Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 32 — Method: alternate angles between parallel lines are equal, so 2x + 10 = 74. Working: subtracting 10 from both sides gives 2x = 64; dividing by 2 gives x = 32. Answer: x = 32. A candidate who forgets to subtract 10 first and divides 74 by 2 directly gets 37. A candidate who treats the angles as co-interior instead of alternate, so that the two expressions add to 180° rather than being equal, gets 48 after solving. A candidate who makes a sign error and treats the equation as 2x equalling 10 minus 74 instead of 74 minus 10 gets −32.
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (c) Two angles and one side are known; x is another side — The sine rule needs a matching pair, a side and the angle opposite it, that you already know, so you can set up a ratio with the unknown. When two angles and one side are known, you can find the third angle from the angle sum, giving you an angle opposite the known side and an angle opposite x: the sine rule applies directly. When all three sides are known and x is an angle, there is no side-angle pair available at all, so the cosine rule, rearranged for an angle, is what's needed instead. When two sides and the included angle are known and x is the third side, again there is no matching side-angle pair yet, so the cosine rule finds the third side directly. When two sides and the included angle are known and x is one of the other angles, you still have no side-angle pair to start from — the cosine rule has to be used first, to find the third side, before any angle can be found. Only the two-angles-and-a-side case hands you a ready-made pair, which is exactly what the sine rule needs.
- (b) 61° — Triangle OAT is isosceles because OA = OT, both radii, so its base angles are equal: angle OTA = angle OAT = (180° − 122°) ÷ 2 = 29°. The tangent PT meets the radius OT at 90°, by the tangent–radius theorem, so angle OTP = 90°. Since TA lies between TO and TP, angle OTP splits into angle OTA and angle ATP: angle ATP = 90° − 29° = 61°. Stopping after the isosceles step and reporting the base angle itself gives 29°. Finding the base angles as 180° − 122° without halving, then subtracting from 90°, gives 90° − 58° = 32°. Adding the base angle to 90° instead of subtracting it gives 90° + 29° = 119°. Subtract the base angle from the right angle, and 61° is what's left.
- (d) (4, −2) — Method: apply the rotation to the point first, then reflect the rotated image, in the order stated. Working: rotating (4, 2) by 90° anticlockwise about the origin sends (x, y) to (−y, x), so (4, 2) becomes (−2, 4). Reflecting (−2, 4) in the line y = x swaps its coordinates, giving (4, −2). Answer: (4, −2). Rotate before you reflect, exactly as the question orders them: these two maps do not commute, so reflecting first, only rotating without swapping the coordinates afterwards, or forgetting to negate the coordinate when rotating anticlockwise all send you to a different point.
- (d) DE = 8 cm — Method: use the stated correspondence ABC ≅ DEF to work out which side in DEF matches the known side AB in ABC. Working: the correspondence sends A to D, B to E and C to F, so AB corresponds to DE; the right angles at B and E and the equal hypotenuses AC = DF = 17 cm are already given, so DE = 8 cm supplies the third ingredient — Right angle, Hypotenuse, Side. Options: EF = 8 cm matches AB to the wrong side, since EF corresponds to BC, and BC = √(17² − 8²) = 15 cm, not 8 cm; BC = 8 cm states something about triangle ABC rather than the missing fact about DEF, and it is false as well, since BC = 15 cm; angle D = angle A does follow once the triangles are congruent, but RHS is completed by a matching side, not by a matching angle. Answer: DE = 8 cm.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (c) 15 — The exterior angle is 180° − 156° = 24°, and the number of sides of a regular polygon is 360° divided by the exterior angle, so 360 ÷ 24 = 15. 24° is the exterior angle itself, stopping one step before the final division. 17 comes from finding 15 correctly and then adding 2, muddling the exterior angle rule with the (n − 2) that appears in the interior angle sum formula. 7.5 comes from dividing 180 by the exterior angle instead of 360, using the angles on a straight line rather than the total of the exterior angles of a polygon.
- (b) AB = DE — RHS needs a right angle, the hypotenuse, and one OTHER side to be equal; the right angles and hypotenuses are already equal, so a matching pair of the remaining sides, AB = DE, completes RHS. Angle A = angle D is an extra ANGLE fact, not the extra SIDE fact that RHS specifically requires. AC being parallel to DF says nothing about either triangle's side lengths, so it cannot complete a congruence condition. Being drawn the same way up is about orientation on the page, not about any measurement, so it proves nothing about congruence.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
Build your own mix at the worksheet builder.