Printable · GCSE Higher · ages 14-16
Geometry and measures worksheet — GCSE Higher
Fifteen questions across the geometry and measures statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Geometry and measures worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (a) 3 cm² — Area scale factor = (linear scale factor)² = (1/4)² = 1/16. Area of T = 48 × 1/16 = 3 cm². (12 cm² comes from multiplying by the linear scale factor 1/4 directly, without squaring it; 24 cm² comes from taking the square root of the scale factor instead of squaring it; 768 cm² comes from squaring the reciprocal of the scale factor, 4, instead of the scale factor itself.)
- (b) 360 cm² — Method: the total surface area is the square base plus the four triangular faces, and the height used for a triangular face is the slant height of 13 cm, not the vertical height of 12 cm. Working: the base is 10 × 10 = 100 cm²; one triangular face is (10 × 13) ÷ 2 = 65 cm², so four faces give 4 × 65 = 260 cm²; the total is 100 + 260 = 360. Answer: 360 cm². The distractors: 260 cm² comes from adding the four triangular faces and leaving out the base; 340 cm² comes from using the vertical height of 12 cm as the height of each triangle, 100 + 4 × 60; 620 cm² comes from working out each face as 10 × 13 without halving, 100 + 4 × 130.
- (c) 45° — Method: the tower, the ground and the line of sight form a right-angled triangle in which the 25 m height is opposite the angle of elevation and the 25 m along the ground is adjacent to it, so use tan θ = opposite ÷ adjacent. Working: tan θ = 25 ÷ 25 = 1, so θ = tan⁻¹(1). Answer: 45°. The distractors: 90° comes from using sin θ = 25 ÷ 25 = 1, which treats the 25 m along the ground as the hypotenuse when it is the side next to the angle; 1° comes from writing down the value of tan θ as though it were the angle itself; 50° comes from adding the two given lengths, 25 + 25, instead of comparing them.
- (d) 118.0 cm² — Method: a rhombus is made of two congruent triangles either side of a diagonal, each with area 1/2 × 12 × 12 × sin 55°, so the whole rhombus has area 12 × 12 × sin 55° (side² × sin of the interior angle). Working: area = 12² × sin 55° = 118.0 cm². Stopping at one triangle's area, 1/2 × 12² × sin 55°, and forgetting to double it gives 59.0 cm²; using cos 55° instead of sin 55° gives 82.6 cm²; and multiplying the two sides together with no trig term at all gives 144.0 cm². Splitting the rhombus into its two triangles is the safest way to see why the 1/2 disappears from the whole-shape formula.
- (d) 8.75 cm — The scale factor of the enlargement is 11.2 ÷ 3.2 = 3.5. Applying this to the second line, 2.5 × 3.5 = 8.75 cm. The distractor 10.50 cm comes from adding the difference between the first line's two lengths (11.2 − 3.2 = 8) to the second line's original length, 2.5 + 8 = 10.5. The distractor 0.71 cm comes from using the scale factor the wrong way round, 2.5 × (3.2 ÷ 11.2) = 0.71 (to 2 d.p.). The distractor 8.70 cm comes from directly subtracting 11.2 − 2.5 = 8.7, muddling the two different lines instead of scaling the second one.
- (a) a rounded rectangle: 5 m by 4 m with semicircular ends — Points within 2 m of the straight part of the fence form a rectangle running the 5 m length of the fence and 4 m wide (2 m on each side); points within 2 m of each END of the fence, beyond that rectangle, form a semicircle of radius 2 m there, since the nearest point of the fence to them is just that one end. Together this gives a rounded, stadium-shaped region. "a rectangle, 9 m by 4 m" extends the rectangle by 2 m at each end instead of rounding it, wrongly including corner points that are actually more than 2 m from every part of the fence. "a circle of radius 2 m" treats the whole 5 m fence as a single point. "a rectangle, 5 m by 2 m" uses 2 m as the full width instead of the distance on EACH side, so it only covers one side of the fence.
- (c) 15 cm — Method: going from the smaller tile to the larger one, every length is multiplied by the scale factor 5 ÷ 3. Working: 9 ÷ 3 = 3, and 3 × 5 = 15. Answer: 15 cm. The distractors: 11 cm comes from adding the difference between the parts of the ratio, 5 − 3 = 2, to the 9 cm side, treating a ratio as a gap rather than a multiplier; 45 cm comes from multiplying by 5 and forgetting to divide by 3; 27 cm comes from multiplying by 3, which is the part of the ratio belonging to the smaller tile.
- (c) 36.7 m — Method: use the cosine rule to find the missing side BC, then add all three sides for the perimeter. Working: BC² = 13² + 10² − 2 × 13 × 10 × cos 72°, so BC = 13.7 m, and perimeter = 13 + 10 + 13.7 = 36.7 m. Forgetting the negative sign in the cosine rule (using + instead of −) gives BC = 18.7 m and a perimeter of 41.7 m; leaving AC out of the total and only adding AB and BC gives 26.7 m; and adding AB twice instead of AB and AC gives 39.7 m. Always add all three named sides once the missing one has been found.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
- (a) Isosceles trapezium: base angles are equal — WX is parallel to ZY and the two non-parallel sides WZ and XY are equal in length, so WXYZ is an isosceles trapezium. In an isosceles trapezium the two angles at each of the parallel sides are equal, so angle W = angle X (and angle Z = angle Y). A student who answers with the parallelogram property has quoted a fact that is true of a parallelogram, but WZ and XY are given as non-parallel so WXYZ is not a parallelogram — and in a parallelogram "opposite angles" pairs W with Y, not W with X. A student who answers with the kite property has again taken a true fact about the wrong shape: a kite's equal sides are two pairs of adjacent sides, not the two non-parallel sides of a trapezium. A student who answers with the rhombus property has used something no rhombus has — a rhombus has two pairs of parallel sides and only two pairs of equal angles; all four angles are equal only in a square.
- (c) (4, 3) — Method: the midpoint of a segment is the mean of its two end points, so its x-coordinate is the mean of the two x-coordinates and its y-coordinate is the mean of the two y-coordinates. Working: for x, (1 + 7) ÷ 2 = 8 ÷ 2 = 4. For y, (3 + 3) ÷ 2 = 6 ÷ 2 = 3. The midpoint is therefore (4, 3). Answer: (4, 3). The distractors: (3, 3) comes from halving the difference of the x-coordinates, (7 − 1) ÷ 2 = 3, which measures half the distance instead of locating the point; (3.5, 3) comes from halving only the larger x-coordinate and leaving the smaller one out of the working; (4, 0) comes from averaging the x-coordinates correctly but then subtracting the y-coordinates, 3 − 3, rather than averaging them.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
Build your own mix at the worksheet builder.