Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 6√3 m — The horizontal distance covered by one support is adjacent to the 30° angle, so it equals 6 × cos 30° = 6 × √3/2 = 3√3 m. The total base width is made up of both supports, so it is 2 × 3√3 = 6√3 m. '3√3 m' gives only one support's horizontal distance and forgets to double it for the total width. '6 m' comes from using sin 30° instead of cos 30° for the horizontal distance (6 × sin 30° = 3, doubled to 6). '12 m' comes from doubling the full sloping length of 6 m without using any trigonometry at all.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (b) 25 cm² — Method: a square has four equal sides, so divide the perimeter by 4 to recover the side length, then square that side to get the area. Working: 20 ÷ 4 = 5 cm, then 5 × 5 = 25. Answer: 25 cm². The distractors: 400 cm² comes from squaring the perimeter itself, 20 × 20, treating the 20 cm as though it were the side length; 100 cm² comes from dividing the perimeter by 2 rather than by 4, giving a side of 10 cm, and squaring that; 5 cm is the side length, from stopping as soon as the perimeter has been divided by 4 and never squaring it, which also leaves a length where an area was asked for.
- (c) 72° — Method: opposite angles in a cyclic quadrilateral always sum to 180°. Working: angle DAB and angle BCD are opposite angles of the cyclic quadrilateral ABCD, so angle BCD = 180 − 108 = 72 degrees. Answer: 72°. Opposite angles in a cyclic quadrilateral are SUPPLEMENTARY, not equal, so do not simply copy the given angle; and do not subtract from 360°, which is the rule for angles round a point, or confuse this with the angle-in-a-semicircle theorem, which gives a fixed 90° that has nothing to do with this quadrilateral.
- (c) A↔N, B↔L, C↔M (ABC≅NLM) — Matching equal side lengths: AB (8 cm) equals NL (8 cm), BC (10 cm) equals LM (10 cm), and CA (6 cm) equals MN (6 cm). This gives the correspondence A with N, B with L, and C with M, so triangle ABC is congruent to triangle NLM, making 'A↔N, B↔L, C↔M (ABC≅NLM)' correct. 'A↔L, B↔M, C↔N (ABC≅LMN)' simply matches the vertices in the order they are written without checking the side lengths: AB (8 cm) would need to equal LM (10 cm), which is false. 'A↔M, B↔N, C↔L (ABC≅MNL)' also fails this check, since AB (8 cm) would need to equal MN (6 cm), which is false. 'A↔N, B↔M, C↔L (ABC≅NML)' gets A correct but swaps B and C, so AB (8 cm) would need to equal NM (6 cm), which is also false.
- (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
- (a) 2 — Gradient = (change in y) ÷ (change in x) = (11 − 3) ÷ (6 − 2) = 8 ÷ 4 = 2. "0.5" comes from dividing the change in x by the change in y the wrong way round: 4 ÷ 8. "8" is only the change in y, forgetting to divide by the change in x at all. "−2" comes from a sign error, as if the y-coordinate had decreased rather than increased.
- (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (d) 240 cm² — Method: the area of a parallelogram is base × perpendicular height, and the perpendicular height is not the sloping side, so it must be found first from the right-angled triangle. Working: the sloping side is the hypotenuse, so the height squared is 13² − 5² = 169 − 25 = 144, giving a height of √144 = 12 cm; then 20 × 12 = 240. Answer: 240 cm². The distractors: 260 cm² comes from using the 13 cm sloping side as the height, 20 × 13, without going through the right-angled triangle at all; 120 cm² comes from finding the height of 12 cm correctly and then halving the product, (20 × 12) ÷ 2, which is the rule for a triangle and not for a parallelogram; 100 cm² comes from using the 5 cm along the base as the height, 20 × 5.
- (a) 7 — Rearranging F + V − E = 2 gives F = 2 − V + E = 2 − 10 + 15 = 7. A candidate who works out E − V without the +2, giving 15 − 10, answers 5. A candidate who rearranges with a sign error, working out 2 + V − E = 2 + 10 − 15 = −3 and then drops the negative sign, answers 3. A candidate who adds all three numbers together, V + E + 2 = 10 + 15 + 2, answers 27, having used the wrong operation entirely. The correct number of faces is 7.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
Build your own mix at the worksheet builder.