Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (c) 0.5 — The real distance is 2 × 25000 = 50000 cm. Converting to metres, by dividing by 100, gives 500 m, and converting to kilometres, by dividing by 1000, gives 0.5 km. A candidate who divides the 50000 cm by 1000 in one go, applying the metres-to-kilometres factor straight to the centimetres, gets 50 km. A candidate who divides by 100 twice, treating 100 m as 1 km, gets 5 km. A candidate who slips one extra decimal place when converting 500 m to kilometres gets 0.05 km. The real distance is 0.5 km.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (d) −2 — Method: the scale factor is the ratio of the image vector to the object vector, both measured FROM THE CENTRE of enlargement, keeping every sign. Working: the vector from the centre (2, 1) to P(2, 5) is (0, 4); the vector from the centre to P′(2, −7) is (0, −8). The scale factor is −8 ÷ 4 = −2. Answer: −2. Measure both vectors from the CENTRE, not from the origin, divide the IMAGE vector by the OBJECT vector and not the other way round, and keep the negative sign: a negative scale factor is not the same size as its positive counterpart with the sign dropped.
- (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
- (d) Opposite angles in a cyclic quadrilateral sum to 180° — ABCD is a cyclic quadrilateral, and angle ABC and angle ADC are a pair of opposite angles in it — they don't sit next to each other around the quadrilateral. The theorem that fixes the sum of a cyclic quadrilateral's opposite angles at 180° is exactly the one needed here. The other three theorems don't apply to this figure at all: the angle-in-a-semicircle theorem gives a 90° angle only when one side is a diameter, and no diameter is mentioned; the angle-at-the-centre theorem needs a centre point and an inscribed angle on the same arc, and no centre is given here; the tangent–radius theorem gives a 90° angle only where a tangent line touches the circle, and there is no tangent in this figure. Only the cyclic-quadrilateral theorem fits what is actually drawn.
- (a) 90° — Method: the angle in a semicircle theorem states that the angle subtended at the circumference by a diameter is always a right angle, whatever the circle's size. Working: since AC is a diameter, the angle ABC subtended at the circumference by AC is 90 degrees, regardless of the circle's radius. Answer: 90°. This result holds for every position of B on the circle and for every size of circle, so no length or radius is ever needed: do not confuse angle ABC with the straight angle along the diameter itself, which is 180°, and do not halve the right angle again.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (b) 1 point — A rotation about a point P always leaves P itself unchanged, and — unless the shape has rotational symmetry about that exact point — no other point of the shape maps onto itself. The centre of rotation here is the vertex (2, 1), so exactly one point of the trapezium, that vertex, is invariant. Thinking that a rotation always has no invariant points ignores the centre of rotation itself, which is always fixed, and gives 0 points. Assuming every vertex of the shape is invariant confuses a rotation with the identity transformation and gives 4 points, the total number of vertices. Believing that the point diametrically opposite the centre is also fixed applies point symmetry of the whole coordinate grid rather than checking whether that point actually lies on this particular trapezium, and gives 2 points.
- (b) 4 — The scale factor is the distance from the centre to the image, divided by the distance from the centre to the object: (5 − 1) ÷ (2 − 1) = 4 ÷ 1 = 4. (2.5 comes from dividing the raw y-coordinates, 5 ÷ 2, without first subtracting the centre's coordinate; 3 comes from subtracting the two distances instead of dividing them; 0.25 comes from dividing the distances the wrong way round.)
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
Build your own mix at the worksheet builder.