Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.
- (b) A right-angled triangle — The right angle at Y makes this a right-angled triangle, so that description is correct. Since XY is twice YZ, those two sides cannot be equal. The third side XZ is opposite the right angle, so it is the hypotenuse and is longer than either XY or YZ, so it cannot equal either of them. No two sides are equal, which rules out 'an isosceles triangle' and 'a right-angled isosceles triangle', both of which wrongly assume two equal sides. 'An equilateral triangle' would need all three sides equal, which contradicts XY being twice YZ, so it is wrong too.
- (a) 65° — OT and OC are both radii, so triangle OTC is isosceles with OT = OC, and its base angles are equal: angle OTC = angle OCT = (180° − 130°) ÷ 2 = 25°. A tangent is perpendicular to the radius at the point of contact, so angle OTP = 90°. Since C lies inside angle OTP, the chord TC splits this right angle into angle OTC and angle PTC, so angle PTC = angle OTP − angle OTC = 90° − 25° = 65°. Stopping after finding the base angle of the isosceles triangle, without subtracting it from the right angle at T, leaves 25° instead of the angle actually asked for. Adding the base angle to the right angle instead of subtracting it, 90° + 25° = 115°, reverses the direction the two angles combine in. Finding the sum of the two base angles of the isosceles triangle, 180° − 130° = 50°, and stopping there, gives another wrong value entirely.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (d) (9, −4) — Reflecting (1, 3) in the line x = 4 gives (2 × 4 − 1, 3) = (7, 3). Reflecting (7, 3) in the line y = 1 gives (7, 2 × 1 − 3) = (7, −1). Translating (7, −1) by the vector (2, −3) gives (7 + 2, −1 + (−3)) = (9, −4). Stopping after the two reflections and forgetting the translation gives (7, −1). Applying the translation's y-component with the wrong sign, adding 3 instead of subtracting it, gives (9, 2). Forgetting that the two reflections are centred on (4, 1) rather than the origin, and instead rotating (1, 3) by 180° about the origin to (−1, −3) before translating, gives (1, −6). Do all three steps in order, each one correctly, and the final image is (9, −4).
- (c) (−3, 1) — Method: for an enlargement about a centre, first find the vector from the centre to the point, multiply it by the scale factor, INCLUDING its sign, then add the result back onto the centre. Working: the vector from the centre (1, 1) to A(3, 1) is (3 − 1, 1 − 1) = (2, 0). Multiplying by the scale factor −2 gives −2 × 2 = −4 and −2 × 0 = 0, so the scaled vector is (−4, 0). Adding this to the centre gives 1 + (−4) = −3 and 1 + 0 = 1, so the image is (−3, 1). Answer: (−3, 1). A NEGATIVE scale factor keeps its sign all the way through the calculation: do not treat −2 as +2, and do not treat it as a fraction like 1/2, which is the rule for a scale factor between 0 and 1, not a negative one. Always measure the vector from the CENTRE of enlargement, never from the origin, unless the two happen to coincide.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (b) 80° — Method: opposite angles of a cyclic quadrilateral sum to 180°, so form and solve an equation for x, then substitute back to find angle DAB. Working: (2x + 10) + (3x − 5) = 180, so 5x + 5 = 180, x = 35, and angle DAB = 2(35) + 10 = 80°. Using 360° instead of 180° as the total (as if the two angles were the whole circle rather than a pair of opposite angles) gives x = 71 and angle DAB = 152°; solving correctly for x but reporting x itself instead of substituting it back into 2x + 10 gives 35°; and mishandling the signs when combining the two expressions, using (2x + 10) + (3x + 5) = 180 instead of (2x + 10) + (3x − 5) = 180, gives x = 33 and angle DAB = 76°. Opposite angles of a cyclic quadrilateral — not adjacent ones — are the pair that sums to 180°.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (d) y = 2 — Two reflections in perpendicular lines that cross at a point combine to a 180° rotation about that point. The line x = 3 is vertical, so the second line must be horizontal, and it must pass through the centre of rotation (3, 2) — that line is y = 2. Taking the y-coordinate of the centre but writing it against the wrong letter gives y = 3. Assuming the second line must also be vertical, like the first one, and just swapping in the other coordinate gives x = 2. Reaching for the standard mirror line y = x without checking that it actually passes through (3, 2) gives y = x — it does not pass through that point at all. The line that is both perpendicular to x = 3 and through (3, 2) is y = 2.
- (b) $\binom{-6}{10}$ — Translating twice by the same vector doubles both components: 2 × $\binom{-3}{5}$ = $\binom{-6}{10}$. $\binom{-3}{5}$ forgets to double the vector at all, giving only one translation's worth. $\binom{-9}{15}$ trebles the vector instead of doubling it. $\binom{-6}{5}$ doubles only the top number and forgets to double the bottom number.
- (a) A square's diagonals are equal in length — A square has two pairs of parallel sides, four equal sides, and diagonals that are equal in length and cross at right angles. This tile's diagonals are not equal, so it is a rhombus that is not a square.
- (a) (4, −4) — A point is invariant under a reflection only if it lies exactly on the mirror line. The line y = −x consists of every point where the y-coordinate is the negative of the x-coordinate: (4, −4) satisfies this, since −4 = −(4), so it is invariant. (5, 5) lies on the line y = x, a different line altogether, not y = −x. (4, 4) has equal coordinates, but that alone does not put it on y = −x; it would need y = −4, not 4. (−4, −4) also has equal coordinates and lies on y = x, not y = −x — its coordinates would need opposite signs to sit on the given mirror line. Only a point whose coordinates are negatives of each other stays fixed under this reflection.
Build your own mix at the worksheet builder.