Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (d) A rectangle — Method: to find the plan view, work out the outline traced when looking straight down onto the solid from directly above, not the outline shown in the angled sketch. Working: this solid has two identical flat round ends joined by one curved surface, and it is lying on its side rather than standing upright; viewed from above, the curved surface gives two straight edges running the full length of the solid, the width of the round ends apart, and each flat round end — seen edge-on from directly above — also becomes a straight edge of that same width, with no curve remaining. Four straight edges, with opposite sides equal and meeting at right angles, form a rectangle. Answer: a rectangle. The distractors: a circle comes from picturing the solid as if it were standing upright on one of its flat ends, giving the plan of an upright version instead of working out the plan of the solid as it actually lies. An oval comes from copying the foreshortened shape of a round end as it is drawn in the angled sketch, instead of working out the true shape seen from directly above, which has no such foreshortening. A rectangle with rounded ends comes from carrying the curve of the round ends over into the plan view, when in fact a flat round end viewed edge-on from directly above shows no curve at all, only a straight edge.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (b) A right-angled triangle — The right angle at Y makes this a right-angled triangle, so that description is correct. Since XY is twice YZ, those two sides cannot be equal. The third side XZ is opposite the right angle, so it is the hypotenuse and is longer than either XY or YZ, so it cannot equal either of them. No two sides are equal, which rules out 'an isosceles triangle' and 'a right-angled isosceles triangle', both of which wrongly assume two equal sides. 'An equilateral triangle' would need all three sides equal, which contradicts XY being twice YZ, so it is wrong too.
- (d) (2, −1) — Method: for an enlargement, image = centre + k × (point − centre), so the centre satisfies centre = (image − k × point) ÷ (1 − k). Working: with k = 5, point (4, 1) and image (12, 9): 5 × (4, 1) = (20, 5); (12, 9) − (20, 5) = (−8, 4); dividing by 1 − 5 = −4 gives (2, −1). Answer: (2, −1), the centre of the enlargement, is the only invariant point since the scale factor is not 1. Subtracting the point itself instead of k times the point, (12, 9) − (4, 1) = (8, 8), then dividing by −4 gives (−2, −2); dividing by k − 1 = 4 instead of 1 − k = −4 gives (−2, 1); and simply taking the midpoint of the point and its image ignores the scale factor altogether and gives (8, 5). The centre of an enlargement is never just the midpoint between a point and its image unless the scale factor happens to be −1 — always use the full centre formula and keep the scale factor k in it.
- (d) 49° — Method: first combine the two given angles at the centre to find the whole central angle FOM, then apply the angle-at-the-centre theorem, which halves the central angle to give the angle at the circumference on the major arc. Working: angle FOM = angle FOP + angle POM = 55 + 43 = 98 degrees. Since S is on the major arc FM, angle FSM = 98 ÷ 2 = 49 degrees. Answer: 49°. Add BOTH given angles to find the whole angle FOM before you halve anything: halving only one of them, doubling the total instead of halving it, or subtracting from 180° all give the wrong angle for the programme.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (b) trapezium — A quadrilateral with exactly one pair of parallel sides is a trapezium; field ABCD has AB parallel to DC and no other pair of parallel sides, so trapezium is correct. Parallelogram requires BOTH pairs of opposite sides to be parallel, but the plan says only AB and DC are parallel. Rhombus requires all four sides to be equal in length, which is not stated here. A kite is defined by two pairs of adjacent equal sides, not by having a pair of parallel sides, so it does not match this description either.
Build your own mix at the worksheet builder.