Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) (−14, 5) — To undo a composition, reverse the order and invert each transformation: undo the rotation first, then undo the translation. The inverse of 'rotate 90° clockwise about the origin' is 'rotate 90° anticlockwise about the origin', which maps (x, y) to (−y, x); applied to (3, 9) this gives (−9, 3). Then undo the translation by subtracting the vector (5, −2), i.e. adding (−5, 2): (−9 − 5, 3 + 2) = (−14, 5). Undoing the two inverse steps in the same order as the original composition, rather than reversing it, gives (−11, −2). Rotating 90° clockwise again instead of inverting the rotation's direction gives (4, −1). Adding the translation vector again instead of subtracting it, after correctly inverting the rotation, gives (−4, 1).
- (b) 12 cm — Method: the area of a rectangle is one side multiplied by the other, so when the area and one side are known the other side is found by reversing that multiplication — divide the area by the side that is known. Working: 96 ÷ 8 = 12. Answer: 12 cm. The distractors: 88 cm comes from 96 − 8, subtracting the known side as though the area had been made by adding the two sides together; 768 cm comes from 96 × 8, running the area rule forwards on the two numbers given instead of reversing it; 40 cm comes from reading the 96 as a perimeter — halving it to 48 and taking the 8 cm side away — which reverses the perimeter rule rather than the area rule.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (b) −2 — The gradient of the original line is (6 − 2) ÷ (3 − 1) = 4 ÷ 2 = 2. Reflecting in the x-axis sends every y-coordinate to its negative, which flips the sign of the gradient: the image line has gradient −2. Translating by (2, 0) is a horizontal shift, which does not change the line's steepness or direction at all, so the gradient stays at −2. Assuming the gradient is unaffected by the reflection gives 2, the original gradient carried straight through. Thinking a reflection in the x-axis turns a gradient into its positive reciprocal gives 1/2. Combining that same wrong idea with the sign flip from the reflection gives −1/2. Only the sign flips, from the reflection, and translating never changes a gradient at all, so the answer is −2.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (a) 71° — Method: first use the straight line through T to find the tangent-chord angle RTC, then apply the alternate segment theorem, which states that this angle equals the angle subtended by the chord in the alternate segment. Working: the two rails form a straight line through T, so angle RTC = 180 − 109 = 71 degrees. D lies in the alternate segment of the chord TC, so angle TDC = angle RTC = 71°. Answer: 71°. Find angle RTC FIRST from the straight line before applying the theorem: using the given 109° directly, doubling the tangent-chord angle, or taking its complement from 90° all give the wrong angle at D.
- (a) 90° — Method: the angle in a semicircle theorem states that the angle subtended at the circumference by a diameter is always a right angle, whatever the circle's size. Working: since AC is a diameter, the angle ABC subtended at the circumference by AC is 90 degrees, regardless of the circle's radius. Answer: 90°. This result holds for every position of B on the circle and for every size of circle, so no length or radius is ever needed: do not confuse angle ABC with the straight angle along the diameter itself, which is 180°, and do not halve the right angle again.
- (d) 600 cm² — Enlarging by scale factor 2 makes the new dimensions 10 × 2 = 20 cm and 15 × 2 = 30 cm, so the poster's area = 20 × 30 = 600 cm². A pupil who scales the original area, 150 cm², by the scale factor itself instead of by its square gets 150 × 2 = 300 cm². A pupil who adds the scale factor to each dimension instead of multiplying gets (10 + 2) × (15 + 2) = 204 cm². A pupil who forgets to enlarge the postcard at all just uses the original area, 150 cm². The correct area of the poster is 600 cm².
- (b) (5, −3) — Method: rotate the point about the given centre first, then translate the image, in the stated order. Working: rotating (0, 2) by 180° about (2, 2) uses the rule (x, y) → (4 − x, 4 − y), since the centre doubles in each coordinate. This gives 4 − 0 = 4 and 4 − 2 = 2, so (0, 2) maps to (4, 2). Translating (4, 2) by the vector (1, −5) gives 4 + 1 = 5 and 2 − 5 = −3, so the final image is (5, −3). Answer: (5, −3). Rotate about the centre GIVEN in the question, (2, 2), not about the origin, and translate the rotated image afterwards, in that order: rotating about the wrong centre, swapping the order, or stopping after one step all give a different point.
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (c) a + (1/2)c — Method: OABC is a parallelogram, so OB = OA + AB, and since AB is equal and parallel to OC, AB = c; this gives OB = a + c. M is the midpoint of AB, so AM = (1/2)AB = (1/2)c. Working: OM = OA + AM = a + (1/2)c. Answer: OM = a + (1/2)c. Adding the whole of AB instead of half of it gives a + c, which is OB, not OM; halving the whole diagonal OB instead of just AB gives (1/2)a + (1/2)c, the midpoint of OB rather than of AB; and flipping the sign on the c-term gives a − (1/2)c, which points back the wrong way along AB. Halve only the side you are told to halve, and check the sign before you commit to an answer.
Build your own mix at the worksheet builder.