Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 1 : 8 — Method: in similar solids the ratio of the volumes is the cube of the ratio of corresponding lengths. Working: the heights are in the ratio 1 : 2, so the volumes are in the ratio 1³ : 2³ = 1 : 8. Answer: 1 : 8. The distractors: 1 : 2 leaves the height ratio unchanged, as though a volume scaled in the same way as a length; 1 : 4 comes from squaring, 1² : 2², which is the rule for surface areas and not for volumes; 1 : 6 comes from multiplying each part by 3 instead of raising each part to the power 3.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (c) (1/2)c − a — Method: in parallelogram OABC, AB is equal and parallel to OC, so AB = c; M is the midpoint of AB, so AM = (1/2)c and OM = OA + AM = a + (1/2)c. MC runs from M to C, so MC = OC − OM. Working: MC = c − (a + (1/2)c) = (1/2)c − a. Answer: MC = (1/2)c − a. Subtracting in the wrong order gives a − (1/2)c, the same vector pointing the opposite way, from C to M rather than M to C; forgetting to halve the c-term gives c − a, which is AC, not MC; and adding instead of subtracting gives (1/2)c + a, which is OM itself. Always subtract the vector for the START of the journey, OM, from the vector for its END point, OC — and keep the fraction from the halving step.
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (a) 250° — The back bearing (the bearing of A from B) differs from the bearing of B from A by exactly 180°. Because the given bearing, 070°, is less than 180°, add 180°: 070 + 180 = 250°, so the bearing of A from B is 250°. Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 110° comes from subtracting 180° from 070° and dropping the negative sign (070 − 180 = −110) instead of adding 180°. Choosing 160° comes from adding only 90° instead of 180° (070 + 90 = 160).
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (b) segment — The region enclosed between a chord and the arc it cuts off is called a segment. A sector is the different region already named in the question, enclosed by the two radii and the arc, not by the chord. A tangent is a straight line that touches the circle at one point, not an enclosed region at all. The circumference is the total distance around the whole circle, a length, not a region.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (b) (2, 3) — Applying A first: reflecting (2, 1) in the x-axis gives (2, −1). Applying B to that image: translating (2, −1) by (0, 4) gives (2, −1 + 4) = (2, 3). Applying the transformations in the opposite order — B first, then A — gives a different result: (2, 1) translates to (2, 5), which then reflects to (2, −5); this shows that the order genuinely matters here. Applying only A and stopping there, without the translation, gives (2, −1). Applying only B and stopping there, without the reflection, gives (2, 5). Do both transformations, in the order A then B, and the image of P is (2, 3).
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (b) 21 — Both legs of the journey are on the same bearing, 070°, so the ship travels in one straight line the whole way and the distances simply add: 12 + 9 = 21 km. A candidate who subtracts instead of adding gets 12 − 9 = 3 km. A candidate who multiplies the two distances gets 12 × 9 = 108. A candidate who assumes the ship changed direction and treats the two legs as the sides of a right-angled triangle works out √(12² + 9²) = √225 = 15 km — but the bearing does not change, so there is no triangle and no hypotenuse to find. Because the ship stays on one straight line, the total distance is 21 km.
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
Build your own mix at the worksheet builder.