Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (b) (3, 10) — Method: multiply every part of p by 2, then add the matching parts of q. Working: 2p = (4, 6); adding q gives top 4 + (−1) = 3 and bottom 6 + 4 = 10. Answer: 2p + q = (3, 10). A candidate who forgets to double p first, working out p + q instead, gets (1, 7). A candidate who doubles q instead of p, working out p + 2q, gets (0, 11). A candidate who subtracts q instead of adding it, working out 2p − q, gets (5, 2).
- (b) £157 — Method: round the hours worked up to the next whole hour, multiply by the hourly rate, then add the call-out fee. Working: 3 hours 30 minutes rounds up to 4 hours; 28 × 4 = 112; 112 + 45 = 157. Answer: £157. A candidate who uses the unrounded time of 3.5 hours, working out 28 × 3.5 = 98 and adding 45, gets £143. A candidate who forgets the call-out fee, giving only 28 × 4, gets £112. A candidate who rounds down to 3 hours instead of up, working out 28 × 3 = 84 and adding 45, gets £129.
- (a) 4700 cm² — Method: split the T-shaped outline into the two rectangles it is made from, find the area of each, then add them together. Working: the wide base gives a rectangle 90 cm × 30 cm = 2700 cm²; the narrower block on top gives a rectangle 40 cm × 50 cm = 2000 cm²; adding these, 2700 + 2000 = 4700 cm². Answer: 4700 cm². The distractors: 2700 cm² comes from finding only the area of the base rectangle and forgetting to add the block on top. 2000 cm² comes from finding only the area of the top block and forgetting the base. 7200 cm² comes from treating the whole outline as one large rectangle, 90 cm wide by (30 + 50) = 80 cm tall, instead of splitting it into the two separate rectangles that actually make up the shape.
- (d) 21 cm — The scale factor from triangle ABC to triangle PQR is PQ ÷ AB = 15 ÷ 5 = 3. QR = BC × scale factor = 7 × 3 = 21 cm. A student who divides BC by the scale factor instead of multiplying gets 7 ÷ 3 = 2.33 cm. A student who multiplies BC by AB instead of by the scale factor gets 7 × 5 = 35 cm.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (c) (6, −5) — Method: the translation has already happened, so it must be undone: reverse the vector and apply the reverse to the point that is given. Working: reversing $\binom{-2}{6}$ gives $\binom{2}{-6}$, so the x-coordinate is 4 + 2 = 6 and the y-coordinate is 1 − 6 = −5. Check: from (6, −5) the given vector gives 6 − 2 = 4 and −5 + 6 = 1, which is the point named in the question. Answer: (6, −5). Applying the vector forwards instead of backwards gives (2, 7). Reversing the horizontal movement but not the vertical one gives (6, 7), and reversing the vertical movement but not the horizontal one gives (2, −5).
- (d) (3/4)a + (1/4)c — Method: OX = OA + AX, and since AX is a third of XC, AX is 1/4 of the whole of AC, with AC = c − a. Working: OX = a + 1/4(c − a) = a − (1/4)a + (1/4)c = (3/4)a + (1/4)c. Answer: OX = (3/4)a + (1/4)c. Measuring 1/4 of AC from C's end instead of A's swaps the fractions round, giving (1/4)a + (3/4)c; adding (1/4)c onto the whole of a without subtracting a inside the bracket first gives a + (1/4)c; and treating the ratio as though AX and XC were equal gives the midpoint, (1/2)a + (1/2)c. Convert the ratio to a fraction of AC measured from A, subtract before you scale, and then add the result to OA.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (b) £5.00 — Perimeter of the kite = 25 + 25 + 40 + 40 = 130 cm = 1.3 m. The frame is sold only in whole metres, so 2 m must be bought. Cost = 2 × £2.50 = £5.00. A student who buys the exact 1.3 m instead of rounding up to whole metres gets 1.3 × £2.50 = £3.25. A student who never converts the perimeter from centimetres to metres and costs 130 × £2.50 gets £325.00.9 m, which rounds up to 3 whole metres, costing 3 × £2.50 = £7.50.
Build your own mix at the worksheet builder.