Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 67° — PA and PB are tangents from the same point, so OAPB is a kite with right angles at A and B, by the tangent–radius theorem. The kite's angles sum to 360°, so angle AOB = 360° − 90° − 90° − 46° = 134°. C is on the major arc AB, so by the angle at the centre theorem, angle ACB = 134° ÷ 2 = 67°. Doubling angle APB instead of first finding angle AOB from the kite gives 46° + 46° = 92°. Using angle APB directly as if it were the centre angle, then halving it, gives 46° ÷ 2 = 23°. Finding angle AOB = 134° correctly but forgetting to halve it for the angle at the circumference gives 134°. Halve angle AOB, once you've found it properly, and you get 67°.
- (a) Kite — Method: check each named quadrilateral's properties against the three facts given, one at a time. Working: a kite has two pairs of adjacent sides equal (not opposite pairs), one pair of opposite angles equal (the two angles where an unequal pair of sides meet), and exactly one line of symmetry — matching all three facts. Options: a rhombus does have equal adjacent sides, but all four of its sides are equal, both pairs of its opposite angles are equal, and it has two lines of symmetry rather than exactly one; a parallelogram has its opposite sides equal rather than adjacent pairs, both pairs of opposite angles equal, and no line of symmetry at all; a trapezium does not generally have any pair of equal adjacent sides or a line of symmetry. Answer: kite.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (a) 225 — Method: find the interior angle of the regular octagon, then subtract it from 360° to find the reflex angle at the same vertex, since the interior angle and the reflex angle together make a full turn. Working: there are 8 − 2 = 6 triangles' worth of angle in the octagon, so the interior angle = 6 × 180 ÷ 8 = 135; reflex angle = 360 − 135 = 225. Answer: 225°. A candidate who stops after finding the interior angle gives 135. A candidate who works out the exterior angle instead, 360 ÷ 8 = 45, gives 45. A candidate who subtracts the exterior angle from 360° instead of the interior angle, working out 360 − 45, gets 315.
- (b) 45 cm² — Area scales with the square of the linear scale factor, and squaring a negative number gives a positive result: (−3)² = 9. The area of T is 5 × 9 = 45 cm². 15 cm² comes from multiplying the original area by the scale factor directly (5 × 3), without squaring. 9 cm² is the area scale factor itself, (−3)², with the multiplication by the original area 5 cm² left out. −15 cm² comes from multiplying 5 × (−3) and carrying the negative sign through, without squaring at all.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (d) (3/4)a + (1/4)c — Method: OX = OA + AX, and since AX is a third of XC, AX is 1/4 of the whole of AC, with AC = c − a. Working: OX = a + 1/4(c − a) = a − (1/4)a + (1/4)c = (3/4)a + (1/4)c. Answer: OX = (3/4)a + (1/4)c. Measuring 1/4 of AC from C's end instead of A's swaps the fractions round, giving (1/4)a + (3/4)c; adding (1/4)c onto the whole of a without subtracting a inside the bracket first gives a + (1/4)c; and treating the ratio as though AX and XC were equal gives the midpoint, (1/2)a + (1/2)c. Convert the ratio to a fraction of AC measured from A, subtract before you scale, and then add the result to OA.
- (c) Rectangle — A rectangle has two pairs of parallel sides and four right angles, but does not require all sides to be equal — this matches exactly, so Rectangle is correct. A square also has four right angles and parallel sides, but additionally requires all four sides to be equal, which contradicts 'not all the same length', so it is wrong. A rhombus has two pairs of parallel sides and all four sides equal, but its angles are not generally 90° unless it is also a square, so it does not match the right-angle condition here. A kite has no pairs of parallel sides at all, so it does not match the first condition given.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (a) 62° — Angle KPQ and angle MQP are co-interior (allied) angles between parallel lines, so they add up to 180°: angle MQP = 180° − 118° = 62°. 118° comes from treating the angles as equal, as if this were a corresponding or alternate angle pair, instead of using the co-interior rule. 90° comes from wrongly assuming the crossing line meets JK and LM at right angles. 59° comes from halving 118° instead of subtracting it from 180°.
- (b) (2x + 10)° — By the angle at the centre theorem, angle ABC is half of angle AOC, because both stand on the same arc AC: angle ABC = (4x + 20)° ÷ 2 = (2x + 10)°. Writing down the centre angle itself, without halving at all, gives (4x + 20)°. Halving only the constant term and leaving the x-term unchanged gives (4x + 10)°. Doubling the centre angle instead of halving it gives (8x + 40)°. Halve every term in the expression, and (2x + 10)° is what you get.
- (a) 18 — PQ lies along the x-axis with length 9, and PR lies along the y-axis with length 4, and these two sides meet at right angles at P, so they can be used as the base and height of the triangle. Area = 1/2 × base × height = 1/2 × 9 × 4 = 18. 36 comes from multiplying the base and height but forgetting to halve the result. 13 comes from adding the two lengths, 9 + 4, instead of multiplying them. 26 comes from the perimeter-style calculation 2 × (9 + 4) instead of the triangle area formula.
- (d) B is the reverse of A — Every component of vector B is the negative of the matching component of vector A (−2 is the negative of 2, and 5 is the negative of −5), so B undoes the translation that A performs — B is the reverse of A. 'B is the same as A' ignores that both signs have flipped. 'B is twice A' confuses a sign change with a scale-factor change; the sizes of the components have not changed, only their signs. 'B is unrelated to A in direction' misses that the two vectors are directly linked, just in opposite directions.
Build your own mix at the worksheet builder.