Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (d) Opposite angles in a cyclic quadrilateral sum to 180° — ABCD is a cyclic quadrilateral, and angle ABC and angle ADC are a pair of opposite angles in it — they don't sit next to each other around the quadrilateral. The theorem that fixes the sum of a cyclic quadrilateral's opposite angles at 180° is exactly the one needed here. The other three theorems don't apply to this figure at all: the angle-in-a-semicircle theorem gives a 90° angle only when one side is a diameter, and no diameter is mentioned; the angle-at-the-centre theorem needs a centre point and an inscribed angle on the same arc, and no centre is given here; the tangent–radius theorem gives a 90° angle only where a tangent line touches the circle, and there is no tangent in this figure. Only the cyclic-quadrilateral theorem fits what is actually drawn.
- (d) (2, −1) — Method: for an enlargement, image = centre + k × (point − centre), so the centre satisfies centre = (image − k × point) ÷ (1 − k). Working: with k = 5, point (4, 1) and image (12, 9): 5 × (4, 1) = (20, 5); (12, 9) − (20, 5) = (−8, 4); dividing by 1 − 5 = −4 gives (2, −1). Answer: (2, −1), the centre of the enlargement, is the only invariant point since the scale factor is not 1. Subtracting the point itself instead of k times the point, (12, 9) − (4, 1) = (8, 8), then dividing by −4 gives (−2, −2); dividing by k − 1 = 4 instead of 1 − k = −4 gives (−2, 1); and simply taking the midpoint of the point and its image ignores the scale factor altogether and gives (8, 5). The centre of an enlargement is never just the midpoint between a point and its image unless the scale factor happens to be −1 — always use the full centre formula and keep the scale factor k in it.
- (a) 2 — Method: recall that the diagonals of a rhombus are always lines of symmetry, whatever its angles are. Working: a rhombus (all sides equal) always has its two diagonals as lines of symmetry, giving 2 lines of symmetry, whether or not the angles are 90°. Options: 0 wrongly assumes a non-square rhombus has no symmetry at all; 4 comes from the number of lines of symmetry a square has, mistaking this rhombus for a square; 1 comes from treating the rhombus like a kite, which has only one diagonal as a line of symmetry. Answer: 2.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (c) 18 — Rearranging F + V − E = 2 gives E = F + V − 2. Substitute F = 8 and V = 12: 8 + 12 − 2 = 18 edges. Choosing 20 comes from adding the faces and vertices but forgetting to subtract the 2 (8 + 12 = 20). Choosing 22 comes from adding the 2 instead of subtracting it (8 + 12 + 2 = 22). Choosing 16 comes from subtracting 2 twice by mistake (8 + 12 − 2 − 2 = 16).
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (a) 75° — The three angles in the triangle formed by the two supports and the ground add up to 180°. Two of the angles are 34° and 71°, so the third angle is 180 − 34 − 71 = 75, which is 75°. 105° comes from adding the two given angles together instead of subtracting them from 180° (34 + 71 = 105). 146° comes from computing 180 − 34 = 146 and forgetting to also subtract 71°. 37° comes from subtracting the two given angles from each other instead of using the triangle's angle sum (71 − 34 = 37).
- (a) 24 cm — The line from the centre to the midpoint of a chord is perpendicular to the chord, so triangle OMA has a right angle at M. By Pythagoras' theorem, AM² = OA² − OM² = 169 − 25 = 144, so AM = 12 cm. AB is twice AM, since M is the midpoint: AB = 2 × 12 = 24 cm. Finding AM = 12 cm correctly but forgetting to double it for the full chord gives 12 cm. Working out 169 − 25 = 144 and forgetting to take the square root gives 144 cm. Subtracting first and then doubling the wrong way, (13 − 5) × 2, gives 16 cm. Doubling AM after finding it correctly is the step that's missing from all three — do it, and you get 24 cm.
- (d) (1/2)a + (1/2)c — Method: X is the midpoint of AC, so OX = OA + (1/2)AC, with AC = c − a. Working: OX = a + 1/2(c − a) = a − (1/2)a + (1/2)c = (1/2)a + (1/2)c. Answer: OX = (1/2)a + (1/2)c. Since OB = a + c, this is exactly half of OB, so OX = (1/2)OB, meaning X lies on OB at its midpoint too — the two diagonals bisect each other. Forgetting to halve AC at all gives a + c, which is OB itself, not its midpoint; halving only the c-term gives (1/2)a + c; and a sign error on the c-term gives (1/2)a − (1/2)c. Halve the whole of AC, both terms together, and add it to OA rather than to a alone.
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
Build your own mix at the worksheet builder.