Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 63° — Method: a tangent meets the radius drawn to the point of contact at a right angle, so triangle OPT has a 90° angle at T; the three angles of the triangle then sum to 180°. Working: angle OTP = 90°, angle OPT = 27°, so angle POT = 180 − 90 − 27 = 63 degrees. Answer: 63°. The tangent-radius angle is a fixed 90°, not something to assume equal to another angle in the triangle, and the three angles of ANY triangle sum to 180°, never 360°: that total belongs to a quadrilateral, not a triangle.
- (d) 1.2 m² — Method: an area in square metres needs lengths in metres, so convert first and then multiply. Working: 100 cm = 1 m, so 150 cm = 1.5 m and 80 cm = 0.8 m, and the area = 1.5 × 0.8 = 1.2 m². Answer: 1.2 m². The same result comes from working in centimetres: 150 × 80 = 12 000 cm², and a square metre is a square of side 100 cm, so 100 × 100 = 10 000 cm² make one square metre and 12 000 ÷ 10 000 = 1.2. Dividing the 12 000 cm² by 100 instead, as though a square metre held only 100 square centimetres, gives 120 m²; dividing by 1000 gives 12 m². Working out the perimeter rather than the area gives 1.5 + 0.8 + 1.5 + 0.8 = 4.6, which is a length and not an area.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (d) No — the volume factor is 2³ = 8, not the area factor 4. — For similar solids, area scales with the square of the length scale factor and volume scales with its cube — different powers of the same number, so they are not usually equal. The length scale factor here is 2, so the area scale factor is 2² = 4 (Priya's figure) but the volume scale factor is 2³ = 8. Priya is wrong: the correct volume scale factor is 8, not 4. The option claiming area and volume always scale by the same factor treats the two as interchangeable, which is only true for the length factor itself. The option giving 6 comes from multiplying the length factor by the number of dimensions (2 × 3) rather than cubing it. The option repeating '4' for volume simply reuses Priya's own area calculation.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (b) (3, −3) — Subtracting column vectors means subtracting the top numbers and subtracting the bottom numbers, in the order given: top = 5 − 2 = 3, bottom = 1 − 4 = −3, giving (3, −3). A candidate who works out v − u instead of u − v, reversing the order, gets (−3, 3). A candidate who makes a sign error on the bottom number, treating 1 − 4 as 3 instead of −3, gets (3, 3). A candidate who adds the vectors instead of subtracting gets (7, 5). Because the question asks for u − v, not v − u, the correct answer is (3, −3).
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (a) a rounded rectangle: 5 m by 4 m with semicircular ends — Points within 2 m of the straight part of the fence form a rectangle running the 5 m length of the fence and 4 m wide (2 m on each side); points within 2 m of each END of the fence, beyond that rectangle, form a semicircle of radius 2 m there, since the nearest point of the fence to them is just that one end. Together this gives a rounded, stadium-shaped region. "a rectangle, 9 m by 4 m" extends the rectangle by 2 m at each end instead of rounding it, wrongly including corner points that are actually more than 2 m from every part of the fence. "a circle of radius 2 m" treats the whole 5 m fence as a single point. "a rectangle, 5 m by 2 m" uses 2 m as the full width instead of the distance on EACH side, so it only covers one side of the fence.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (c) 2 — A point 4 cm from A lies on a circle of radius 4 cm centred at A; a point 3 cm from B lies on a circle of radius 3 cm centred at B. Since AB = 5 cm, and 4 + 3 = 7 is greater than 5 while 4 − 3 = 1 is less than 5, the two circles genuinely cross each other, at two separate points, one on each side of line AB. "1" comes from wrongly assuming the circles only touch rather than cross, which would need 4 + 3 to equal exactly 5. "0" comes from wrongly assuming the circles miss each other completely. "4" comes from counting where each circle crosses the line AB itself (two points each) instead of counting where the two circles cross each other.
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
Build your own mix at the worksheet builder.