Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (a) (−1, 1) — Translating by $\binom{−2}{3}$ subtracts 2 from every x-coordinate and adds 3 to every y-coordinate. This gives image vertices (−1, 4), (3, 4), (3, 7) and (−1, 7). The point (−1, 1) is not one of these: it has the correct new x-coordinate (1 − 2 = −1) but keeps the original y-coordinate (1) instead of adding 3, as if only the horizontal part of the vector had been applied.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (a) Kite — Method: check each named quadrilateral's properties against the three facts given, one at a time. Working: a kite has two pairs of adjacent sides equal (not opposite pairs), one pair of opposite angles equal (the two angles where an unequal pair of sides meet), and exactly one line of symmetry — matching all three facts. Options: a rhombus does have equal adjacent sides, but all four of its sides are equal, both pairs of its opposite angles are equal, and it has two lines of symmetry rather than exactly one; a parallelogram has its opposite sides equal rather than adjacent pairs, both pairs of opposite angles equal, and no line of symmetry at all; a trapezium does not generally have any pair of equal adjacent sides or a line of symmetry. Answer: kite.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (a) 3 cm² — Area scale factor = (linear scale factor)² = (1/4)² = 1/16. Area of T = 48 × 1/16 = 3 cm². (12 cm² comes from multiplying by the linear scale factor 1/4 directly, without squaring it; 24 cm² comes from taking the square root of the scale factor instead of squaring it; 768 cm² comes from squaring the reciprocal of the scale factor, 4, instead of the scale factor itself.)
- (c) 38° — The interior angles of a hexagon sum to (6 − 2) × 180° = 720°. 130° + 142° + 125° + 150° + 135° = 682°. x = 720° − 682° = 38°. A student who uses 6 × 180° instead of (6 − 2) × 180°, forgetting to subtract the 2, gets 1080° − 682° = 398°. A student who mis-adds the five given angles as 680° instead of 682° gets x = 720° − 680° = 40°. A student who answers with one of the given angles instead of solving for x might write 142°.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (d) (−4, −3) — The combined translation is the sum of the two column vectors, added component by component: top numbers 3 + (−7) = −4, bottom numbers −5 + 2 = −3, giving (−4, −3). (10, −7) subtracts the second vector from the first instead of adding them. (−4, 3) gets the top number right but makes a sign error on the bottom, treating −5 + 2 as +3. (4, −3) gets the bottom number right but makes a sign error on the top, treating 3 + (−7) as +4.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
Build your own mix at the worksheet builder.