Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 6 cm — Method: a rectangle is made of two lengths and two widths, so the perimeter is 2 × (length + width). Half the perimeter is therefore one length plus one width, and the width is what is left of that half once the length is taken away. Working: 30 ÷ 2 = 15 cm is one length added to one width, and 15 − 9 = 6. Answer: 6 cm. The distractors: 21 cm comes from taking the length off the whole perimeter, 30 − 9, so three sides are still counted in the figure that is written down; 12 cm comes from removing both lengths correctly, 30 − 2 × 9 = 12, and then recording that remainder as the width instead of halving it, because it is in fact the two widths together; 7.5 cm comes from dividing the perimeter by four, 30 ÷ 4, which is the calculation for the side of a square and throws away the length that was given.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (a) 3 : 5 — Method: for similar figures the ratio of the areas is the square of the ratio of the lengths, so the length ratio is found by taking the square root of each part of the area ratio. Working: the areas are in the ratio 36 : 100, and taking square roots gives √36 : √100 = 6 : 10, which cancels to 3 : 5. Answer: 3 : 5. The distractors: 9 : 25 is 36 : 100 in its simplest form, so it is still the ratio of the areas and the square roots were never taken; 5 : 3 takes the roots correctly but writes the parts the wrong way round, giving DEF to ABC when ABC to DEF was asked for; 25 : 9 makes both mistakes at once, leaving the area ratio and reversing it.
- (b) 4 : 9 — The heights are in the ratio 4 : 6, which simplifies to 2 : 3. For similar solids, area scales with the square of the length ratio, so the surface area ratio is 2² : 3² = 4 : 9. 2 : 3 is just the simplified length ratio, before squaring has been done. 8 : 27 comes from cubing the ratio (2³ : 3³) instead of squaring it — that's the rule for volumes, not areas. 9 : 4 has the correct squared values but in the wrong order, giving the larger tin's area first instead of the smaller.
- (a) Draw equal arcs from X and Y, meeting below line l. — After the first arc marks two points X and Y on line l, compasses are opened to a new radius and arcs of equal radius are drawn centred at X and at Y, so that they meet on the opposite side of l from P; joining P to that meeting point gives the perpendicular. (Joining X and Y with a straight line only retraces part of line l itself, since X and Y both already lie on it; drawing an arc centred at P through only one of X or Y repeats part of the first step instead of moving on; drawing a circle through X, Y and P does not locate the new point needed to complete the perpendicular.)
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
- (d) 24 cm²; same way round as T — An enlargement scales area by the square of the scale factor, whatever its sign: area factor = (−2)² = 4, so the image's area is 6 × 4 = 24 cm². A negative scale factor is equivalent to an enlargement by the positive scale factor together with a rotation of 180°, so it does not create a mirror image — it is still a direct transformation, and combining it with a further rotation cannot create one either, since rotations never change a shape's orientation. Using the scale factor itself rather than its square gives area 6 × 2 = 12 cm², which is too small. Believing that a negative scale factor reflects the shape gives 'a mirror image of T' alongside the correct area of 24 cm², and combining both mistakes gives 12 cm² together with 'a mirror image of T'.
- (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
- (a) (4, −4) — A point is invariant under a reflection only if it lies exactly on the mirror line. The line y = −x consists of every point where the y-coordinate is the negative of the x-coordinate: (4, −4) satisfies this, since −4 = −(4), so it is invariant. (5, 5) lies on the line y = x, a different line altogether, not y = −x. (4, 4) has equal coordinates, but that alone does not put it on y = −x; it would need y = −4, not 4. (−4, −4) also has equal coordinates and lies on y = x, not y = −x — its coordinates would need opposite signs to sit on the given mirror line. Only a point whose coordinates are negatives of each other stays fixed under this reflection.
- (c) 12 cm — By Pythagoras' Theorem, QR² = PQ² + PR², so PR² = QR² − PQ² = 15² − 9² = 225 − 81 = 144. Square root: √144 = 12 cm.
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (a) 68° — Method: a tangent meets a radius at 90°, so quadrilateral OAPB has two right angles at A and B; its four angles sum to 360°, so angle APB = 360° − 90° − 90° − angle AOB. Working: angle APB = 360° − 90° − 90° − 112° = 68°. Halving angle AOB, confusing this with the angle-at-centre theorem for a chord, gives 56°; assuming the angle between two tangents is always 90° (true only for the angles at A and B, not at P) gives 90°; and assuming angle APB simply equals angle AOB by symmetry gives 112°. The two right angles at A and B, from the tangent-radius property, are what link angle AOB and angle APB.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (a) 3 m — Height = sloping length × sin 45° = 3√2 × √2/2 = (3 × 2)/2 = 3 m, since √2 × √2 = 2. 3√2 m comes from forgetting to multiply by sin 45° at all. 3√2/2 m comes from using sin 30° = 1/2 instead of sin 45° = √2/2. 6 m comes from using √2 instead of √2/2 for sin 45°, dropping the denominator of the exact value: 3√2 × √2 = 6.
Build your own mix at the worksheet builder.