Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (c) exterior angle = sum of the two interior opposite angles — Angle ACD is the exterior angle at C, and the exterior angle of a triangle is always equal to the sum of the two interior angles at the other two vertices — here, angle BAC and angle ABC — so angle ACD = 48° + 67° = 115°. "angles in a triangle add up to 180°" is a true fact, but on its own it only gives the INTERIOR angle at C (180 − 48 − 67 = 65°), not the exterior angle 115° — reaching 115° that way still needs a further step. "angles on a straight line add up to 180°" is the fact that links the interior and exterior angles at C to each other, not the fact that gives 115° directly from the two OTHER angles. "exterior angle is always double the smallest angle" is not a genuine angle fact: double the smallest angle here is 48° × 2 = 96°, not 115°.
- (b) 4 : 9 — The heights are in the ratio 4 : 6, which simplifies to 2 : 3. For similar solids, area scales with the square of the length ratio, so the surface area ratio is 2² : 3² = 4 : 9. 2 : 3 is just the simplified length ratio, before squaring has been done. 8 : 27 comes from cubing the ratio (2³ : 3³) instead of squaring it — that's the rule for volumes, not areas. 9 : 4 has the correct squared values but in the wrong order, giving the larger tin's area first instead of the smaller.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (b) 68° — Method: two properties are needed. Angle A and angle D are co-interior angles between the parallel sides AB and DC, so they add up to 180°; and because the trapezium is isosceles, the two angles on the side AB are equal, so angle B = angle A. Working: angle A = 180° − 112° = 68°, and angle B = angle A = 68°. Answer: 68°. The distractors: 112° comes from assuming that angles B and D are equal, which is the property of a parallelogram, not of a trapezium; 90° comes from assuming that the angles on the other parallel side must be right angles; 248° comes from using the 360° angle sum of a quadrilateral and taking away only the one angle that is given.
- (c) 140° — Method: OAPB is a quadrilateral whose angles sum to 360°; the tangent-radius angles at A and B are each 90°, and angle APB is given, so angle AOB is whatever is left. Working: angle OAP = angle OBP = 90°, so angle AOB = 360 − 90 − 90 − 40 = 140 degrees. Answer: 140°. Both tangent-radius angles are 90° each and must both be subtracted, not just one, and the quadrilateral's angles sum to 360°, not 180°: do not assume angle AOB simply matches angle APB, which is a different angle in a different part of the figure.
- (b) angle B = angle E — AB and BC meet at vertex B, so the angle INCLUDED between them is angle B; making angle B = angle E completes SAS. Angle A sits between AB and AC, not between AB and BC, so it is not the included angle needed for SAS here. Angle C sits between BC and CA, not between AB and BC, so it is not included either. AC = DF would give a third pair of equal sides, which proves congruence by SSS instead of SAS.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (b) (3, −3) — Subtracting column vectors means subtracting the top numbers and subtracting the bottom numbers, in the order given: top = 5 − 2 = 3, bottom = 1 − 4 = −3, giving (3, −3). A candidate who works out v − u instead of u − v, reversing the order, gets (−3, 3). A candidate who makes a sign error on the bottom number, treating 1 − 4 as 3 instead of −3, gets (3, 3). A candidate who adds the vectors instead of subtracting gets (7, 5). Because the question asks for u − v, not v − u, the correct answer is (3, −3).
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (d) Base angles of an isosceles triangle are equal — DE = DF, so triangle DEF is isosceles with DE and DF as the two equal sides. The base angles opposite those equal sides, angle E and angle F, are therefore equal to each other. Angle F = 58°. A student who instead quotes 'Angles in a triangle sum to 180°' has picked a true fact about triangles, but that fact finds a missing angle from the other two — it does not explain why two angles are equal to each other. A student who quotes 'Angles on a straight line sum to 180°' has confused this with a straight-line angle fact, but no straight line of angles is described in this triangle.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
Build your own mix at the worksheet builder.