Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (a) 5 — Method: BC faces the 60° angle, so put the two algebraic sides into the cosine rule and solve the equation that results. By hand, cos 60° = 0.5. Working: 7² = x² + (x + 3)² − 2 × x × (x + 3) × 0.5, so 49 = x² + x² + 6x + 9 − x² − 3x = x² + 3x + 9. That rearranges to x² + 3x − 40 = 0, which factorises as (x + 8)(x − 5) = 0, giving x = −8 or x = 5. A length cannot be negative, so the negative root is rejected. Answer: x = 5. The distractors: 8 comes from expanding (x + 3)² as x² + 9, the error of assuming that squaring a bracket squares each term, which turns the equation into x² − 3x − 40 = 0; −8 is the negative root, kept by a candidate who solves the quadratic but never checks that x has to be a length; 37 comes from applying the cosine rule as though the 60° angle were at C facing AB, which gives x² = (x + 3)² + 49 − 7(x + 3) and a single linear solution.
- (b) £2.94 — Method: the price is quoted for each kilogram, so the mass has to be written in kilograms before it is multiplied by the price. Working: 1 kg = 1000 g, so 350 ÷ 1000 = 0.35 and the piece weighs 0.35 kg. The cost is then 8.40 × 0.35 = 2.94. Answer: £2.94. Treating 350 g as 3.5 kg, a division by 100 rather than by 1000, gives 8.40 × 3.5 = 29.40. Multiplying the price by the number of grams gives 8.40 × 350 = 2940. Dividing the price by the mass instead of multiplying gives 8.40 ÷ 0.35 = 24.
- (b) 62° — Because AT is a diameter, the radius OT lies along AT, and the tangent PT meets every radius at 90°, by the tangent–radius theorem. So PT meets AT at T at a right angle: angle ATP = 90°. The angles of triangle APT sum to 180°, so angle APT = 180° − 90° − 28° = 62°. Copying the given angle PAT straight across, as though the triangle were isosceles, gives 28°. Adding the two known angles instead of subtracting them from 180° gives 90° + 28° = 118°. Naming the right angle itself, angle ATP, instead of the angle that was actually asked for gives 90°. Subtract both known angles from 180°, and 62° is angle APT.
- (b) (5, 1) — First scale a by 2: 2a = (2×3, 2×(−2)) = (6, −4). Then add b component by component: (6+(−1), −4+5) = (5, 1). (2, 3) is a + b without doubling a first. (4, 6) doubles both a and b instead of only a. (7, −9) subtracts b from 2a instead of adding it.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (c) A↔N, B↔L, C↔M (ABC≅NLM) — Matching equal side lengths: AB (8 cm) equals NL (8 cm), BC (10 cm) equals LM (10 cm), and CA (6 cm) equals MN (6 cm). This gives the correspondence A with N, B with L, and C with M, so triangle ABC is congruent to triangle NLM, making 'A↔N, B↔L, C↔M (ABC≅NLM)' correct. 'A↔L, B↔M, C↔N (ABC≅LMN)' simply matches the vertices in the order they are written without checking the side lengths: AB (8 cm) would need to equal LM (10 cm), which is false. 'A↔M, B↔N, C↔L (ABC≅MNL)' also fails this check, since AB (8 cm) would need to equal MN (6 cm), which is false. 'A↔N, B↔M, C↔L (ABC≅NML)' gets A correct but swaps B and C, so AB (8 cm) would need to equal NM (6 cm), which is also false.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 5 — Method: the two points have the same y-coordinate, so the segment joining them runs horizontally and its length is the gap between the two x-coordinates; a length is a distance, so it is never negative. Working: the x-coordinates are 2 and −3, so the gap is 2 − (−3) = 2 + 3 = 5. Both points have y = −4, so there is no vertical part to add on. Answer: 5. The distractors: 1 comes from dropping the minus sign on −3 and working out 3 − 2 instead; 0 comes from subtracting the y-coordinates, which are equal, in place of the x-coordinates; 6 comes from counting the grid lines from −3 across to 2 inclusive, which counts one more than the number of gaps between them.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (c) Tangent-chord angle = angle in the alternate segment. — This diagram has a diameter AC, a centre O, and a cyclic quadrilateral ABCD, but no tangent anywhere in it. 'Angle in a semicircle = 90°' applies directly, because AC is a diameter. 'Opposite angles of a cyclic quadrilateral sum to 180°' applies directly, because ABCD is a cyclic quadrilateral. 'Angle at the centre = twice angle at circumference' applies directly, because O is given as the centre of the circle. The tangent-chord fact relates the angle between a tangent and a chord to an angle elsewhere in the circle, and since this diagram has no tangent, there is nothing in it for that fact to describe — so it is the one theorem that does not apply here.
- (a) 3 — Method: find the sail's area with Area = (1/2)ab sin C, then divide by how much one litre covers, and round up to a whole number of tins since paint can only be bought by the tin. Working: Area = 1/2 × 4.2 × 3.6 × sin 115° = 6.85 m² (2 d.p.); 6.85 ÷ 3 = 2.28 tins, which rounds up to 3 tins. Answer: 3. Rounding 2.28 to the nearest whole number instead of rounding up gives 2, which is not enough paint to finish the sail; forgetting the 1/2 in the area formula gives an area of 13.7 m², needing 5 tins; and assuming one litre covers exactly 1 m² of sail, ignoring the coverage rate given, rounds the area itself up to 7 tins. Whenever a quantity can only be bought in whole units, round up even when the decimal part is small — 2.28 tins means you need a third tin.
- (c) $\binom{2}{7}$ — First find the character's position after the first move: (−5 + 6, 2 + (−9)) = (1, −7). The second move takes it from (1, −7) to (3, 0), so subtract the current position from the target: (3 − 1, 0 − (−7)) = $\binom{2}{7}$. $\binom{8}{−2}$ works from the starting point (−5, 2) and ignores the first move — (3 − (−5), 0 − 2) = $\binom{8}{−2}$. $\binom{−2}{−7}$ subtracts the wrong way round, current position minus target, instead of target minus current position — (1 − 3, −7 − 0) = $\binom{−2}{−7}$. $\binom{4}{−7}$ adds the target's coordinates to the current position instead of subtracting — (1 + 3, −7 + 0) = $\binom{4}{−7}$.
- (d) 30.2 cm² — Method: with two sides and the angle between them, use Area = (1/2)ab sin C. Working: Area = 1/2 × 9.4 × 7.2 × sin 63° = 30.2 cm² (1 d.p.). Answer: 30.2 cm². Leaving out the 1/2 altogether gives 60.3 cm²; using cos 63° instead of sin 63° gives 15.4 cm²; and squaring one side instead of multiplying the two different given sides together gives 39.4 cm². Always check you are using sin, not cos, and that the 1/2 is there before you multiply the two given sides together.
Build your own mix at the worksheet builder.