Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (b) 61° — Triangle OAT is isosceles because OA = OT, both radii, so its base angles are equal: angle OTA = angle OAT = (180° − 122°) ÷ 2 = 29°. The tangent PT meets the radius OT at 90°, by the tangent–radius theorem, so angle OTP = 90°. Since TA lies between TO and TP, angle OTP splits into angle OTA and angle ATP: angle ATP = 90° − 29° = 61°. Stopping after the isosceles step and reporting the base angle itself gives 29°. Finding the base angles as 180° − 122° without halving, then subtracting from 90°, gives 90° − 58° = 32°. Adding the base angle to 90° instead of subtracting it gives 90° + 29° = 119°. Subtract the base angle from the right angle, and 61° is what's left.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (c) 0.5 — The real distance is 2 × 25000 = 50000 cm. Converting to metres, by dividing by 100, gives 500 m, and converting to kilometres, by dividing by 1000, gives 0.5 km. A candidate who divides the 50000 cm by 1000 in one go, applying the metres-to-kilometres factor straight to the centimetres, gets 50 km. A candidate who divides by 100 twice, treating 100 m as 1 km, gets 5 km. A candidate who slips one extra decimal place when converting 500 m to kilometres gets 0.05 km. The real distance is 0.5 km.
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
Build your own mix at the worksheet builder.