Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) (−1, −0.5) — Method: for an enlargement centred at a point O that is not the origin, first find the point's position relative to O, multiply that by the scale factor, then add O's coordinates back on — image = O + k × (F − O). Working: F relative to O is (4, 2) − (2, 1) = (2, 1). Multiplying by the scale factor, −1.5 × (2, 1) = (−3, −1.5). Adding O back on: (2, 1) + (−3, −1.5) = (−1, −0.5). Answer: (−1, −0.5). Measure F's position from the aperture O, not from the origin, apply the full signed scale factor −1.5 to that displacement, and add O's own coordinates back on afterwards: measuring from the origin instead of O, treating the factor as +1.5, or adding O onto the wrong displacement all place the image mark somewhere else.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (d) A prism — A prism has two identical, parallel polygon faces (its cross-section) joined by flat rectangular side faces, so the same cross-sectional shape runs all the way along its length — this description matches a prism. A pyramid instead narrows from one polygon base up to a single point (the apex), so it does not have two identical parallel faces. A cone has one curved surface and a single circular base narrowing to a point — no flat rectangular sides at all. A cylinder has two identical circular faces, but they are joined by a curved surface, not by flat rectangles.
- (c) ∠XYZ — The angle at a named vertex is written with that vertex's letter in the middle, flanked by its two neighbouring vertices. The angle at Y sits between X and Z, its neighbours in quadrilateral WXYZ, so it is written ∠XYZ. ∠WXY names the angle at X, since X is the middle letter, not Y. ∠YZW names the angle at Z, since Z is the middle letter. ∠ZWX names the angle at W, since W is the middle letter.
- (a) 25° — PA and PB are tangents from the same external point, so PA = PB and OAPB is a kite with right angles at A and B, by the tangent–radius theorem: angle OAP = angle OBP = 90°. The four angles of the kite sum to 360°, so angle AOB = 360° − 90° − 90° − 50° = 130°. Triangle OAB is isosceles because OA = OB, both radii, so its base angles are equal: angle OAB = (180° − 130°) ÷ 2 = 25°. Using angle APB itself as the apex angle of triangle OAB instead of angle AOB gives (180° − 50°) ÷ 2 = 65°. Using a triangle's angle sum on the four-sided kite, and so counting only one of its two right angles, treats angle AOB as 180° − 90° − 50° = 40°, and halving what is then left of triangle OAB gives (180° − 40°) ÷ 2 = 70°. Finding angle AOB = 130° correctly but forgetting to halve for the isosceles base angle gives 180° − 130° = 50°. Halve that remaining angle, and 25° is what's left for angle OAB.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (d) 7 cm — Area of a parallelogram = base × height, so height = area ÷ base = 84 ÷ 12 = 7 cm. A pupil who multiplies instead of dividing gets 84 × 12 = 1008 cm. A pupil who divides the base by the area instead of the area by the base gets 12 ÷ 84 ≈ 0.14 cm. A pupil who mistakenly halves the area first, as if this were a triangle, gets (84 ÷ 2) ÷ 12 = 3.5 cm. The correct height is 7 cm.
- (b) 13 — Using the sum of interior angles formula, (n − 2) × 180° = 1980°, so n − 2 = 1980 ÷ 180 = 11, and n = 11 + 2 = 13. 11 stops after the division, forgetting to add 2 back to find n. 15 adds 2 twice by mistake, giving 11 + 2 + 2. 22 divides 1980 by 90 instead of 180.
- (a) 0.1 m — Method: the sloping surface is the hypotenuse and the vertical rise is the side opposite the 30° angle, so rise = 4.8 × sin 30°; then compare that rise with the limit. Working: the exact value of sin 30° is one half, so the rise = 4.8 × 1/2 = 2.4 m. The limit is 2.5 m, and 2.5 − 2.4 = 0.1. Answer: the ramp is 0.1 m below the limit. Working out the rise and stopping there gives 2.4 m, which answers a question that was not asked. Dividing by sin 30° instead of multiplying gives 4.8 ÷ 0.5 = 9.6 and then 9.6 − 2.5 = 7.1 m. Treating sine as proportional to the angle, so that sin 30° is a third of sin 90°, gives 4.8 ÷ 3 = 1.6 and then 2.5 − 1.6 = 0.9 m.
- (c) 58° — In an isosceles triangle, the base angles opposite the equal sides are equal. Since DE = DF, angle F is the base angle equal to angle E, so angle F = 58°.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
- (d) 12 — Method: rearrange F + V − E = 2 so that E is on its own: E = F + V − 2. Working: E = 6 + 8 − 2 = 12. A student who answers 14 has added F and V but forgotten to subtract 2 at all. A student who answers 16 has added 2 instead of subtracting it. A student who answers 10 has subtracted 2 twice by mistake. Answer: 12 edges.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
Build your own mix at the worksheet builder.