Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (−2, −1) — Method: apply the reflection to the point first, then rotate the image about the given centre, in the order the question states them. Working: reflecting (3, 4) in the line y = 1 keeps x = 3 and puts the image as far below the line as the point is above it: 4 is 3 units above y = 1, so the image is 3 units below, at 1 − 3 = −2 (the same as 2 × 1 − 4 = −2). The reflected point is (3, −2). Rotating (3, −2) by 90° clockwise about (1, 1): subtracting the centre gives 3 − 1 = 2 and −2 − 1 = −3, the clockwise rule swaps and negates these to give −3 and −2, and adding the centre back gives 1 + (−3) = −2 and 1 + (−2) = −1. The final image is (−2, −1). Answer: (−2, −1). Reflect before you rotate, exactly as the design process is described, and rotate about the CENTRE (1, 1) given in the question rather than the origin: either mistake, or reversing the two steps, sends the tile to a different point.
- (d) 5 — Method: since the triangles are congruent by SAS, the corresponding sides AB and DE must be equal, because both are the side next to the given right angle that is not BC or EF. Working: AB = DE gives 2x + 3 = 13, so 2x = 10, so x = 5. Options: 10 comes from dropping the coefficient of x and solving x + 3 = 13 instead of 2x + 3 = 13; 4 comes from matching AB to the wrong side, EF, giving 2x + 3 = 11, so 2x = 8, so x = 4; 8 comes from a sign error, solving 2x − 3 = 13 instead of 2x + 3 = 13, giving 2x = 16, so x = 8. Answer: 5.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (a) a rounded rectangle: 5 m by 4 m with semicircular ends — Points within 2 m of the straight part of the fence form a rectangle running the 5 m length of the fence and 4 m wide (2 m on each side); points within 2 m of each END of the fence, beyond that rectangle, form a semicircle of radius 2 m there, since the nearest point of the fence to them is just that one end. Together this gives a rounded, stadium-shaped region. "a rectangle, 9 m by 4 m" extends the rectangle by 2 m at each end instead of rounding it, wrongly including corner points that are actually more than 2 m from every part of the fence. "a circle of radius 2 m" treats the whole 5 m fence as a single point. "a rectangle, 5 m by 2 m" uses 2 m as the full width instead of the distance on EACH side, so it only covers one side of the fence.
- (a) 9 — A cube has 9 planes of symmetry in total: 3 that pass through the middles of pairs of opposite faces, and 6 more that pass through pairs of opposite edges diagonally. A candidate who counts only the 3 face-to-face planes — which is correct for a cuboid with three different edge lengths, but forgets that a cube's equal edges create 6 more diagonal planes — answers 3. A candidate who counts only the 6 diagonal planes and forgets the 3 face-to-face ones answers 6. A candidate who confuses the number of planes of symmetry with the number of edges on a cube answers 12. The correct total for a cube is 9.
- (d) No — angles must be equal too — A regular polygon must have both all sides equal and all angles equal. This tile has all six sides equal, but its interior angles are not all equal, so it fails the angle condition and is not regular — 'No — angles must be equal too' is correct. 'Yes — all sides are equal' is wrong because equal sides alone are not enough; a shape can have equal sides but unequal angles, as here. 'Yes — six equal sides means regular' is wrong for the same reason: equal sides do not automatically guarantee equal angles. 'No — hexagons can't be regular' is wrong because regular hexagons certainly exist (six equal sides and six equal 120° angles); it is this particular tile that fails to be regular, not hexagons in general.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
Build your own mix at the worksheet builder.