Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 15 cm — Method: any two sides of a triangle must together be longer than the third, so the third side must be longer than the difference of the two given sides and shorter than their sum. Working: the difference is 20 − 8 = 12 cm and the sum is 20 + 8 = 28 cm, so the third side must be between 12 cm and 28 cm, and 15 cm lies inside that range. Answer: 15 cm. The distractors: 12 cm is exactly the difference, so the three lengths would lie flat along a straight line and never close into a triangle; 5 cm is shorter than the difference — 5 + 8 = 13 cm cannot reach across the 20 cm side — and is chosen by candidates who check no lower limit at all; 30 cm is longer than the sum of the other two, so those two sides could never meet, and it is chosen by candidates who check no upper limit.
- (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
- (b) Yes — OA = OC (radii), so the base angles are equal. — Method: check the definition of a radius and the isosceles triangle property the step relies on. Working: every radius of a circle has the same length, so OA = OC regardless of where A and C sit on the circle — this alone makes triangle OAC isosceles, and the base angles opposite the two equal sides, angle OAC and angle OCA, must be equal. The verdict is Yes, for exactly that reason. Claiming OA and OC are only equal if they are drawn to 'the very same point' misunderstands what a radius is — A and C can be any two points on the circle and OA still equals OC. Claiming the triangle is isosceles because angle AOC is 90° reverses the logic: nothing in the step has fixed angle AOC at 90°, and even if it had, that alone would not explain why OA = OC. Claiming the triangle would need to be equilateral confuses isosceles (two equal sides) with equilateral (three equal sides) — only two sides, OA and OC, are being compared here.
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (a) 1/3 — Method: since OABC is a parallelogram, B = OA + OC = a + c. M = (1/2)c, since M is the midpoint of OC. Since AN is twice NC, N is 2/3 of the way along AC from A, so N = a + 2/3(c − a) = (1/3)a + (2/3)c. Working: MN = N − M = (1/3)a + (1/6)c, and MB = B − M = a + (1/2)c. Comparing term by term, 1/3 × (a + (1/2)c) = (1/3)a + (1/6)c, which matches MN exactly. Answer: k = 1/3, so M, N and B lie on a straight line. Giving 2/3 instead is the scalar linking N to B (NB = (2/3)MB), not M to N; giving 1/6 is just MN's c-coefficient read off on its own, without comparing it to MB's c-coefficient at all; and giving 3 is the scalar the wrong way up — it is MB that equals 3 × MN, not the other way round, since MN = k × MB was what was asked for. Always match the direction of the scalar to the vectors exactly as the question states them.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (c) 6 squares — Method: the plan view shows the footprint of the solid; a second layer stacked on top of floor positions that are already covered does not create any new squares in the plan. Working: the row of 4 cubes and the row of 2 cubes attached at the end do not overlap, so the footprint has 4 + 2 = 6 distinct squares. Answer: 6 squares. The distractors: 12 squares comes from counting the total number of cubes used, including the second layer (6 floor positions × 2 layers = 12), instead of the footprint. 4 squares comes from counting only the row of four and forgetting the attached row of two. 5 squares comes from wrongly treating the corner square as shared between the two rows (4 + 1 instead of 4 + 2).
Build your own mix at the worksheet builder.