Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (c) An L-shape — Method: to find the front elevation, trace the outline of the solid seen from directly in front. Working: the low, wide cuboid gives a wide rectangle across the bottom, and the taller, narrower cuboid sitting on one end adds a narrower rectangle rising above only that end of the base, so the outline steps up on one side only. Answer: an L-shape. The distractors: a rectangle comes from taking the outline of the box the whole solid would just fit inside, ignoring the step created by the taller block. A T-shape comes from placing the taller block in the middle of the base instead of at one end, so that the base would show on both sides of it. A parallelogram comes from copying a face as it is drawn in the sketch — the top of the taller block is drawn as a sloping parallelogram because the solid is drawn at an angle — instead of drawing the true outline seen looking straight at the front.
- (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
- (c) A rotation of 180° about the origin — An enlargement by scale factor −1 sends every point (x, y) to (−x, −y) — both coordinates change sign. A rotation of 180° about the origin does exactly the same thing to every point, so the two transformations have identical effect. A reflection in the x-axis only changes the sign of the y-coordinate, sending (x, y) to (x, −y), leaving the x-coordinate untouched. A reflection in the y-axis only changes the sign of the x-coordinate, sending (x, y) to (−x, y), leaving the y-coordinate untouched. Treating a negative scale factor as though it behaves like a positive one gives no transformation at all, but the minus sign is not decorative — it reverses both coordinates. Both signs flip together, which is exactly what a 180° rotation about the origin does.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (a) 5 — Method: BC faces the 60° angle, so put the two algebraic sides into the cosine rule and solve the equation that results. By hand, cos 60° = 0.5. Working: 7² = x² + (x + 3)² − 2 × x × (x + 3) × 0.5, so 49 = x² + x² + 6x + 9 − x² − 3x = x² + 3x + 9. That rearranges to x² + 3x − 40 = 0, which factorises as (x + 8)(x − 5) = 0, giving x = −8 or x = 5. A length cannot be negative, so the negative root is rejected. Answer: x = 5. The distractors: 8 comes from expanding (x + 3)² as x² + 9, the error of assuming that squaring a bracket squares each term, which turns the equation into x² − 3x − 40 = 0; −8 is the negative root, kept by a candidate who solves the quadratic but never checks that x has to be a length; 37 comes from applying the cosine rule as though the 60° angle were at C facing AB, which gives x² = (x + 3)² + 49 − 7(x + 3) and a single linear solution.
- (d) (−1, 3) — Method: two 90° rotations about the SAME centre, applied one after another, combine into a single 180° rotation about that same centre: use the shortcut (x, y) → (2a − x, 2b − y) for a half-turn about (a, b). Working: with centre (2, 3), doubling each coordinate gives 2 × 2 = 4 and 2 × 3 = 6, so the rule is (x, y) → (4 − x, 6 − y). Applying it to (5, 3) gives 4 − 5 = −1 and 6 − 3 = 3, so the coin ends at (−1, 3). Answer: (−1, 3). Rotate about the centre (2, 3) stated in the game, not about the origin, and remember the button is pressed TWICE: stopping after one press, or rotating about the wrong centre, both leave the coin somewhere else.
- (b) Rhombus — A rhombus has exactly two lines of symmetry, formed by its two diagonals, and both pairs of opposite angles are equal, but its diagonals are unequal in length. A square also has opposite angles equal, but it has four lines of symmetry and its diagonals ARE equal, so it does not fit. A kite normally has only one line of symmetry and only one pair of opposite angles equal, so it does not fit. A general parallelogram has no lines of symmetry at all, so it does not fit. The correct answer is rhombus.
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (c) (−3, 1) — Method: for an enlargement about a centre, first find the vector from the centre to the point, multiply it by the scale factor, INCLUDING its sign, then add the result back onto the centre. Working: the vector from the centre (1, 1) to A(3, 1) is (3 − 1, 1 − 1) = (2, 0). Multiplying by the scale factor −2 gives −2 × 2 = −4 and −2 × 0 = 0, so the scaled vector is (−4, 0). Adding this to the centre gives 1 + (−4) = −3 and 1 + 0 = 1, so the image is (−3, 1). Answer: (−3, 1). A NEGATIVE scale factor keeps its sign all the way through the calculation: do not treat −2 as +2, and do not treat it as a fraction like 1/2, which is the rule for a scale factor between 0 and 1, not a negative one. Always measure the vector from the CENTRE of enlargement, never from the origin, unless the two happen to coincide.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
- (b) 6 cm — Method: the right angle is at A, so BC is the hypotenuse and AC is the side opposite the angle at B; sin B = opposite ÷ hypotenuse therefore gives AC ÷ BC = 3/5. Working: AC ÷ 10 = 3/5, so AC = 10 × 3 ÷ 5 = 6. Answer: 6 cm. The distractors: 8 cm is AB, the side next to the angle at B, which is what cos B = 4/5 produces — the right method used on the wrong side; 3 cm comes from reading the 3 in the ratio as a length and never scaling it up to the 10 cm hypotenuse; 30 cm comes from multiplying by 3 and forgetting to divide by 5.
Build your own mix at the worksheet builder.