Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (c) VW — Method: within one circle a chord's distance from the centre is fixed by its length, because a chord passing nearer the centre cuts further across the circle; so the chord that lies closest to the centre is simply the longest one listed. Working: the four lengths are 6 cm, 10 cm, 14 cm and 15 cm. Placing them in order, the greatest is 15 cm, and that length belongs to VW, so VW lies closest to the centre. Answer: VW. The distractors: PQ comes from reversing the rule and taking the shortest chord to be the one tucked nearest the centre; TU comes from knowing that the very longest chord is a diameter, deciding that such a chord passes through the centre rather than lying close to it, ruling the 15 cm chord out on that ground and taking the next longest; RS comes from reading 'closest to the centre' as 'nearest the middle of the list of lengths' and picking a middling value.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (b) 115° — Angle APE and angle BPQ are vertically opposite, so angle BPQ = 65°, equal to angle APE. Angle BPQ and angle PQD are co-interior (allied) angles between the parallel lines, and co-interior angles always add up to 180°, so angle PQD = 180 − 65 = 115°. "65°" comes from treating co-interior angles as equal to each other, the way alternate angles are, instead of adding to 180°. "295°" comes from applying the angles-round-a-point fact (360° − 65°) directly to the original 65°, skipping the correct co-interior step. "25°" comes from misremembering co-interior angles as adding to 90° instead of 180° (90 − 65 = 25).
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (b) 72 000 cm³ — Cross-sectional area = 1/2 × 40 × 30 = 600 cm². Volume = cross-sectional area × length = 600 × 120 = 72 000 cm³. (144 000 cm³ comes from forgetting the 1/2 in the triangle's area, using 40 × 30 as the cross-section; 36 000 cm³ comes from halving the correct volume again, as if the 1/2 applied a second time; 720 cm³ comes from adding the cross-sectional area and the length, 600 + 120, instead of multiplying them.)
- (a) 10.4 cm — The scale factor from the smaller triangle to the larger triangle is 8 ÷ 5 = 1.6, so the larger side is 6.5 × 1.6 = 10.4 cm. The distractor 4.0625 cm comes from using the ratio the wrong way round, 6.5 × 5 ÷ 8 = 4.0625. The distractor 9.5 cm comes from adding the difference between the ratio numbers (8 − 5 = 3) to the given length, 6.5 + 3 = 9.5. The distractor 13 cm comes from doubling the given length, treating the scale factor as 2 instead of 1.6.
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (b) Square — A square has all four sides equal, all four angles equal to 90°, and diagonals that are equal in length and bisect each other at right angles — every part of the description matches, so Square is correct. A rhombus has all four sides equal and diagonals bisecting at right angles, but its interior angles are not generally 90° (only a square, a special rhombus, has that), so it does not fully match. A rectangle has four 90° angles and equal diagonals, but its sides are not all equal in general, so it fails the equal-sides condition. A kite has two pairs of adjacent equal sides rather than all four sides equal, and its diagonals are not generally equal in length, so it fails both conditions.
- (a) (−2, 6) — Translating by the vector (−5, 4) means adding −5 to the x-coordinate and adding 4 to the y-coordinate: (3 + (−5), 2 + 4) = (−2, 6). (8, 6) comes from treating −5 as +5, adding instead of subtracting on the x-coordinate. (−2, −2) keeps the x-coordinate correct but subtracts 4 from the y-coordinate instead of adding it. (7, −3) comes from swapping the two components of the vector, applying 4 to the x-coordinate and −5 to the y-coordinate.
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (d) 4 m — The sloping slide is the hypotenuse of a right-angled triangle with the other two sides 2.4 m and 3.2 m. By Pythagoras' Theorem, hypotenuse² = 2.4² + 3.2² = 5.76 + 10.24 = 16. Square root: √16 = 4 m. Adding the two sides instead of squaring them gives 2.4 + 3.2 = 5.6 m. Truncating each squared side to a whole number before adding (5.76 to 5 and 10.24 to 10) gives √15 ≈ 3.87 m. Forgetting to take the square root and leaving the sum of the squares as the answer gives 5.76 + 10.24 = 16, written as 16 m.
Build your own mix at the worksheet builder.