Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (c) a + (1/2)c — Method: OABC is a parallelogram, so OB = OA + AB, and since AB is equal and parallel to OC, AB = c; this gives OB = a + c. M is the midpoint of AB, so AM = (1/2)AB = (1/2)c. Working: OM = OA + AM = a + (1/2)c. Answer: OM = a + (1/2)c. Adding the whole of AB instead of half of it gives a + c, which is OB, not OM; halving the whole diagonal OB instead of just AB gives (1/2)a + (1/2)c, the midpoint of OB rather than of AB; and flipping the sign on the c-term gives a − (1/2)c, which points back the wrong way along AB. Halve only the side you are told to halve, and check the sign before you commit to an answer.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (c) (1, 0) — To enlarge about a centre other than the origin, find the vector from the centre to the point, scale that vector, then add it back to the centre. The vector from (2, 2) to A(4, 6) is (2, 4). Scaling by −1/2 gives (−1, −2). Adding this to the centre (2, 2) gives the image point (1, 0). (3, 4) comes from using +1/2 instead of −1/2, so the image lands on the same side as A instead of the opposite side. (−2, −3) comes from scaling A's coordinates directly about the origin, ignoring that the centre is (2, 2). (−2, −6) comes from using a scale factor of −2 instead of −1/2.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (a) 90° — Method: the angle in a semicircle theorem states that the angle subtended at the circumference by a diameter is always a right angle, whatever the circle's size. Working: since AC is a diameter, the angle ABC subtended at the circumference by AC is 90 degrees, regardless of the circle's radius. Answer: 90°. This result holds for every position of B on the circle and for every size of circle, so no length or radius is ever needed: do not confuse angle ABC with the straight angle along the diameter itself, which is 180°, and do not halve the right angle again.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (c) Tangent-chord angle = angle in the alternate segment. — This diagram has a diameter AC, a centre O, and a cyclic quadrilateral ABCD, but no tangent anywhere in it. 'Angle in a semicircle = 90°' applies directly, because AC is a diameter. 'Opposite angles of a cyclic quadrilateral sum to 180°' applies directly, because ABCD is a cyclic quadrilateral. 'Angle at the centre = twice angle at circumference' applies directly, because O is given as the centre of the circle. The tangent-chord fact relates the angle between a tangent and a chord to an angle elsewhere in the circle, and since this diagram has no tangent, there is nothing in it for that fact to describe — so it is the one theorem that does not apply here.
- (a) the lens-shaped region where the two circles overlap — The region within 30 km of the ship is a circle of radius 30 km around the ship; the region within 20 km of the lighthouse is a circle of radius 20 km around the lighthouse. Since 30 + 20 = 50 km is more than the 40 km between them, and 30 − 20 = 10 km is less than 40 km, the two circles genuinely overlap, in a lens-shaped region where both conditions hold at once. "the whole smaller circle, since it fits inside the larger one" would only be true if the 40 km distance between the centres were small enough for one circle to swallow the other, which it is not here. "no overlap — 30 km and 20 km don't add to 40 km" wrongly assumes the two radii must add up to exactly the distance between the centres for an overlap to exist; any total greater than that distance is enough. "a straight strip, exactly halfway between the two" confuses this with an equidistant locus, which is a different problem from the one asked here.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (b) 2 cm — Method: the volume of a cube is edge × edge × edge, so finding the edge from the volume means undoing a cube, not a square or a halving. Working: edge × edge × edge = 8; testing whole numbers, 1 × 1 × 1 = 1 is too small and the next whole number gives 2 × 2 × 2 = 8, which matches. Answer: 2 cm. The distractors: 8 cm comes from writing the volume down as the edge length and changing only the unit; 4 cm comes from halving the volume, 8 ÷ 2, as though a cube were undone by dividing by 2; 2.83 cm is the square root of 8, from taking a square root where a cube root is needed.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
Build your own mix at the worksheet builder.