Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 5 hours — The distance from the origin to (7, 24) is √(7² + 24²) = √(49 + 576) = √625 = 25 km. Travelling at 5 km per hour, the time taken is 25 ÷ 5 = 5 hours. 25 hours mistakes the distance itself for the time, forgetting to divide by the speed. 125 hours comes from multiplying the distance by the speed, 25 × 5, instead of dividing. 0.2 hours comes from dividing the speed by the distance, 5 ÷ 25, the wrong way round.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (d) (−4, −3) — The combined translation is the sum of the two column vectors, added component by component: top numbers 3 + (−7) = −4, bottom numbers −5 + 2 = −3, giving (−4, −3). (10, −7) subtracts the second vector from the first instead of adding them. (−4, 3) gets the top number right but makes a sign error on the bottom, treating −5 + 2 as +3. (4, −3) gets the bottom number right but makes a sign error on the top, treating 3 + (−7) as +4.
- (d) (4, −2) — Method: apply the rotation to the point first, then reflect the rotated image, in the order stated. Working: rotating (4, 2) by 90° anticlockwise about the origin sends (x, y) to (−y, x), so (4, 2) becomes (−2, 4). Reflecting (−2, 4) in the line y = x swaps its coordinates, giving (4, −2). Answer: (4, −2). Rotate before you reflect, exactly as the question orders them: these two maps do not commute, so reflecting first, only rotating without swapping the coordinates afterwards, or forgetting to negate the coordinate when rotating anticlockwise all send you to a different point.
- (c) Pentagonal pyramid — Method: a pyramid has one base and triangular faces that all meet at a single apex; the base shape gives the pyramid its name. Working: the base is a pentagon and the other five faces are triangles meeting at one point, so this is a pyramid with a pentagon base. A student who answers pentagonal prism has confused a pyramid, whose sloping faces meet at an apex, with a prism, which has two identical parallel faces. A student who answers hexagonal pyramid has miscounted the base as having 6 sides instead of 5. A student who answers triangular pyramid has misread the five triangular side faces as meaning the base itself is a triangle. Answer: pentagonal pyramid.
- (a) 1260° — The sum of the interior angles of a polygon with n sides is (n − 2) × 180°. For a nonagon, n = 9, so the sum is (9 − 2) × 180° = 7 × 180° = 1260°. 1620° uses 9 × 180° without subtracting 2 from n first. 140° is the size of a single interior angle of a regular nonagon (1260° ÷ 9), not the sum of all nine. 1440° uses (n − 1) × 180° = 8 × 180° instead of (n − 2) × 180°.
- (b) (−2, −1) — Method: apply the reflection to the point first, then rotate the image about the given centre, in the order the question states them. Working: reflecting (3, 4) in the line y = 1 keeps x = 3 and puts the image as far below the line as the point is above it: 4 is 3 units above y = 1, so the image is 3 units below, at 1 − 3 = −2 (the same as 2 × 1 − 4 = −2). The reflected point is (3, −2). Rotating (3, −2) by 90° clockwise about (1, 1): subtracting the centre gives 3 − 1 = 2 and −2 − 1 = −3, the clockwise rule swaps and negates these to give −3 and −2, and adding the centre back gives 1 + (−3) = −2 and 1 + (−2) = −1. The final image is (−2, −1). Answer: (−2, −1). Reflect before you rotate, exactly as the design process is described, and rotate about the CENTRE (1, 1) given in the question rather than the origin: either mistake, or reversing the two steps, sends the tile to a different point.
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (b) An enlargement, centre O, scale factor −1/2. — A single enlargement with a negative scale factor both changes the size (by the magnitude of the factor) and rotates the image 180° about the centre (giving the inverted orientation) in one transformation. Halving the size needs a magnitude of 1/2, and inverting needs a negative sign, so the scale factor is −1/2, centre O. 'Scale factor 1/2' gives the correct size but no inversion, since a positive scale factor keeps the same orientation. 'A 180° rotation with no change in size' gives the inversion but not the halving — K is described as smaller than J, so size must change too. 'Scale factor −2' inverts correctly but doubles the size instead of halving it.
- (c) ABC ≅ XYZ — Method: match each vertex in ABC to its corresponding vertex in XYZ, using the equal sides and angles given, then write the letters in that matching order. Working: AB matches XY, BC matches YZ, and angle B matches angle Y, so A corresponds to X, B corresponds to Y, and C corresponds to Z, giving ABC ≅ XYZ. Options: 'ABC ≅ ZYX' puts Z in A's position, but A corresponds to X, not Z; 'ABC ≅ YXZ' puts Y in A's position, but A corresponds to X; 'ABC ≅ ZXY' puts Z in A's position and X in B's position, neither of which is correct. Answer: ABC ≅ XYZ.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (a) 46° — Method: use the angle at the centre, then the cyclic quadrilateral, then the angle sum of a triangle. Working: angle ABC = 152° ÷ 2 = 76° (angle at the centre is twice the angle at the circumference); angle ADC = 180° − 76° = 104° (opposite angles of a cyclic quadrilateral sum to 180°); angle DAC = 180° − 104° − 30° = 46° (angle sum of triangle ACD). Skipping the halving step and taking angle ABC = 152° gives angle ADC = 180° − 152° = 28° and then angle DAC = 122°; using angle ABC = 76° directly as angle ADC, skipping the cyclic quadrilateral step, gives 74°; and finding angle DAC as 180° − 104° without subtracting the given 30° gives 76°. Each of the three steps must be carried through in order — halve, then subtract from 180°, then subtract from 180° again with the extra angle.
Build your own mix at the worksheet builder.