of the two column vectors, added component by component: top numbers 3 + (−7) = −4, bottom numbers −5 + 2 = −3, giving (−4, −3). (10, −7) subtracts the second vector from the first instead of adding them. (−4, 3) gets the top number right but makes a sign error on the bottom, treating −5 + 2 as +3. (4, −3) gets the bottom number right but makes a sign error on the top, treating 3 + (−7) as +4.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
- (d) 60° — Method: the six angles at the centre together make one complete turn of 360°, and because the hexagon is regular they are all equal, so divide 360° by 6. Working: 360 ÷ 6 = 60. Answer: 60°. The distractors: 120° is the interior angle of a regular hexagon, 720 ÷ 6, which is the angle at a vertex and not the angle at the centre; 45° comes from dividing 360 by 8, treating the hexagon as though it had eight sides; 30° comes from halving the angle at the centre, as though each of the six triangles were split again by a line of symmetry.
- (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (d) 15 cm — Method: any two sides of a triangle must together be longer than the third, so the third side must be longer than the difference of the two given sides and shorter than their sum. Working: the difference is 20 − 8 = 12 cm and the sum is 20 + 8 = 28 cm, so the third side must be between 12 cm and 28 cm, and 15 cm lies inside that range. Answer: 15 cm. The distractors: 12 cm is exactly the difference, so the three lengths would lie flat along a straight line and never close into a triangle; 5 cm is shorter than the difference — 5 + 8 = 13 cm cannot reach across the 20 cm side — and is chosen by candidates who check no lower limit at all; 30 cm is longer than the sum of the other two, so those two sides could never meet, and it is chosen by candidates who check no upper limit.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (c) RHS applies: the right angle, hypotenuse and one matching side are all equal — Both triangles are right-angled, and the hypotenuses (AC and DF) are equal, and one further pair of matching sides (AB and DE) are equal. This matches the Right angle-Hypotenuse-Side condition, which needs only these three facts, not a third side.
Build your own mix at the worksheet builder.