Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) $12\sqrt{3}$ cm² — Use Area = 1/2 × AB × AC × sin(angle BAC) = 1/2 × 6 × 8 × sin 60°. Since sin 60° = √3⁄2, this is 1/2 × 6 × 8 × √3⁄2 = 24 × √3⁄2 = 12√3 cm². Using AB × AB instead of AB × AC (taking 6 × 6 rather than 6 × 8) gives 1/2 × 6 × 6 × sin 60° = 18 × √3⁄2 = 9√3 cm². Using AC × AC instead of AB × AC (taking 8 × 8 rather than 6 × 8) gives 1/2 × 8 × 8 × sin 60° = 32 × √3⁄2 = 16√3 cm². Leaving out the 1/2 from the area formula gives 6 × 8 × sin 60° = 48 × √3⁄2 = 24√3 cm².
- (a) 49 cm² — Method: two sides and the angle between them are given, so use the cosine rule a² = b² + c² − 2bc cos A with BC facing the 60° angle. By hand, cos 60° = 0.5. Working: BC² = 8² + 5² − 2 × 8 × 5 × cos 60° = 64 + 25 − 80 × 0.5 = 89 − 40 = 49. Answer: BC² = 49 cm². The distractors: 129 cm² comes from adding the final term instead of subtracting it, 89 + 40; 89 cm² comes from leaving the cosine term out altogether and treating the 60° as though it were a right angle, so that Pythagoras applies; 69 cm² comes from forgetting the factor 2 in 2bc cos A and subtracting only 8 × 5 × 0.5 = 20.
- (a) 56° — The angles of a triangle add up to 180°. Add the two known angles: 90° + 34° = 124°. Subtract from 180°: 180° − 124° = 56°.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (b) 1 point — A rotation about a point P always leaves P itself unchanged, and — unless the shape has rotational symmetry about that exact point — no other point of the shape maps onto itself. The centre of rotation here is the vertex (2, 1), so exactly one point of the trapezium, that vertex, is invariant. Thinking that a rotation always has no invariant points ignores the centre of rotation itself, which is always fixed, and gives 0 points. Assuming every vertex of the shape is invariant confuses a rotation with the identity transformation and gives 4 points, the total number of vertices. Believing that the point diametrically opposite the centre is also fixed applies point symmetry of the whole coordinate grid rather than checking whether that point actually lies on this particular trapezium, and gives 2 points.
- (b) 3 — The real width is 0.6 × 500 = 300 cm, which converts to 3 m by dividing by 100. A candidate who uses the wrong side of the rectangle, 1.2 cm, instead of the 0.6 cm width, gets 1.2 × 500 = 600 cm = 6 m. A candidate who multiplies correctly but converts the 300 cm to metres by dividing by 1000 instead of 100 gets 0.3 m. A candidate who converts by dividing by 10 instead of 100 gets 30 m. The real width of the bay is 3 m.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (d) (−2, 0) — A 180° rotation about a centre (a, b) maps (x, y) to (2a − x, 2b − y). Here that gives (2 × 1 − 4, 2 × 1 − 2) = (−2, 0). A pupil who rotates about the origin instead of (1, 1) gets (−4, −2). A pupil who adds the centre's coordinates instead of applying the rotation formula gets (4 + 1, 2 + 1) = (5, 3). A pupil who just subtracts the centre's coordinates from E's, without doubling and reversing, gets (4 − 1, 2 − 1) = (3, 1). The correct image is (−2, 0).
- (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
- (b) 58° — Method: the angle at the centre is TWICE the angle at the circumference when both stand on the same arc. Working: angle AOC is the angle at the centre standing on arc AC, and angle ABC is the angle at the circumference standing on the same arc AC, with B on the major arc, so angle AOC = 2 × angle ABC. Rearranging, angle ABC = 116 ÷ 2 = 58 degrees. Answer: 58°. Halve the centre angle, do not double it, and use the angle AOC exactly as given, 116°: you do not need its reflex angle here, because B sits on the major arc, which is precisely the arrangement the theorem is stated for.
Build your own mix at the worksheet builder.