Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) (1/3)a + (2/3)b — Method: OP = OA + AP, and since AP is twice PB, AP is 2/3 of the whole of AB, with AB = b − a. Working: OP = a + 2/3(b − a) = a − (2/3)a + (2/3)b = (1/3)a + (2/3)b. Answer: OP = (1/3)a + (2/3)b. Measuring 2/3 of AB from B's end instead of A's swaps the fractions round, giving (2/3)a + (1/3)b; adding (2/3)b onto the whole of a without first subtracting a inside the bracket gives a + (2/3)b; and treating the ratio as though AP and PB were equal gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from the point named first in the ratio, subtract before you scale, and then add the result to OA.
- (b) (5, −3) — Method: rotate the point about the given centre first, then translate the image, in the stated order. Working: rotating (0, 2) by 180° about (2, 2) uses the rule (x, y) → (4 − x, 4 − y), since the centre doubles in each coordinate. This gives 4 − 0 = 4 and 4 − 2 = 2, so (0, 2) maps to (4, 2). Translating (4, 2) by the vector (1, −5) gives 4 + 1 = 5 and 2 − 5 = −3, so the final image is (5, −3). Answer: (5, −3). Rotate about the centre GIVEN in the question, (2, 2), not about the origin, and translate the rotated image afterwards, in that order: rotating about the wrong centre, swapping the order, or stopping after one step all give a different point.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (b) 23 — If every position were filled to the full height of 3, the total would be 2 × 4 × 3 = 24 crates. One corner position has only 2 crates instead of 3, one crate short of full height there, so the actual total is 24 − 1 = 23. "24" comes from using the full height everywhere and forgetting the one incomplete corner. "22" comes from removing 2 crates for the incomplete corner instead of the 1 that is actually missing (3 − 2 = 1, not 2). "21" comes from removing all 3 crates at that corner, as though the position were completely empty rather than 2 crates short.
- (c) $12\sqrt{3}$ cm² — Use Area = 1/2 × AB × AC × sin(angle BAC) = 1/2 × 6 × 8 × sin 60°. Since sin 60° = √3⁄2, this is 1/2 × 6 × 8 × √3⁄2 = 24 × √3⁄2 = 12√3 cm². Using AB × AB instead of AB × AC (taking 6 × 6 rather than 6 × 8) gives 1/2 × 6 × 6 × sin 60° = 18 × √3⁄2 = 9√3 cm². Using AC × AC instead of AB × AC (taking 8 × 8 rather than 6 × 8) gives 1/2 × 8 × 8 × sin 60° = 32 × √3⁄2 = 16√3 cm². Leaving out the 1/2 from the area formula gives 6 × 8 × sin 60° = 48 × √3⁄2 = 24√3 cm².
- (c) tan 45° — Method: replace each ratio by its exact value, then compare. Working: a right-angled triangle with a 45° angle is isosceles, so its opposite and adjacent sides are equal and the tangent of 45° is exactly 1. The others are cos 30° = √3/2, about 0.87; sin 45° = √2/2, about 0.71; and cos 60° = 1/2. Answer: tan 45°, the only one of the four that reaches 1. Reading √3/2 as though it were √3, about 1.73, makes cos 30° look the largest, but the division by 2 is part of the value. Ranking by the size of the angle also fails here, because the cosine of an angle falls as the angle grows.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (c) 10 cm — The diagonals of a rhombus bisect each other at right angles, splitting it into four congruent right-angled triangles with legs 8 cm (half of 16 cm) and 6 cm (half of 12 cm). By Pythagoras' Theorem, side² = 8² + 6² = 64 + 36 = 100. Square root: √100 = 10 cm.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (b) (0, 2) — Method: to rotate about a point that is not the origin, first subtract the centre's coordinates, apply the rotation rule to the shifted point, then add the centre's coordinates back on; only after that do you apply the translation, in the order the question states them. Working: shifting P relative to the centre gives (6 − 1, 4 − 2) = (5, 2); rotating 90° clockwise sends (x, y) to (y, −x), giving (2, −5); adding the centre back on gives (2 + 1, −5 + 2) = (3, −3); applying the translation (−3, 5) gives (3 − 3, −3 + 5) = (0, 2). Answer: (0, 2). Applying the translation BEFORE the rotation, reversing the order the question gives them in, gives (8, 0); stopping after the rotation and forgetting the translation altogether gives (3, −3); and rotating anticlockwise instead of clockwise, using (x, y) → (−y, x), gives (−4, 12). Always carry out the two transformations in the order stated — rotate about the given centre first, then translate — and check each step before moving to the next.
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
Build your own mix at the worksheet builder.