Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (b) AB = DE — RHS needs a right angle, the hypotenuse, and one OTHER side to be equal; the right angles and hypotenuses are already equal, so a matching pair of the remaining sides, AB = DE, completes RHS. Angle A = angle D is an extra ANGLE fact, not the extra SIDE fact that RHS specifically requires. AC being parallel to DF says nothing about either triangle's side lengths, so it cannot complete a congruence condition. Being drawn the same way up is about orientation on the page, not about any measurement, so it proves nothing about congruence.
- (d) A translation by the vector (8, 0) — Method: two reflections in PARALLEL lines combine into a single translation, perpendicular to the lines, of size twice the distance between them; two reflections in lines that CROSS combine into a rotation instead, never a translation. Working: the lines x = 2 and x = 6 are parallel, a distance of 6 − 2 = 4 apart. Doubling this distance gives 2 × 4 = 8, and the translation runs in the direction from the first line towards the second, so the vector is (8, 0). Answer: a translation by the vector (8, 0). Double the distance between the lines rather than using it directly, keep the direction running from the FIRST line reflected to the SECOND, and remember that two reflections in lines that never meet can only give a translation, never a rotation.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) 22 — Method: add the two drawn lengths together first, then apply the scale to the total. Working: 3 cm + 2.5 cm = 5.5 cm; 5.5 cm × 4 = 22 m. A student who answers 10 has only converted one of the two sections (2.5 cm × 4) and forgotten the other. A student who answers 5.5 has added the two drawn lengths but forgotten to apply the scale at all. A student who answers 44 has doubled the correct answer, effectively applying the scale twice. Answer: 22 m.
- (b) 45 cm² — Area scales with the square of the linear scale factor, and squaring a negative number gives a positive result: (−3)² = 9. The area of T is 5 × 9 = 45 cm². 15 cm² comes from multiplying the original area by the scale factor directly (5 × 3), without squaring. 9 cm² is the area scale factor itself, (−3)², with the multiplication by the original area 5 cm² left out. −15 cm² comes from multiplying 5 × (−3) and carrying the negative sign through, without squaring at all.
- (b) No — should divide by −2bc, not +2bc; sign is wrong. — Method: rearrange a² = b² + c² − 2bc cos A step by step and compare with the student's version. Working: subtracting b² + c² from both sides gives a² − b² − c² = −2bc cos A, then dividing both sides by −2bc gives cos A = (a² − b² − c²) / (−2bc), which is the same as cos A = (b² + c² − a²) / (2bc). The student divided by +2bc instead of −2bc, so their expression is the negative of the correct one — the verdict is No. Saying the algebra is fine because 'either sign order gives a valid result' ignores that only one of the two signed expressions matches the original equation. Saying the denominator should be bc rather than 2bc is a different, unrelated error — the coefficient 2bc in the original formula is correct and must stay.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (c) (10.5, −2) — Method: the vector from the first tile to the third tile is the pattern's vector doubled, since two translations happen between them. Working: doubling (4.5, −2.5) gives (9, −5); adding this to the starting corner (1.5, 3) gives x-coordinate 1.5 + 9 = 10.5 and y-coordinate 3 − 5 = −2. Answer: (10.5, −2). A candidate who only applies the vector once, translating to the second tile instead of the third, gets (6, 0.5). A candidate who adds 2.5 instead of subtracting it in the y-coordinate gets (10.5, 8). A candidate who doubles the x-part of the vector correctly but forgets to change the y-coordinate at all gets (10.5, 3).
- (d) (11, −2) — First undo the original translation to find the vertex on the original shape: (1 − (−8), 6 − 3) = (9, 3). Then apply the second vector to that original vertex: (9 + 2, 3 + (−5)) = (11, −2). (3, 1) comes from applying the second vector to the image point (1, 6) instead of to the original vertex — (1 + 2, 6 + (−5)) = (3, 1). (7, 8) comes from subtracting the second vector from the original vertex (9, 3) instead of adding it — (9 − 2, 3 − (−5)) = (7, 8). (11, 3) comes from applying only the x-component of the second vector to the original vertex and leaving the y-coordinate unchanged.
- (d) 6 cm — Method: CH cuts the triangle into two smaller right-angled triangles, so Pythagoras' theorem can be written in each of the three right-angled triangles and the results combined. Working: HB = 12 − 3 = 9 cm. In triangle ACH, CH² = AC² − 3² = AC² − 9; in triangle CHB, CH² = CB² − 9² = CB² − 81. Setting those equal gives AC² − 9 = CB² − 81. In triangle ABC, AC² + CB² = 12² = 144, so CB² = 144 − AC². Substituting gives AC² − 9 = 144 − AC² − 81, so 2 × AC² = 72 and AC² = 36, giving AC = 6. Answer: 6 cm. The distractors: 36 cm comes from stopping at AC² = 36 and never taking the square root; 9 cm is HB, the other part of the hypotenuse, written down in place of AC; 4 cm comes from working out 12 ÷ 3, treating AH as a scale factor between the two triangles rather than as a length.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
Build your own mix at the worksheet builder.