Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (b) (−2, −1) — Method: apply the reflection to the point first, then rotate the image about the given centre, in the order the question states them. Working: reflecting (3, 4) in the line y = 1 keeps x = 3 and puts the image as far below the line as the point is above it: 4 is 3 units above y = 1, so the image is 3 units below, at 1 − 3 = −2 (the same as 2 × 1 − 4 = −2). The reflected point is (3, −2). Rotating (3, −2) by 90° clockwise about (1, 1): subtracting the centre gives 3 − 1 = 2 and −2 − 1 = −3, the clockwise rule swaps and negates these to give −3 and −2, and adding the centre back gives 1 + (−3) = −2 and 1 + (−2) = −1. The final image is (−2, −1). Answer: (−2, −1). Reflect before you rotate, exactly as the design process is described, and rotate about the CENTRE (1, 1) given in the question rather than the origin: either mistake, or reversing the two steps, sends the tile to a different point.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (d) 1 — sin 30° = 1/2, so (sin 30°)² = 1/4. cos 30° = √3/2, so (cos 30°)² = 3/4. Adding these gives 1/4 + 3/4 = 1. '1/4' only calculates (sin 30°)² and forgets to add the cos 30° term. '3/4' only calculates (cos 30°)² and forgets to add the sin 30° term. '−1/2' comes from subtracting the two squared values instead of adding them: 1/4 − 3/4 = −1/2.
- (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (b) 115° — Angle APE and angle BPQ are vertically opposite, so angle BPQ = 65°, equal to angle APE. Angle BPQ and angle PQD are co-interior (allied) angles between the parallel lines, and co-interior angles always add up to 180°, so angle PQD = 180 − 65 = 115°. "65°" comes from treating co-interior angles as equal to each other, the way alternate angles are, instead of adding to 180°. "295°" comes from applying the angles-round-a-point fact (360° − 65°) directly to the original 65°, skipping the correct co-interior step. "25°" comes from misremembering co-interior angles as adding to 90° instead of 180° (90 − 65 = 25).
- (d) 49° — Method: first combine the two given angles at the centre to find the whole central angle FOM, then apply the angle-at-the-centre theorem, which halves the central angle to give the angle at the circumference on the major arc. Working: angle FOM = angle FOP + angle POM = 55 + 43 = 98 degrees. Since S is on the major arc FM, angle FSM = 98 ÷ 2 = 49 degrees. Answer: 49°. Add BOTH given angles to find the whole angle FOM before you halve anything: halving only one of them, doubling the total instead of halving it, or subtracting from 180° all give the wrong angle for the programme.
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (c) 80 cm² — Method: a composite shape made of two rectangles that do not overlap has an area equal to the sum of the two rectangle areas, so work out each area and add them. Working: the first rectangle has area 12 × 4 = 48 cm² and the second has area 4 × 8 = 32 cm², so the total is 48 + 32 = 80. Answer: 80 cm². The distractors: 48 cm² comes from working out the larger rectangle only and treating it as the whole shape; 32 cm² comes from working out the smaller rectangle only; 28 cm comes from adding the four given lengths, 12 + 4 + 4 + 8, which is a distance rather than an area and so carries a plain centimetre unit.
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
Build your own mix at the worksheet builder.