Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (d) 15 cm — Method: any two sides of a triangle must together be longer than the third, so the third side must be longer than the difference of the two given sides and shorter than their sum. Working: the difference is 20 − 8 = 12 cm and the sum is 20 + 8 = 28 cm, so the third side must be between 12 cm and 28 cm, and 15 cm lies inside that range. Answer: 15 cm. The distractors: 12 cm is exactly the difference, so the three lengths would lie flat along a straight line and never close into a triangle; 5 cm is shorter than the difference — 5 + 8 = 13 cm cannot reach across the 20 cm side — and is chosen by candidates who check no lower limit at all; 30 cm is longer than the sum of the other two, so those two sides could never meet, and it is chosen by candidates who check no upper limit.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (a) 3 times the size, opposite side, rotated 180° — Method: for any enlargement, the MAGNITUDE of the scale factor gives the size ratio between image and object, while the SIGN decides which side of the centre the image falls on; a negative scale factor puts the image on the opposite side, which is equivalent to a 180° rotation about the centre. Working: the scale factor is −3, so the size ratio is the magnitude, which is 3, and the negative sign puts the image on the opposite side of the centre, rotated 180° relative to the original. Answer: 3 times the size, opposite side, rotated 180°. The magnitude of the scale factor controls the SIZE only: do not let the sign leak into it and turn 3 into 1/3. The sign controls the SIDE and orientation, which a positive-only view of enlargement, just 'further away' with the same orientation, misses entirely.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (d) (−14, 5) — To undo a composition, reverse the order and invert each transformation: undo the rotation first, then undo the translation. The inverse of 'rotate 90° clockwise about the origin' is 'rotate 90° anticlockwise about the origin', which maps (x, y) to (−y, x); applied to (3, 9) this gives (−9, 3). Then undo the translation by subtracting the vector (5, −2), i.e. adding (−5, 2): (−9 − 5, 3 + 2) = (−14, 5). Undoing the two inverse steps in the same order as the original composition, rather than reversing it, gives (−11, −2). Rotating 90° clockwise again instead of inverting the rotation's direction gives (4, −1). Adding the translation vector again instead of subtracting it, after correctly inverting the rotation, gives (−4, 1).
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
- (a) 75° — The three angles in the triangle formed by the two supports and the ground add up to 180°. Two of the angles are 34° and 71°, so the third angle is 180 − 34 − 71 = 75, which is 75°. 105° comes from adding the two given angles together instead of subtracting them from 180° (34 + 71 = 105). 146° comes from computing 180 − 34 = 146 and forgetting to also subtract 71°. 37° comes from subtracting the two given angles from each other instead of using the triangle's angle sum (71 − 34 = 37).
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (a) 1 : 8 — Method: in similar solids the ratio of the volumes is the cube of the ratio of corresponding lengths. Working: the heights are in the ratio 1 : 2, so the volumes are in the ratio 1³ : 2³ = 1 : 8. Answer: 1 : 8. The distractors: 1 : 2 leaves the height ratio unchanged, as though a volume scaled in the same way as a length; 1 : 4 comes from squaring, 1² : 2², which is the rule for surface areas and not for volumes; 1 : 6 comes from multiplying each part by 3 instead of raising each part to the power 3.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
Build your own mix at the worksheet builder.