Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (b) Minor segment — Method: compare the sizes of the two regions cut off by the chord, and recall the term used for the smaller one. Working: the chord creates two segments; the smaller region is called the minor segment and the larger one the major segment. A student who answers major segment has picked the larger region by mistake instead of the smaller one. A student who answers minor arc has named the curved boundary rather than the two-dimensional region it encloses. A student who answers semicircle has wrongly assumed the chord must pass through the centre. Answer: minor segment.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (a) 80° — In triangle ABD, the three angles sum to 180°: angle BAD = 180° − 35° − 65° = 80°. ABCD is a cyclic quadrilateral, so the exterior angle at C, angle BCE, is equal to the interior angle at the opposite vertex, angle BAD: angle BCE = 80°. Adding the two given angles in triangle ABD instead of subtracting them from 180°, 35° + 65° = 100°, and then applying the exterior-angle rule correctly still gives the wrong angle BAD and so the wrong exterior angle, 100°. Halving the correct angle BAD, 80° ÷ 2 = 40°, confuses the exterior-angle rule with a different circle theorem in which one angle is half of another. Doubling it instead, 80° × 2 = 160°, makes the same kind of confusion in the other direction.
- (c) 1/4 — A full turn at the centre of a circle is 360°, so a sector's fraction of the circle is its angle divided by 360°: 90 ÷ 360 = 1/4. 1/2 would be the fraction for a sector with an angle of 180°, not 90°. 3/4 is the fraction of the rest of the circle, the major sector left over from the 270° that is not part of this sector. 1/8 would be the fraction for a sector with an angle of 45°, half of 90°.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (c) a + (1/2)c — Method: OABC is a parallelogram, so OB = OA + AB, and since AB is equal and parallel to OC, AB = c; this gives OB = a + c. M is the midpoint of AB, so AM = (1/2)AB = (1/2)c. Working: OM = OA + AM = a + (1/2)c. Answer: OM = a + (1/2)c. Adding the whole of AB instead of half of it gives a + c, which is OB, not OM; halving the whole diagonal OB instead of just AB gives (1/2)a + (1/2)c, the midpoint of OB rather than of AB; and flipping the sign on the c-term gives a − (1/2)c, which points back the wrong way along AB. Halve only the side you are told to halve, and check the sign before you commit to an answer.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (c) x — By convention, the side opposite a vertex is labelled with the lowercase version of that vertex's letter, so the side opposite X is labelled x. y is the label for the side opposite Y, not X. z is the label for the side opposite Z, not X. X is the vertex's own uppercase letter — the convention specifically switches to lowercase for the side, so the uppercase letter on its own is not correct.
- (a) (4, −4) — A point is invariant under a reflection only if it lies exactly on the mirror line. The line y = −x consists of every point where the y-coordinate is the negative of the x-coordinate: (4, −4) satisfies this, since −4 = −(4), so it is invariant. (5, 5) lies on the line y = x, a different line altogether, not y = −x. (4, 4) has equal coordinates, but that alone does not put it on y = −x; it would need y = −4, not 4. (−4, −4) also has equal coordinates and lies on y = x, not y = −x — its coordinates would need opposite signs to sit on the given mirror line. Only a point whose coordinates are negatives of each other stays fixed under this reflection.
- (a) Reflect in the x-axis, then translate by (0, 7). — Reflecting in the x-axis sends (x, y) to (x, −y); applied to S's vertices (2, 2), (5, 2) and (2, 5) this gives (2, −2), (5, −2) and (2, −5). Translating this image by the vector (0, 7) adds 7 to every y-coordinate, giving (2, 5), (5, 5) and (2, 2), which matches S′ exactly. Using the correct reflection but translating by (7, 0) instead moves the image sideways rather than upwards, giving (9, −2), (12, −2) and (9, −5) — nowhere near S′. Reflecting in the y-axis instead of the x-axis changes the sign of the x-coordinate rather than the y-coordinate, so translating that image by (0, 7) gives (−2, 9), (−5, 9) and (−2, 12), the wrong shape entirely. Rotating 180° about the origin instead of reflecting sends every coordinate to its negative, so translating by (0, 7) gives (−2, 5), (−5, 5) and (−2, 2) — the y-coordinates match S′ but the x-coordinates do not.
- (c) 90° — A tangent to a circle always meets the radius drawn to the point of contact at a right angle, so the angle between the tangent and the radius at P is 90°. 180° confuses the tangent with the diameter through P, as if the radius continued in a straight line into the tangent. 45° halves the true angle by mistake. 60° comes from confusing this fact with the angle of an equilateral triangle.
Build your own mix at the worksheet builder.