Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
- (c) (−3, 1) — Method: for an enlargement about a centre, first find the vector from the centre to the point, multiply it by the scale factor, INCLUDING its sign, then add the result back onto the centre. Working: the vector from the centre (1, 1) to A(3, 1) is (3 − 1, 1 − 1) = (2, 0). Multiplying by the scale factor −2 gives −2 × 2 = −4 and −2 × 0 = 0, so the scaled vector is (−4, 0). Adding this to the centre gives 1 + (−4) = −3 and 1 + 0 = 1, so the image is (−3, 1). Answer: (−3, 1). A NEGATIVE scale factor keeps its sign all the way through the calculation: do not treat −2 as +2, and do not treat it as a fraction like 1/2, which is the rule for a scale factor between 0 and 1, not a negative one. Always measure the vector from the CENTRE of enlargement, never from the origin, unless the two happen to coincide.
- (c) (1/2)c − a — Method: in parallelogram OABC, AB is equal and parallel to OC, so AB = c; M is the midpoint of AB, so AM = (1/2)c and OM = OA + AM = a + (1/2)c. MC runs from M to C, so MC = OC − OM. Working: MC = c − (a + (1/2)c) = (1/2)c − a. Answer: MC = (1/2)c − a. Subtracting in the wrong order gives a − (1/2)c, the same vector pointing the opposite way, from C to M rather than M to C; forgetting to halve the c-term gives c − a, which is AC, not MC; and adding instead of subtracting gives (1/2)c + a, which is OM itself. Always subtract the vector for the START of the journey, OM, from the vector for its END point, OC — and keep the fraction from the halving step.
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (d) (−2, 0) — A 180° rotation about a centre (a, b) maps (x, y) to (2a − x, 2b − y). Here that gives (2 × 1 − 4, 2 × 1 − 2) = (−2, 0). A pupil who rotates about the origin instead of (1, 1) gets (−4, −2). A pupil who adds the centre's coordinates instead of applying the rotation formula gets (4 + 1, 2 + 1) = (5, 3). A pupil who just subtracts the centre's coordinates from E's, without doubling and reversing, gets (4 − 1, 2 − 1) = (3, 1). The correct image is (−2, 0).
- (a) 1 : 8 — Method: in similar solids the ratio of the volumes is the cube of the ratio of corresponding lengths. Working: the heights are in the ratio 1 : 2, so the volumes are in the ratio 1³ : 2³ = 1 : 8. Answer: 1 : 8. The distractors: 1 : 2 leaves the height ratio unchanged, as though a volume scaled in the same way as a length; 1 : 4 comes from squaring, 1² : 2², which is the rule for surface areas and not for volumes; 1 : 6 comes from multiplying each part by 3 instead of raising each part to the power 3.
- (a) 245 m² — Method: for similar figures the ratio of the areas is the square of the ratio of the lengths, so multiply the smaller area by the square of the length scale factor. Working: the length scale factor is 7 ÷ 3, so the area scale factor is 49 ÷ 9, and the larger area is 45 × 49 ÷ 9 = 5 × 49 = 245. Answer: 245 m². The distractors: 105 m² comes from multiplying by the length scale factor 7 ÷ 3 instead of by its square, the commonest slip on this topic; 315 m² comes from multiplying by 7 and forgetting to divide by 3; 405 m² comes from multiplying by 3² = 9, squaring the wrong part of the ratio.
- (d) (2/5)a + (3/5)b — Method: OP = OA + AP, and since AP : PB = 3 : 2 splits AB into 5 equal parts, AP is 3/5 of the whole of AB, with AB = b − a. Working: OP = a + 3/5(b − a) = a − (3/5)a + (3/5)b = (2/5)a + (3/5)b. Answer: OP = (2/5)a + (3/5)b. Using the ratio the wrong way round, as though it read AP : PB = 2 : 3, gives (3/5)a + (2/5)b; adding (3/5)b onto the whole of a without subtracting a inside the bracket first gives a + (3/5)b; and treating the ratio as 1 : 1 gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from A, matching the ORDER the ratio is stated in, and subtract before you scale.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (b) 10 — Corresponding angles are equal, so 5x + 4 = 3x + 24. Subtracting 3x from both sides gives 2x + 4 = 24, then subtracting 4 gives 2x = 20, so x = 10. 14 comes from adding the constants, 4 + 24, instead of subtracting them when rearranging. 19 comes from treating the angles as co-interior (summing to 180°): 5x + 4 + 3x + 24 = 180 gives 8x = 152, so x = 19. 20 correctly reaches 2x = 20 but stops without dividing by 2.
- (a) 60° — Method: the angles of a triangle add up to 180°, so add the three expressions, solve for x and then substitute back into the expression for angle B. Working: 2x + 3x + 4x = 9x, so 9x = 180 and x = 20. Angle B is 3x, so angle B = 3 × 20 = 60. Answer: 60°. The distractors: 20° is the value of x, from stopping as soon as the equation is solved instead of substituting back; 120° comes from using 360° as the angle sum, which gives x = 40 and 3x = 120; 80° is 4x, the angle at C, from substituting into the wrong expression.
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
Build your own mix at the worksheet builder.