Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) (3, −5) — Method: apply the rotation to the point first, then translate the image, in the order the question gives them. Working: rotating (4, 1) by 90° clockwise about the origin sends (x, y) to (y, −x), so (4, 1) becomes (1, −4). Translating (1, −4) by the vector (2, −1) gives 1 + 2 = 3 and −4 − 1 = −5, so the final image is (3, −5). Answer: (3, −5). Use the CLOCKWISE rule, (x, y) → (y, −x), not the anticlockwise one, and apply the rotation before the translation, exactly as the question states them: reversing the order or the direction of turn both land on a different point.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (d) (2, −1) — Method: for an enlargement, image = centre + k × (point − centre), so the centre satisfies centre = (image − k × point) ÷ (1 − k). Working: with k = 5, point (4, 1) and image (12, 9): 5 × (4, 1) = (20, 5); (12, 9) − (20, 5) = (−8, 4); dividing by 1 − 5 = −4 gives (2, −1). Answer: (2, −1), the centre of the enlargement, is the only invariant point since the scale factor is not 1. Subtracting the point itself instead of k times the point, (12, 9) − (4, 1) = (8, 8), then dividing by −4 gives (−2, −2); dividing by k − 1 = 4 instead of 1 − k = −4 gives (−2, 1); and simply taking the midpoint of the point and its image ignores the scale factor altogether and gives (8, 5). The centre of an enlargement is never just the midpoint between a point and its image unless the scale factor happens to be −1 — always use the full centre formula and keep the scale factor k in it.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (c) (1/3)b − (1/3)a — Method: PQ runs from P to Q, so PQ = OQ − OP. Working: PQ = (1/3)b − (1/3)a. Answer: PQ = (1/3)b − (1/3)a. Subtracting the other way round gives (1/3)a − (1/3)b, the same vector pointing back from Q to P instead of P to Q; using 2/3 instead of the 1/3 that OP and OQ were actually given as gives (2/3)b − (2/3)a; and using the full vectors a and b with no scaling at all gives b − a, which is AB, not PQ. Always subtract START from END, OQ − OP, and carry the fraction given in the question through to your final vector.
- (b) 35° — Method: angle CBE and angle ABC lie on a straight line at B, so they are supplementary; angle ABC then equals angle ADC because B and D are both on the major arc AC (angles in the same segment). Working: angle ABC = 180 − 145 = 35 degrees, using angles on a straight line. Since B and D are both on the major arc AC, angle ADC = angle ABC = 35°. Answer: 35°. Find angle ABC FIRST from the straight line at B before applying the circle theorem: using the given 145° directly, doubling or halving it, or subtracting it from 180° a second time all give the wrong angle.
- (b) 21 cm — By Pythagoras' theorem, the other side = √(29² − 20²) = √(841 − 400) = √441 = 21 cm. "9 cm" comes from subtracting the two given lengths directly, 29 − 20 = 9, instead of subtracting their squares. "441 cm" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "35 cm" comes from adding the squares of the two given lengths instead of subtracting them, √(29² + 20²) = √1241 ≈ 35, treating both given lengths as if they were the two shorter sides rather than a shorter side and the hypotenuse.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (a) opposite angles of a parallelogram are equal — P and R are opposite vertices of the parallelogram, and opposite angles of a parallelogram are always equal, which is why angle R equals angle P, 65°. Co-interior angles adding up to 180° is the correct fact for angle Q or angle S, the angles adjacent to P along a side, not for the opposite angle R. Alternate angles are equal is a fact about a transversal crossing two parallel lines, which explains other angle relationships in the parallelogram, not the one between opposite angles P and R directly. Angles on a straight line adding up to 180° applies to two angles that sit together on one straight line, which P and R do not.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
Build your own mix at the worksheet builder.