Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Square — A square has all four sides equal, all four angles equal to 90°, and diagonals that are equal in length and bisect each other at right angles — every part of the description matches, so Square is correct. A rhombus has all four sides equal and diagonals bisecting at right angles, but its interior angles are not generally 90° (only a square, a special rhombus, has that), so it does not fully match. A rectangle has four 90° angles and equal diagonals, but its sides are not all equal in general, so it fails the equal-sides condition. A kite has two pairs of adjacent equal sides rather than all four sides equal, and its diagonals are not generally equal in length, so it fails both conditions.
- (d) No transformation — every point stays exactly where it was — The two vectors (5, −3) and (−5, 3) are opposites, so adding them gives (0, 0): every point ends up exactly where it started, and there is no transformation at all. Misreading the second vector's signs and effectively adding (5, −3) to itself instead of to its opposite gives a translation by the vector (10, −6). Assuming two translations must combine into a reflection gives a reflection in the x-axis — but a reflection reverses orientation, and translations never do. Assuming that two opposite vectors must mean a half turn gives a rotation of 180° about the origin — but a 180° rotation moves every point except its own centre, whereas this pair of translations leaves every single point exactly where it was. Two translations by opposite vectors always cancel exactly, leaving every point unmoved.
- (d) (6, 2) — Applying the first vector: (2, 1) + (5, −3) = (7, −2), which is the warehouse. Applying the second vector: (7, −2) + (−1, 4) = (6, 2), the delivery address. '(7, −2)' stops at the warehouse and forgets the second flight. '(8, −6)' comes from adding (1, −4) instead of (−1, 4) for the second vector, getting both signs wrong. '(11, −3)' comes from swapping the components of the second vector to (4, −1) before adding.
- (d) 13 cm — Use Pythagoras' theorem in three dimensions: for a cuboid with edges a, b and c the space diagonal d satisfies d² = a² + b² + c². Substitute a = 3, b = 4, c = 12: d² = 3² + 4² + 12² = 9 + 16 + 144 = 169. Take the square root: d = √169 = 13 cm. Adding the three edges directly, 3 + 4 + 12 = 19 cm, ignores that Pythagoras' theorem is about squares, not lengths, and gives 19 cm. Stopping after squaring and adding, without taking the square root, leaves 169 cm — the squared length, not the length itself. Using only the 4 cm and 12 cm edges finds the diagonal of one face, √(4² + 12²) = √160 = 12.6 cm (1 d.p.), and leaves out the third dimension entirely.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (b) AB = DE — RHS needs a right angle, the hypotenuse, and one OTHER side to be equal; the right angles and hypotenuses are already equal, so a matching pair of the remaining sides, AB = DE, completes RHS. Angle A = angle D is an extra ANGLE fact, not the extra SIDE fact that RHS specifically requires. AC being parallel to DF says nothing about either triangle's side lengths, so it cannot complete a congruence condition. Being drawn the same way up is about orientation on the page, not about any measurement, so it proves nothing about congruence.
- (c) 5 cm — Diameter = circumference ÷ π, so 31.4 ÷ 3.14 = 10 cm, and the radius is half the diameter, so 10 ÷ 2 = 5 cm. 10 cm is the diameter itself, given as the radius by forgetting the final halving step. 15.7 cm comes from halving the circumference, 31.4 ÷ 2 = 15.7, and stopping there, treating half the circumference as the radius without ever dividing by π. 2.5 cm comes from halving the correct radius again, effectively dividing by 2 twice instead of once.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (d) £100.48 — Area of the rug = (angle ÷ 360) × π × r² = (180 ÷ 360) × 3.14 × 16 = 0.5 × 50.24 = 25.12 m². Cost = 25.12 × £4 = £100.48. (£200.96 comes from finding the area of a full circle, 3.14 × 16 = 50.24 m², and forgetting the angle fraction before costing it; £25.12 comes from forgetting to square the radius, using 0.5 × 3.14 × 4 = 6.28 m², and then costing that; £50.24 comes from using the arc length formula, 0.5 × 2 × 3.14 × 4 = 12.56, in place of the area, and costing that.)
- (c) (10.5, −2) — Method: the vector from the first tile to the third tile is the pattern's vector doubled, since two translations happen between them. Working: doubling (4.5, −2.5) gives (9, −5); adding this to the starting corner (1.5, 3) gives x-coordinate 1.5 + 9 = 10.5 and y-coordinate 3 − 5 = −2. Answer: (10.5, −2). A candidate who only applies the vector once, translating to the second tile instead of the third, gets (6, 0.5). A candidate who adds 2.5 instead of subtracting it in the y-coordinate gets (10.5, 8). A candidate who doubles the x-part of the vector correctly but forgets to change the y-coordinate at all gets (10.5, 3).
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (a) SSA - not sufficient to prove congruence — The angle given, angle A, is not the angle between sides AB and BC — it is not the included angle — so this data is SSA (side, side, angle), which is not sufficient to prove congruence on its own; two triangles can share this SSA information without being congruent. SAS is wrong because the given angle is not the one included between the two given sides. ASA is wrong because only one angle (A) is given, not two. AAS is wrong for the same reason — only one angle is given, not two.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
Build your own mix at the worksheet builder.