Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (b) An enlargement, centre O, scale factor −1/2. — A single enlargement with a negative scale factor both changes the size (by the magnitude of the factor) and rotates the image 180° about the centre (giving the inverted orientation) in one transformation. Halving the size needs a magnitude of 1/2, and inverting needs a negative sign, so the scale factor is −1/2, centre O. 'Scale factor 1/2' gives the correct size but no inversion, since a positive scale factor keeps the same orientation. 'A 180° rotation with no change in size' gives the inversion but not the halving — K is described as smaller than J, so size must change too. 'Scale factor −2' inverts correctly but doubles the size instead of halving it.
- (c) (1/3)a + (2/3)b — Method: OP = OA + AP, and since AP is twice PB, AP is 2/3 of the whole of AB, with AB = b − a. Working: OP = a + 2/3(b − a) = a − (2/3)a + (2/3)b = (1/3)a + (2/3)b. Answer: OP = (1/3)a + (2/3)b. Measuring 2/3 of AB from B's end instead of A's swaps the fractions round, giving (2/3)a + (1/3)b; adding (2/3)b onto the whole of a without first subtracting a inside the bracket gives a + (2/3)b; and treating the ratio as though AP and PB were equal gives the midpoint, (1/2)a + (1/2)b. Convert the ratio to a fraction of AB measured from the point named first in the ratio, subtract before you scale, and then add the result to OA.
- (b) (1/2)b − (1/2)a — Method: MN runs from M to N, so MN = ON − OM, with OM = (1/2)a and ON = (1/2)b. Working: MN = (1/2)b − (1/2)a. Answer: MN = (1/2)b − (1/2)a. Subtracting the other way round gives (1/2)a − (1/2)b, the reverse vector from N to M; subtracting the wrong way round AND forgetting to halve gives a − b, which is BA, not MN; and adding the two halved vectors instead of subtracting them gives (1/2)a + (1/2)b, which is the position vector of the midpoint of AB. Always subtract the START point's vector from the END point's vector, and halve OA and OB before you combine them, not after.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (c) 0.5 — The real distance is 2 × 25000 = 50000 cm. Converting to metres, by dividing by 100, gives 500 m, and converting to kilometres, by dividing by 1000, gives 0.5 km. A candidate who divides the 50000 cm by 1000 in one go, applying the metres-to-kilometres factor straight to the centimetres, gets 50 km. A candidate who divides by 100 twice, treating 100 m as 1 km, gets 5 km. A candidate who slips one extra decimal place when converting 500 m to kilometres gets 0.05 km. The real distance is 0.5 km.
- (a) Triangular-based pyramid (tetrahedron) — A solid with 4 triangular faces, 4 vertices and 6 edges is a triangular-based pyramid, also called a tetrahedron. A triangular prism also has triangular faces, but it has 2 triangular faces plus 3 rectangular faces, 6 vertices and 9 edges — the extra rectangular faces and edges rule it out here. A square-based pyramid has 5 faces (one square, four triangles), 5 vertices and 8 edges, which does not match. A cube has 6 faces, 8 vertices and 12 edges, all much higher than the numbers given. The solid described is a triangular-based pyramid.
- (a) 4700 cm² — Method: split the T-shaped outline into the two rectangles it is made from, find the area of each, then add them together. Working: the wide base gives a rectangle 90 cm × 30 cm = 2700 cm²; the narrower block on top gives a rectangle 40 cm × 50 cm = 2000 cm²; adding these, 2700 + 2000 = 4700 cm². Answer: 4700 cm². The distractors: 2700 cm² comes from finding only the area of the base rectangle and forgetting to add the block on top. 2000 cm² comes from finding only the area of the top block and forgetting the base. 7200 cm² comes from treating the whole outline as one large rectangle, 90 cm wide by (30 + 50) = 80 cm tall, instead of splitting it into the two separate rectangles that actually make up the shape.
- (d) 12 cm — Since DE is parallel to BC, triangle ADE is similar to triangle ABC (the two triangles share angle A, and the parallel lines make the angles at D and E equal to the angles at B and C). The whole side AB = AD + DB = 3 + 6 = 9 cm. The scale factor from the small triangle to the large triangle is AB ÷ AD = 9 ÷ 3 = 3, so BC = DE × 3 = 4 × 3 = 12 cm. Scaling by DB ÷ AD instead of AB ÷ AD gives 4 × (6 ÷ 3) = 8 cm. Adding DB directly onto DE, instead of scaling, gives 4 + 6 = 10 cm. Treating the triangles as congruent rather than similar, so assuming corresponding sides are simply equal, gives BC = DE = 4 cm.
- (b) 7 cm — The side opposite the 30° angle is found using sin 30° = opposite/hypotenuse, so opposite = 14 × sin 30° = 14 × 1/2 = 7 cm. 7√3 cm comes from using cos 30° = √3/2 instead of sin 30° (mixing up the opposite and adjacent sides). 14/√3 cm comes from using tan 30° = 1/√3 instead of sin 30°. 28 cm comes from dividing 14 by sin 30° instead of multiplying by it.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (c) (3, 2) — For an enlargement centred on the origin, multiply every coordinate by the scale factor: (9 × 1/3, 6 × 1/3) = (3, 2). A pupil who multiplies by 3 instead of by 1/3 gets (27, 18). A pupil who subtracts a third of each coordinate instead of scaling by a third gets (9 − 3, 6 − 2) = (6, 4). A pupil who applies the scale factor to the x-coordinate only gets (3, 6). The correct image is (3, 2).
Build your own mix at the worksheet builder.