Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (a) isosceles trapezium — One pair of parallel sides, plus a separate pair of equal non-parallel sides, is exactly the definition of an isosceles trapezium — the shape the designer should draw. Parallelogram is wrong because a parallelogram needs BOTH pairs of opposite sides parallel, but only one pair is parallel here. Kite is wrong because a kite has two separate pairs of adjacent equal sides and no requirement for any sides to be parallel, a different combination of properties. Rhombus is wrong because a rhombus needs all four sides equal, but the description only makes two of the four sides equal to each other.
- (a) 2 — Method: recall that the diagonals of a rhombus are always lines of symmetry, whatever its angles are. Working: a rhombus (all sides equal) always has its two diagonals as lines of symmetry, giving 2 lines of symmetry, whether or not the angles are 90°. Options: 0 wrongly assumes a non-square rhombus has no symmetry at all; 4 comes from the number of lines of symmetry a square has, mistaking this rhombus for a square; 1 comes from treating the rhombus like a kite, which has only one diagonal as a line of symmetry. Answer: 2.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (b) trapezium — A quadrilateral with exactly one pair of parallel sides is a trapezium; field ABCD has AB parallel to DC and no other pair of parallel sides, so trapezium is correct. Parallelogram requires BOTH pairs of opposite sides to be parallel, but the plan says only AB and DC are parallel. Rhombus requires all four sides to be equal in length, which is not stated here. A kite is defined by two pairs of adjacent equal sides, not by having a pair of parallel sides, so it does not match this description either.
- (a) 3/4 — 1 litre = 1000 ml, so 750 ml is 750/1000 of a litre. Dividing both the numerator and denominator by 250 simplifies this to 3/4. Writing the fraction upside down, as the litre out of the 750 ml, gives 4/3. Finding the fraction of the litre that is NOT filled, 250/1000, gives 1/4. Dividing the numerator by 250 but the denominator by only 100, an inconsistent simplification, gives 3/10.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (a) 4700 cm² — Method: split the T-shaped outline into the two rectangles it is made from, find the area of each, then add them together. Working: the wide base gives a rectangle 90 cm × 30 cm = 2700 cm²; the narrower block on top gives a rectangle 40 cm × 50 cm = 2000 cm²; adding these, 2700 + 2000 = 4700 cm². Answer: 4700 cm². The distractors: 2700 cm² comes from finding only the area of the base rectangle and forgetting to add the block on top. 2000 cm² comes from finding only the area of the top block and forgetting the base. 7200 cm² comes from treating the whole outline as one large rectangle, 90 cm wide by (30 + 50) = 80 cm tall, instead of splitting it into the two separate rectangles that actually make up the shape.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) 5 cm by 3 cm — The plan view looks straight down on the cuboid's footprint, so it shows the length (5 cm, left to right) and the depth (3 cm, front to back) — the two dimensions that do not involve height. "5 cm by 2 cm" repeats the front elevation's dimensions, pairing the length with the height instead of the depth. "3 cm by 2 cm" repeats the side elevation's dimensions, again pairing the depth with the height rather than with the length. "5 cm by 5 cm" comes from mistakenly assuming the plan must be a square, pairing the length with itself instead of with the depth.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (a) (8, 2) — Method: translating a point by a column vector means adding the vector's top number to the x-coordinate and its bottom number to the y-coordinate. Working: x-coordinate 2 + 6 = 8; y-coordinate 5 + (−3) = 2. Answer: B = (8, 2). A candidate who ignores the negative sign and adds 3 instead of −3 gets (8, 8). A candidate who translates in the reverse direction, subtracting the vector from A instead of adding it, gets (−4, 8). A candidate who swaps the vector's top and bottom numbers before adding gets (−1, 11).
Build your own mix at the worksheet builder.