Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) (6, −5) — Method: the translation has already happened, so it must be undone: reverse the vector and apply the reverse to the point that is given. Working: reversing $\binom{-2}{6}$ gives $\binom{2}{-6}$, so the x-coordinate is 4 + 2 = 6 and the y-coordinate is 1 − 6 = −5. Check: from (6, −5) the given vector gives 6 − 2 = 4 and −5 + 6 = 1, which is the point named in the question. Answer: (6, −5). Applying the vector forwards instead of backwards gives (2, 7). Reversing the horizontal movement but not the vertical one gives (6, 7), and reversing the vertical movement but not the horizontal one gives (2, −5).
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
- (c) One third of the cylinder's volume — Volume of a cylinder = base area × height. Volume of a cone = 1/3 × base area × height. For the same base radius and height, the cone's volume is exactly one third of the cylinder's, so it uses less wax. A student who thinks the cone is half the cylinder's volume has confused it with a different solid's ratio. A student who thinks the two volumes are the same has ignored the 1/3 factor in the cone formula entirely. A student who thinks the cone is two thirds of the cylinder's volume has the right idea that it is a fraction, but the wrong fraction.
- (c) 2π cm — Method: the circumference of a circle is 2πr, where r is the radius, or equivalently πd, where d is the diameter. Working: r = 1, so the circumference is 2 × π × 1 = 2π cm. Answer: 2π cm. The distractors: π cm comes from using the formula πd but substituting the radius in place of the diameter; 4π cm comes from doubling twice — changing the radius into the diameter of 2 cm and then putting that diameter into 2πr as though it were a radius; π cm² is the area of this circle, π × 1², and comes from reaching for the area formula when a distance round the outside was asked for, which is why it carries a squared unit.
- (c) 1.5 — The area scale factor is the length scale factor squared, so if n is the length factor, n² = 2.25. Taking the positive square root gives n = 1.5 (check: 1.5² = 2.25). 2.25 is just the area factor restated, with no root taken. 1.125 comes from halving 2.25 instead of taking its square root. 5.0625 comes from squaring 2.25 instead of rooting it.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (b) It is the longest of the three chords — Method: in any circle the length of a chord is decided by how far the chord lies from the centre, because a chord passing nearer the centre cuts further across the circle. Working: the chord through O lies at a distance of zero from the centre, and no chord can lie closer than that, so no chord of the circle can be longer than it; a chord through the centre is a diameter. The other two chords lie at some distance greater than zero, so each of them falls short of that maximum. Answer: It is the longest of the three chords. The distractors: It is the shortest of the three chords comes from reversing the rule and picturing a chord near the centre as a short line tucked inside; It is the same length as the other two chords comes from carrying the fact that all radii of a circle are equal across to chords, which are not all equal; It is half the length of each of the other two chords comes from confusing a chord through the centre with a radius, which really is half a diameter.
- (a) 1023 m² — Method: split the quadrilateral along the diagonal AC into two triangles. Triangle ABC has two sides and the angle between them, so the cosine rule gives AC and the area formula gives its area; triangle ACD then has three known sides, so the cosine rule gives an angle and the area formula gives its area. Working: AC² = 40² + 32² − 2 × 40 × 32 × cos 95° = 1600 + 1024 + 223.12 = 2847.12, so AC = 53.358 m. The area of triangle ABC is 1/2 × 40 × 32 × sin 95° = 640 × 0.99619 = 637.56 m². In triangle ACD, cos ADC = (25² + 36² − 2847.12) ÷ (2 × 25 × 36) = (1921 − 2847.12) ÷ 1800 = −0.51451, so angle ADC = 120.965° and sin ADC = 0.85748, giving an area of 1/2 × 25 × 36 × 0.85748 = 385.87 m². The total is 637.56 + 385.87 = 1023.43. Answer: the field has an area of 1023 m² to the nearest square metre. The distractors: 1071 m² comes from taking cos 95° as positive, so the diagonal is found as 49.00 m instead of 53.358 m and the second triangle comes out too large; 2047 m² comes from leaving the factor 1/2 out of both area calculations; 638 m² is the area of triangle ABC alone, written down by a candidate who finds the diagonal and then forgets that the second triangle is part of the field.
- (d) £100.48 — Area of the rug = (angle ÷ 360) × π × r² = (180 ÷ 360) × 3.14 × 16 = 0.5 × 50.24 = 25.12 m². Cost = 25.12 × £4 = £100.48. (£200.96 comes from finding the area of a full circle, 3.14 × 16 = 50.24 m², and forgetting the angle fraction before costing it; £25.12 comes from forgetting to square the radius, using 0.5 × 3.14 × 4 = 6.28 m², and then costing that; £50.24 comes from using the arc length formula, 0.5 × 2 × 3.14 × 4 = 12.56, in place of the area, and costing that.)
- (c) 9.9 cm — Method: the 7 cm side is opposite the 45° angle and the hypotenuse is wanted, so use sin θ = opposite ÷ hypotenuse and rearrange it for the hypotenuse. Working: sin 45° = 7 ÷ h, so h = 7 ÷ sin 45° = 9.899…, which is 9.9 to 1 decimal place. Answer: 9.9 cm. The distractors: 5.0 cm comes from multiplying by sin 45° instead of dividing by it; 14.0 cm comes from doubling the 7 cm side, which is the rule for a side opposite 30° and not one opposite 45°; 7.0 cm comes from reading the two equal sides of a 45° right-angled triangle as including the hypotenuse, when the equal pair is the two shorter sides.
- (d) 4.44 m — The real van's length is 18.5 × 24 = 444 cm, which converts to 4.44 m. '0.77 m' comes from dividing by 24 instead of multiplying, using the ratio the wrong way round (18.5 ÷ 24 = 0.77 cm), and then writing that figure down as metres. '44.4 m' comes from converting 444 cm to metres with the decimal point in the wrong place. '444 m' comes from working out 444 cm correctly but forgetting to convert it into metres at all.
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
Build your own mix at the worksheet builder.