Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 30 cm — The perpendicular from the centre of a circle to a chord bisects the chord, so this line, half the chord and the radius form a right-angled triangle. Using Pythagoras' theorem, half the chord = √(17² − 8²) = √(289 − 64) = √225 = 15 cm. The full chord AB is twice this length: AB = 2 × 15 = 30 cm. Stopping after finding the half-chord, without doubling it for the whole chord, gives 15 cm. Adding the radius and the perpendicular distance directly, 17 + 8 = 25 cm, ignores that these two lengths are the two shorter sides of a right-angled triangle, not parts of a straight line. Subtracting instead, 17 − 8 = 9 cm, makes the same mistake in the other direction.
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (a) A smaller circle — Since the cutting plane is parallel to the circular base, the cross-section is also a circle, but smaller than the base because the cone narrows as it rises towards the apex, so 'a smaller circle' is correct. 'A triangle' wrongly describes the outline seen from the side of the cone, not a horizontal cross-section. 'An ellipse' would only result from a cut made at an angle to the base, not one parallel to it. 'The same size circle as the base' wrongly ignores that the cone tapers, so any parallel cross-section above the base must be smaller.
- (c) 24 — PQ lies along the x-axis with length 6, and PR lies along the y-axis with length 8, meeting at a right angle at P, so QR = √(6² + 8²) = √100 = 10. The perimeter is 6 + 8 + 10 = 24. "14" adds only the two shorter sides, PQ and PR, and leaves out the hypotenuse QR completely. "28" comes from finding QR incorrectly as 6 + 8 = 14 instead of using Pythagoras' theorem, then adding 6 + 8 + 14. "48" comes from multiplying the two shorter sides, 6 × 8, instead of finding and adding all three sides of the triangle.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (a) 90° — Method: the angle in a semicircle theorem states that the angle subtended at the circumference by a diameter is always a right angle, whatever the circle's size. Working: since AC is a diameter, the angle ABC subtended at the circumference by AC is 90 degrees, regardless of the circle's radius. Answer: 90°. This result holds for every position of B on the circle and for every size of circle, so no length or radius is ever needed: do not confuse angle ABC with the straight angle along the diameter itself, which is 180°, and do not halve the right angle again.
- (d) Triangle 2, by 3.6 cm² — Method: find both areas with 1/2ab sin C, then compare them. Working: area of triangle 1 = 1/2 × 10 × 13 × sin 64° = 58.4 cm²; area of triangle 2 = 1/2 × 11 × 12 × sin 70° = 62.0 cm²; triangle 2 is larger, by 62.0 − 58.4 = 3.6 cm². Getting the right difference but naming triangle 1 as the larger one, the subtraction done the wrong way round, gives 'Triangle 1, by 3.6 cm²'; leaving out the 1/2 when finding triangle 1's area (giving 116.8 cm² instead of 58.4 cm²) and then subtracting gives 'Triangle 1, by 54.8 cm²'; and using cos 64° instead of sin 64° for triangle 1 (giving 28.5 cm² instead of 58.4 cm²) gives 'Triangle 2, by 33.5 cm²'. Work out both areas fully and correctly before comparing which is bigger.
- (c) 56.52 cm² — Sector area = (45 ÷ 360) × 3.14 × 12² = 0.125 × 3.14 × 144 = 56.52 cm². (4.71 cm² comes from forgetting to square the radius; 452.16 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 9.42 cm² comes from using the arc length formula instead of the sector area formula.)
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (a) 53.5° — Method: use the sine rule BC/sin A = AC/sin B, since BC is opposite angle A and AC is opposite angle B. Working: sin(ABC) = AC × sin(BAC) / BC = 10 × sin 40° / 8, which gives angle ABC = 53.5° or its supplement 180 − 53.5 = 126.5°; since angle ABC is acute, the answer is 53.5°. Taking the obtuse supplement instead gives 126.5°; putting the sides the wrong way round in the ratio (sin B = BC × sin A / AC instead of AC × sin A / BC) gives 30.9°; and using sin 50° in place of sin 40° gives 73.2°. Every sine-rule ratio has two possible angle solutions that add to 180° — the word 'acute' tells you which one to keep.
- (a) No — it's a 180° rotation, not a reflection. — A negative scale factor scales the shape by the size of the factor and turns it through 180° about the centre of enlargement — every point of the image lands on the opposite side of the centre from the object. A 180° turn is a rotation, and a rotation never reverses a shape's handedness (its sense), whereas a reflection always does, so the image is not a mirror image: Priti is wrong. The option claiming negative numbers always mean a reflection confuses the sign of a scale factor with the transformation of reflection — they are not the same thing. The option saying only the size changes ignores the sign altogether: the 180° turn does change the way the shape faces, even though it leaves the handedness unchanged. The option equating 'upside down' with 'mirrored' assumes the two always mean the same thing, but a 180° rotation and a reflection in a horizontal line can both look 'upside down' while being different transformations — only the reflection reverses the shape's handedness.
Build your own mix at the worksheet builder.