Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (c) 25 m — The gardener needs the circumference, since the trim goes around the flower bed. Circumference = πd = 3.14 × 8 = 25.12 m, which rounds to 25 m. A student who mistakes the diameter (8 m) for the radius, then doubles it before multiplying by π, gets 3.14 × 16 = 50.24 m, rounding to 50 m. A student who makes the same mistake but uses the area formula instead of the circumference gets 3.14 × 8² = 200.96 m², rounding to 201. A student who correctly halves the diameter to find the radius (4 m) but then uses πr instead of πd gets 3.14 × 4 = 12.56 m, rounding to 13 m.
- (a) 62.8 cm — The ribbon goes once around the circular cross-section, so its length equals the circumference: 2πr = 2 × 3.14 × 10 = 62.8 cm.
- (a) 3.75 km — To convert metres to kilometres, divide by 1000: 3750 ÷ 1000 = 3.75 km. Dividing by 100 instead of 1000 gives 37.5 km. Dividing by 10 instead of 1000 gives 375 km. Dividing by 10 000 instead of 1000 gives 0.375 km.
- (a) Similar, but AAA alone does not prove congruence — Three equal corresponding angles (AAA) show that the two triangles are similar — the same shape — but says nothing about their size, so it does not prove congruence. They could be congruent, or one could simply be an enlargement of the other; without matching side lengths, congruence is not established, so 'congruent because AAA proves congruence' is wrong. Equal angles do not force equal sides — a triangle can be enlarged to any size while keeping the same angles, so that option is also wrong. Something CAN be said here — that the triangles are similar — so 'no relationship can be determined' is wrong too.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (b) 12 m — sin 30° = opposite ÷ hypotenuse, where the opposite side is the height (6 m) and the hypotenuse is the string. So string = height ÷ sin 30° = 6 ÷ (1/2) = 12 m. The distractor 3 m comes from multiplying by sin 30° instead of dividing (6 × 1/2 = 3). The distractor 6√3 m comes from using tan 30° = 1/√3 instead of sin 30° (6 ÷ (1/√3) = 6√3). The distractor 4√3 m comes from using cos 30° = √3/2 instead of sin 30° (6 ÷ (√3/2) = 12/√3 = 4√3).
- (c) Translation by the vector (8, 0) — Method: reflecting twice in two parallel vertical lines is always equivalent to a single translation, at right angles to the lines, of twice the distance between them. Working: the two lines are 5 − 1 = 4 units apart, so the translation is 2 × 4 = 8 units in the positive x-direction. Answer: translation by the vector (8, 0). Using just the gap itself, without doubling it, gives (4, 0); translating in the negative x-direction, from the second line back towards the first, gives (−8, 0); and describing the combination as a single reflection in the line halfway between them, x = 3, confuses this combination with the effect of a single reflection — two reflections in parallel lines are always equivalent to a translation, never to another reflection. Always double the gap between the lines, and translate in the direction from the first line towards the second.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (c) 0.5 — The real distance is 2 × 25000 = 50000 cm. Converting to metres, by dividing by 100, gives 500 m, and converting to kilometres, by dividing by 1000, gives 0.5 km. A candidate who divides the 50000 cm by 1000 in one go, applying the metres-to-kilometres factor straight to the centimetres, gets 50 km. A candidate who divides by 100 twice, treating 100 m as 1 km, gets 5 km. A candidate who slips one extra decimal place when converting 500 m to kilometres gets 0.05 km. The real distance is 0.5 km.
- (d) 6.7 cm — Volume of the sphere = (4/3)πr³ = (4/3) × 3.14 × 5³ = (4/3) × 3.14 × 125 = 523.33 cm³. Set this equal to the cylinder's volume πr²h: 523.33 = 3.14 × 25 × h = 78.5h. Divide: h = 523.33 ÷ 78.5 = 6.667 cm, which rounds to 6.7 cm. 1.7 cm comes from using the sphere's diameter, 10 cm, as the cylinder's radius: 523.33 ÷ (3.14 × 10²) = 1.7 cm.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
Build your own mix at the worksheet builder.