Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) A rotation of 180° about the origin — Method: composing two reflections in lines that cross is always a single rotation about the point where the lines meet, through twice the angle between them. Working: the x-axis and y-axis meet at the origin at an angle of 90°, so the combined transformation is a rotation about the origin through 2 × 90 = 180 degrees. Answer: a rotation of 180° about the origin. The rotation angle is TWICE the angle between the mirror lines, not the angle itself, and the centre is always where the two lines cross, not some other point, and the result of two reflections in intersecting lines is a rotation, never another reflection.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (a) 8 — A cylinder has two flat circular faces (the top and the base) and one curved surface, so only its 2 flat faces are wrapped. A cuboid has 6 faces and all of them are flat, so all 6 are wrapped. Adding these: 2 + 6 = 8, so 8 is correct. 9 comes from wrongly counting the cylinder's curved surface as a flat face. 6 comes from counting only the cuboid and forgetting the cylinder's two flat circular faces. 3 comes from counting only the cylinder and including its curved surface in that total.
- (b) (6, 3) — For an enlargement centred on the origin, multiply both coordinates by the scale factor: (2 × 3, 1 × 3) = (6, 3). A pupil who adds the scale factor to each coordinate instead of multiplying gets (2 + 3, 1 + 3) = (5, 4). A pupil who multiplies only the x-coordinate gets (6, 1). A pupil who multiplies only the y-coordinate gets (2, 3). The correct image is (6, 3).
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (d) 4 m — The sloping slide is the hypotenuse of a right-angled triangle with the other two sides 2.4 m and 3.2 m. By Pythagoras' Theorem, hypotenuse² = 2.4² + 3.2² = 5.76 + 10.24 = 16. Square root: √16 = 4 m. Adding the two sides instead of squaring them gives 2.4 + 3.2 = 5.6 m. Truncating each squared side to a whole number before adding (5.76 to 5 and 10.24 to 10) gives √15 ≈ 3.87 m. Forgetting to take the square root and leaving the sum of the squares as the answer gives 5.76 + 10.24 = 16, written as 16 m.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
Build your own mix at the worksheet builder.