Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (b) 4 : 9 — The heights are in the ratio 4 : 6, which simplifies to 2 : 3. For similar solids, area scales with the square of the length ratio, so the surface area ratio is 2² : 3² = 4 : 9. 2 : 3 is just the simplified length ratio, before squaring has been done. 8 : 27 comes from cubing the ratio (2³ : 3³) instead of squaring it — that's the rule for volumes, not areas. 9 : 4 has the correct squared values but in the wrong order, giving the larger tin's area first instead of the smaller.
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (d) (3/4)a + (1/4)c — Method: OX = OA + AX, and since AX is a third of XC, AX is 1/4 of the whole of AC, with AC = c − a. Working: OX = a + 1/4(c − a) = a − (1/4)a + (1/4)c = (3/4)a + (1/4)c. Answer: OX = (3/4)a + (1/4)c. Measuring 1/4 of AC from C's end instead of A's swaps the fractions round, giving (1/4)a + (3/4)c; adding (1/4)c onto the whole of a without subtracting a inside the bracket first gives a + (1/4)c; and treating the ratio as though AX and XC were equal gives the midpoint, (1/2)a + (1/2)c. Convert the ratio to a fraction of AC measured from A, subtract before you scale, and then add the result to OA.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (b) No — the angle given is not the included angle — Method: check whether the given angle sits between the two given sides, since SAS requires the included angle. Working: sides AB and BC meet at vertex B, so the angle between them is angle B — but the angle given is angle A, which is not between the two given sides, and the same mismatch happens in triangle DEF. Options: 'two sides and one angle match' restates SAS's ingredients without checking their positions, which is exactly Meera's mistake; 'SSS needs three equal sides' is a true fact about a different condition, but it is not the reason Meera is wrong here; 'SAS allows any equal angle' states a rule that is not how SAS works, since the angle must be the included one. Answer: no, the angle given is not the included angle.
- (d) 16 — Method: use the scale to find the real length and width separately, then use the perimeter formula. Working: real length = 4 cm × 125 = 500 cm = 5 m; real width = 2.4 cm × 125 = 300 cm = 3 m; perimeter = 2 × (5 + 3) = 16 m. A student who answers 8 has added the real length and width but forgotten to double the total for the perimeter. A student who answers 1600 has correctly worked out the perimeter in centimetres but forgotten to convert it to metres. A student who answers 500 has only converted the length to real centimetres and stopped there, ignoring the width and the perimeter step. Answer: 16 m.
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
Build your own mix at the worksheet builder.