Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) SAS, vertically opposite angle included — AE equals CE and BE equals DE give two pairs of equal sides, and angle AEB equals angle CED because they are vertically opposite angles formed where AC and BD cross; vertically opposite angles are always equal without needing to be measured. This included angle sits between the two known sides in each triangle, giving SAS, so 'SAS, vertically opposite angle included' is correct. 'ASA, vertically opposite angle at E' is wrong because ASA needs two pairs of equal angles with the side between them, but only one angle is known in each triangle here, and the two other known facts are sides, not angles. 'SSS, three equal side pairs' is wrong because only two pairs of sides are given; there is no third pair of equal sides. 'Cannot prove — no angle measured' is wrong because vertically opposite angles are always equal automatically when two straight lines cross, so no separate measurement is needed.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (b) Kite — Method: name a quadrilateral by matching what is given — which sides are equal, whether those equal sides lie next to each other or opposite each other, and whether any sides are parallel — against the definitions of the special quadrilaterals. Working: the two 6 cm sides meet at B and the two 9 cm sides meet at D, so each pair of equal sides is a pair of neighbours rather than a pair of opposites, and the stem rules out any parallel sides. The quadrilateral with two pairs of equal adjacent sides and no parallel sides is a kite. Answer: kite. The distractors: a rhombus is chosen by candidates who see two pairs of equal sides and read that as all four sides being equal, which the two different lengths of 6 cm and 9 cm rule out; a parallelogram is chosen by candidates who remember that a parallelogram has two pairs of equal sides but not that in a parallelogram the equal sides are the opposite ones, and who pass over the statement that nothing is parallel; an isosceles trapezium is chosen by candidates who notice that the shape is symmetrical about the line BD and treat symmetry on its own as the mark of a trapezium, when a trapezium needs a pair of parallel sides.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
- (c) 9 : 16 — Method: in similar solids the ratio of the surface areas is the square of the ratio of corresponding lengths. Working: the radii are in the ratio 3 : 4, so the surface areas are in the ratio 3² : 4² = 9 : 16. Answer: 9 : 16. The distractors: 27 : 64 is 3³ : 4³, the ratio of the volumes, which cubes the length ratio instead of squaring it; 3 : 4 leaves the length ratio untouched, as though surface area scaled in the same way as a length; 81 : 256 comes from squaring a second time, applying the rule to the ratio 9 : 16 rather than to the radii.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (c) 13 cm — Method: the two given sides meet at the right angle, so they are the shorter pair and the hypotenuse comes from Pythagoras' theorem, a² + b² = c². Working: c² = 5² + 12² = 25 + 144 = 169, so c = √169 = 13. Answer: 13 cm. The distractors: 17 cm comes from adding the two sides, 5 + 12, rather than adding their squares; 60 cm comes from multiplying them, 5 × 12, which is twice the area of the triangle and not a length; 7 cm comes from subtracting, 12 − 5, as though the hypotenuse were the difference of the two shorter sides.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
Build your own mix at the worksheet builder.