Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) Two angles and one side are known; x is another side — The sine rule needs a matching pair, a side and the angle opposite it, that you already know, so you can set up a ratio with the unknown. When two angles and one side are known, you can find the third angle from the angle sum, giving you an angle opposite the known side and an angle opposite x: the sine rule applies directly. When all three sides are known and x is an angle, there is no side-angle pair available at all, so the cosine rule, rearranged for an angle, is what's needed instead. When two sides and the included angle are known and x is the third side, again there is no matching side-angle pair yet, so the cosine rule finds the third side directly. When two sides and the included angle are known and x is one of the other angles, you still have no side-angle pair to start from — the cosine rule has to be used first, to find the third side, before any angle can be found. Only the two-angles-and-a-side case hands you a ready-made pair, which is exactly what the sine rule needs.
- (b) 128° — Angle AOC and angle ABC stand on the same arc AC (the minor arc, which does not contain B), so by the angle at the centre theorem angle ABC = 104° ÷ 2 = 52°. ABCD is a cyclic quadrilateral, so its opposite angles ABC and ADC sum to 180°: angle ADC = 180° − 52° = 128°. A candidate who finds angle ABC = 52° correctly but then treats opposite angles as equal, as in a parallelogram, instead of supplementary, writes down 52° and stops there. Skipping the halving step and using 104° as angle ABC gives 180° − 104° = 76°. Reading off the given centre angle itself as the final answer, without applying either theorem, gives 104°. Work through both theorems in order and you land on 128°.
- (d) y = 2 — Two reflections in perpendicular lines that cross at a point combine to a 180° rotation about that point. The line x = 3 is vertical, so the second line must be horizontal, and it must pass through the centre of rotation (3, 2) — that line is y = 2. Taking the y-coordinate of the centre but writing it against the wrong letter gives y = 3. Assuming the second line must also be vertical, like the first one, and just swapping in the other coordinate gives x = 2. Reaching for the standard mirror line y = x without checking that it actually passes through (3, 2) gives y = x — it does not pass through that point at all. The line that is both perpendicular to x = 3 and through (3, 2) is y = 2.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (c) 1 — sin 30° = 1/2 and cos 60° = 1/2, so sin 30° + cos 60° = 1/2 + 1/2 = 1. 0 comes from subtracting the two values instead of adding them (1/2 − 1/2). 1/2 comes from writing down only one of the two exact values and forgetting to add the other. √3 comes from swapping the two angles and working out sin 60° + cos 30° = √3/2 + √3/2 = √3.
- (b) £33.60 — The area of the parallelogram flower bed is base × height = 3.5 × 2 = 7 m². The cost is 7 × £4.80 = £33.60. £16.80 comes from using the triangle formula instead of the parallelogram formula: 3.5 × 2 = 7, and half of 7 is 3.5 m², then 3.5 × £4.80 = £16.80. £26.40 comes from adding the base and height, 3.5+2 = 5.5, instead of multiplying them, then multiplying by £4.80. £7.00 correctly finds the area, 7 m², but forgets to multiply it by the cost per m².
- (b) (12, 9) — Apply the transformations in the order given: first translate, then enlarge. Translating (3, 5) by the vector (1, −2) gives (3 + 1, 5 − 2) = (4, 3). Enlarging this by scale factor 3 about the origin multiplies both coordinates by 3: (4 × 3, 3 × 3) = (12, 9). Enlarging first and translating afterwards reverses the order and gives (3 × 3 + 1, 5 × 3 − 2) = (10, 13), a different point because the two transformations do not commute. Enlarging the original point by scale factor 3 while forgetting to translate it at all gives (3 × 3, 5 × 3) = (9, 15). Reversing the signs of the translation vector before applying it gives (3 − 1, 5 + 2) = (2, 7), which then enlarges to (2 × 3, 7 × 3) = (6, 21).
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (a) 18 — PQ lies along the x-axis with length 9, and PR lies along the y-axis with length 4, and these two sides meet at right angles at P, so they can be used as the base and height of the triangle. Area = 1/2 × base × height = 1/2 × 9 × 4 = 18. 36 comes from multiplying the base and height but forgetting to halve the result. 13 comes from adding the two lengths, 9 + 4, instead of multiplying them. 26 comes from the perimeter-style calculation 2 × (9 + 4) instead of the triangle area formula.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (d) 16 — Method: use the scale to find the real length and width separately, then use the perimeter formula. Working: real length = 4 cm × 125 = 500 cm = 5 m; real width = 2.4 cm × 125 = 300 cm = 3 m; perimeter = 2 × (5 + 3) = 16 m. A student who answers 8 has added the real length and width but forgotten to double the total for the perimeter. A student who answers 1600 has correctly worked out the perimeter in centimetres but forgotten to convert it to metres. A student who answers 500 has only converted the length to real centimetres and stopped there, ignoring the width and the perimeter step. Answer: 16 m.
- (c) 24 cm² — Method: the front elevation of a cuboid is a rectangle formed by the cuboid's length and its height, so its area is length × height. Working: 6 cm × 4 cm = 24 cm². Answer: 24 cm². The distractors: 12 cm² comes from using width × height (3 × 4) instead of length × height, mistaking the side elevation's dimensions for the front's. 18 cm² comes from using length × width (6 × 3), which gives the area of the plan view instead of the front elevation. 20 cm² comes from finding the perimeter of the front face instead of its area: 2 × (6 + 4) = 20.
Build your own mix at the worksheet builder.