Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (c) RHS — Both triangles are right-angled, and have equal hypotenuses (13 cm) and one equal corresponding side (5 cm), so they are congruent by the RHS (right angle, hypotenuse, side) condition — the three facts given are exactly a right angle, a hypotenuse and one other side. The distractor SAS would apply if two sides and the angle between those two sides were matched, but the right angle here lies between the 5 cm side and the third side, not between the 5 cm side and the hypotenuse. The distractor SSS needs all three pairs of sides matched, and only two sides of each triangle are given — the third side would first have to be calculated by Pythagoras, so SSS is not the condition the given facts supply. The distractor AAS would need two angles and a non-included side matched, but only one angle in each triangle is given.
- (a) 100° — In a kite, the pair of angles between the unequal sides are equal to each other. Angle X and angle Z are both between one side from the WX/WZ pair and one side from the XY/ZY pair, so angle Z = angle X = 100°.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (b) 8.4 cm — Two sides and the angle between them are known, so use the cosine rule: BC² = AB² + AC² − 2 × AB × AC × cos(BAC). Substituting, BC² = 81 + 36 − 45.64 = 71.36. Taking the square root: BC = √71.36 = 8.4 cm (1 d.p.). Leaving out the factor of 2 in the formula gives BC² = 81 + 36 − 22.82 = 94.18, so BC = 9.7 cm. Adding the cosine term instead of subtracting it gives BC² = 81 + 36 + 45.64 = 162.64, so BC = 12.8 cm. Using sin65° in place of cos65° gives BC² = 81 + 36 − 97.88 = 19.12, so BC = 4.4 cm. Keep the factor of 2, subtract the cosine term, and the correct length is 8.4 cm.
- (b) 16.747 m³ — Volume of a sphere = (4/3)πr³, so a hemisphere is half that: (2/3)πr³. Substitute r = 2: (2/3) × 3.14 × 2³ = (2/3) × 3.14 × 8 = (2/3) × 25.12 = 16.7467 m³, which rounds to 16.747 m³.
- (a) 9 — AB is a vertical segment, since A and B share the x-coordinate 1, and its length is the difference in y-coordinates: 5 − 1 = 4. BC is a horizontal segment, since B and C share the y-coordinate 5, and its length is the difference in x-coordinates: 6 − 1 = 5. The total path length is 4 + 5 = 9. 20 comes from multiplying the two lengths, 4 × 5, instead of adding them. 5 is only the length of BC, forgetting to include AB. 4 is only the length of AB, forgetting to include BC.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (d) (1/2)a + (1/2)c — Method: X is the midpoint of AC, so OX = OA + (1/2)AC, with AC = c − a. Working: OX = a + 1/2(c − a) = a − (1/2)a + (1/2)c = (1/2)a + (1/2)c. Answer: OX = (1/2)a + (1/2)c. Since OB = a + c, this is exactly half of OB, so OX = (1/2)OB, meaning X lies on OB at its midpoint too — the two diagonals bisect each other. Forgetting to halve AC at all gives a + c, which is OB itself, not its midpoint; halving only the c-term gives (1/2)a + c; and a sign error on the c-term gives (1/2)a − (1/2)c. Halve the whole of AC, both terms together, and add it to OA rather than to a alone.
- (d) 15 cm² — Method: identify the length that is common to both views, since it is the box's length; then read off the width from the plan view and the height from the front elevation, and multiply those two measurements to find the area of the side elevation. Working: both rectangles share a side of 8 cm, which is the box's length; the plan view's other side gives a width of 5 cm, and the front elevation's other side gives a height of 3 cm. The side elevation is bounded by the width and the height: 5 cm × 3 cm = 15 cm². Answer: 15 cm². The distractors: 24 cm² comes from giving the area of the front elevation shown (8 cm × 3 cm) instead of working out a new rectangle for the side elevation. 40 cm² comes from giving the area of the plan view shown (8 cm × 5 cm) instead of working out the side elevation. 120 cm² comes from multiplying all three measurements together (8 cm × 5 cm × 3 cm), finding the volume of the box instead of the area of one face.
- (a) 310° — Method: give the two rotations opposite signs since they turn in opposite senses — clockwise positive, anticlockwise negative — combine them into a single signed turn, then convert that turn into an angle measured clockwise between 0° and 360°. Working: the first rotation is 200° clockwise, so +200. The second is 250° anticlockwise, so −250. Combined: 200 − 250 = −50, meaning the net effect is a 50° turn anticlockwise. Measured clockwise instead, that same turn is 360 − 50 = 310°. Answer: 310°. Give the two rotations opposite signs before combining them, and convert a negative (anticlockwise) result into a clockwise angle by subtracting it from 360°, not from 180°: taking 50° away from a half turn gives 130°, which is a different rotation altogether; adding the two sizes as if both were clockwise gives 450°, which reduces to 90°; and reporting the anticlockwise size without converting it gives 50°.
- (a) 69.3 m — Method: each observer gives a right-angled triangle with the mast as the opposite side, so tan θ = 60 ÷ distance and the distance from the foot of the mast is 60 ÷ tan θ; because both stand on the same side, the gap between them is the difference of those two distances. Working: from Amelia, 60 ÷ tan 30° = 103.92… m; from Noah, 60 ÷ tan 60° = 34.64… m; the gap is 103.92… − 34.64… = 69.28… m, which is 69.3 m to 1 decimal place. Answer: 69.3 m. The distractors: 103.9 m is Amelia's own distance from the foot of the mast, written down before the second distance has been taken away; 34.6 m is Noah's distance from the foot of the mast; 138.6 m comes from adding the two distances, which would be right only if the two observers stood on opposite sides of the mast.
Build your own mix at the worksheet builder.